Radiation resistant LGAD design Ferrero, M.; Arcidiacono, R.; Barozzi, M. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
03/2019, Volume:
919
Journal Article
Peer reviewed
Open access
In this paper, we report on the radiation resistance of 50-micron thick Low Gain Avalanche Diodes (LGAD) manufactured at the Fondazione Bruno Kessler (FBK) employing different dopings in the gain ...layer. LGADs with a gain layer made of Boron, Boron low-diffusion, Gallium, Carbonated Boron and Carbonated Gallium have been designed and successfully produced at FBK. These sensors have been exposed to neutron fluences up to ϕn∼3⋅1016n∕cm2 and to proton fluences up to ϕp∼9⋅1015p∕cm2 to test their radiation resistance. The experimental results show that Gallium-doped LGAD are more heavily affected by the initial acceptor removal mechanism than those doped with Boron, while the addition of Carbon reduces this effect both for Gallium and Boron doping. The Boron low-diffusion gain layer shows a higher radiation resistance than that of standard Boron implant, indicating a dependence of the initial acceptor removal mechanism upon the implant density.
In this paper we report on the timing resolution obtained in a beam test with pions of 180 GeV/c momentum at CERN for the first production of 45 μm thick Ultra-Fast Silicon Detectors (UFSD). UFSD are ...based on the Low- Gain Avalanche Detector (LGAD) design, employing n-on-p silicon sensors with internal charge multiplication due to the presence of a thin, low-resistivity diffusion layer below the junction. The UFSD used in this test had a pad area of 1.7 mm2. The gain was measured to vary between 5 and 70 depending on the sensor bias voltage. The experimental setup included three UFSD and a fast trigger consisting of a quartz bar readout by a SiPM. The timing resolution was determined by doing Gaussian fits to the time-of-flight of the particles between one or more UFSD and the trigger counter. For a single UFSD the resolution was measured to be 34 ps for a bias voltage of 200 V, and 27 ps for a bias voltage of 230 V. For the combination of 3 UFSD the timing resolution was 20 ps for a bias voltage of 200 V, and 16 ps for a bias voltage of 230 V.
First FBK production of 50 μm ultra-fast silicon detectors Sola, V.; Arcidiacono, R.; Boscardin, M. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
04/2019, Volume:
924
Journal Article
Peer reviewed
Fondazione Bruno Kessler (FBK, Trento, Italy) has recently delivered its first 50 μm thick production of Ultra-Fast Silicon Detectors (UFSD), based on the Low-Gain Avalanche Diode design. These ...sensors use high resistivity Si-on-Si substrates, and have a variety of gain layer doping profiles and designs based on Boron, Gallium, Carbonated Boron and Carbonated Gallium to obtain a controlled multiplication mechanism. Such variety of gain layers will allow identifying the most radiation hard technology to be employed in the production of UFSD, to extend their radiation resistance beyond the current limit of ϕ∼ 1015 neq/cm2. In this paper, we present the characterisation, the timing performance, and the results on radiation damage tolerance of this new FBK production.
In this paper we present the numerical simulation of silicon detectors with internal gain as the main tool for 4-dimensional (4D) particle trackers design and optimization. The Low-Gain Avalanche ...Diode (LGAD) technology and its present limitations are reviewed with the aim of introducing the Resistive AC-Coupled Silicon Detectors (RSD) paradigm as a case study of our investigation. Authors here present Spice-like and 2D/3D Technological Computer-Aided Design (TCAD) simulations to characterize sensors in terms of both their electrostatic behavior, capacitive (dynamic) coupling and radiation-hardness performances, showing the methodological approach used in order to extract the set of layout rules allowing the release of RSD1, the incoming production run at Fondazione Bruno Kessler (FBK) of next-generation silicon detectors for 4D tracking with intrinsic 100% fill-factor.
Experimental Study of Acceptor Removal in UFSD Jin, Y.; Ren, H.; Christie, S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2020, Volume:
983, Issue:
C
Journal Article
Peer reviewed
Open access
The performance of the Ultra-Fast Silicon Detectors (UFSD) after irradiation with neutrons and protons is compromised by the removal of acceptors in the thin layer below the junction responsible for ...the gain. This effect is tested both with capacitance–voltage, C–V, measurements of the doping concentration and with measurements of charge collection, CC, using charged particles. We find a perfect linear correlation between the bias voltage to deplete the gain layer determined with C–V and the bias voltage to collect a defined charge, measured with charge collection. An example for the usefulness of this correlation is presented.
PDF
