Three-layer polymeric diphenyl-methane-diisocyanate (pMDI)-bonded particleboards (PBs) were produced with different proportions of simulated recovered wood (rW) in the core layers (cLs) to assess the effect of rW on the formaldehyde (FA) release of PB. A pre-test was conducted on furniture and particle mixtures of rW to determine the range of expectable FA emission of rW. The FA content of the raw particle mixtures could be predicted from the contents of the individual raw material and did not change compared to the PB. FA content correlated strongly with PB-FA emission. It was possible to predict the maximum PB-FA contents, which should not be exceeded according to F*** and CARB 2 by linear regression models. At moderate and high total FA emission levels, the FA emission of the particle mixtures was approximately 60% higher than the emission of PB blocks. At low total FA level, the flask method and the gas analysis method exhibited different results with regard to the emissions from particles and their respective PBs.