DIKUL - logo
Faculty of Mechanical Engineering, Lj. (FSLJ)
  • Welding of tailored blanks of different materials
    Tušek, Janez, 1952- ; Kampuš, Zlatko ; Suban, Marjan
    This paper treats welding of tailored blanks made of different materials. In general, fusion welding and welding with pressure, practically without fusion, are described. Fusion welding may be ... carried out with or without the addition of filler material. In Section 3, general characteristics of tailored blanks are described. In Section 4, MIG welding and laser welding of austenitic stainless steel with ferrite non-stainless steel are described. After welding, hardness of the welded joints was measured. The welded joints were subjected to deep drawing. At the end, conclusions are stated. Investigations have shown that tailored blanks of high-alloy stainless steel cannot be laser or TIG welded to those of low-alloyed ferrite steel without the addition of filler material. A suitable process and filler material should be selected. The purpose of the filler material is to compensate for the differences in chemical and physical properties of both materials.
    Source: Journal of materials processing technology. - ISSN 0924-0136 (Vol. 119, no. 1/3, special issue "AMPT'99", part 2, 2001, str. 180-184)
    Type of material - article, component part
    Publish date - 2001
    Language - english
    COBISS.SI-ID - 4892187

    Link(s):

    http://www.elsevier.nl/cdweb/journals/09240136/viewer.htt?iss=1-3&vol=119

    PII: S0924-0136(01)00937-2

    Prosto dostopno samo kazalo vsebine


    http://www.sciencedirect.com/science/journal/09240136

    DOI: 10.1016/S0924-0136(01)00937-2

    Dostop do polnega teksta za člane



source: Journal of materials processing technology. - ISSN 0924-0136 (Vol. 119, no. 1/3, special issue "AMPT'99", part 2, 2001, str. 180-184)

loading ...
loading ...
loading ...

Shelf entry