Narodna in univerzitetna knjižnica, Ljubljana (NUK)
Novo: ob sobotah ni dostave gradiva, več o naročanju in izposoji gradiva.
Naročanje kopij člankov.
PDF
  • Monitoring of injection moulding of thermoplastics : adopting pressure transducers to estimate the solidification history and the shrinkage of moulded parts
    Speranza, Vito ; Vietri, Umberto ; Pantani, Roberto
    In this work, a series of injection moulding tests were conducted using a general purpose PolyStyrene, PS, and changing the holding pressure,injection temperature and cavity dimensions. The pressures ... at the interface with the mould at several positions along the flow-path weremeasured by means of pressure-temperature transducers. The samples were measured after moulding to determine dimensional accuracy,which was taken to be the target quality parameter. The pressure profiles obtained were then analysed using a recently developed procedurethat is able to estimate the local solidification history from pressure measurements. The local average solidification pressure, namely theaverage along the thickness direction of the pressures at which each layer solidifies, could thus be estimated. This parameter is known tocorrelate well with shrinkage and thus a master-curve can be created that can be adopted to monitor the quality of the moulded part on line.
    Vir: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 59, no. 11, Nov. 2013, str. 677-682, SI 137)
    Vrsta gradiva - članek, sestavni del
    Leto - 2013
    Jezik - angleški
    COBISS.SI-ID - 13220379
    DOI

vir: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 59, no. 11, Nov. 2013, str. 677-682, SI 137)

loading ...
loading ...
loading ...

Vnos na polico