Calibration of the ANTARES high energy neutrino telescope Baret, B.
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
2011, Letnik:
626
Journal Article
Recenzirano
ANTARES
1 is a deep-sea, large volume Mediterranean neutrino telescope installed off the Coast of Toulon, France. It is taking data in its complete configuration since May 2008 with nearly 900 ...photomultipliers installed on 12 lines. It is today the largest high energy neutrino telescope of the northern hemisphere. The muons created by the interaction of neutrinos near or in the instrumented volume are detected through the Cherenkov light produced along their track. The arrival direction is reconstructed thanks to the precise determination of the time and position of the photons detected by the Optical Modules and their compatibility with a track. In order to do this and achieve the expected angular resolution of 0.3° at energies above 10
TeV, the detector needs to be precisely calibrated. We will describe here the different calibration procedures necessary to achieve the required precision.
KM3NeT is a network of deep-sea neutrino telescopes to be deployed in the Mediterranean Sea that will perform neutrino astronomy and oscillation studies. It consists of three-dimensional arrays of ...thousands of optical modules that detect the Cherenkov light induced by charged particles resulting from the interaction of a neutrino with the surrounding medium. The performance of the neutrino telescope relies on the precise timing and positioning calibration of the detector elements. Other environmental conditions which may affect light and sound transmission, such as water temperature and salinity, must also be continuously monitored. This contribution describes the technical design of the first Calibration Unit, to be deployed on the French site as part of KM3NeT Phase 1.
Context. Various signals of anisotropy of the ultra-high-energy cosmic rays (UHECRs) have recently been reported, whether at large angular scales, with a dipole modulation in right ascension observed ...in the data of the Pierre Auger observatory ( Auger ), as discussed in the first paper accompanying the present one, or at intermediate angular scales, with flux excesses identified in specific directions by Auger and the Telescope Array (TA) Collaborations. Aims. We investigated the implications of the current data regarding these intermediate scale anisotropies, and examined to what extent they can be used to shed light on the origin of UHECRs, and constrain the astrophysical and/or physical parameters of the viable source scenarios. We also investigated what could be learnt from the study of the evolution of the various UHECR anisotropy signals, and discussed the expected benefit of an increased exposure of the UHECR sky using future observatories. Methods. We simulated realistic UHECR sky maps for a wide range of astrophysical scenarios satisfying the current observational constraints, with the assumption that the UHECR source distribution follows that of the galaxies in the Universe, also implementing possible biases towards specific classes of sources. In each case, several scenarios were explored with different UHECR source compositions and spectra, a range of source densities and different models of the Galactic magnetic field. We also implemented the Auger sky coverage, and explored various levels of statistics. For each scenario, we produced 300 independent datasets on which we applied similar analyses as those recently used by the Auger Collaboration, searching for flux excesses through either blind or targeted searches and quantifying correlations with predefined source catalogues through a likelihood analysis. Results. We find the following. First, with reasonable choices of the parameters, the investigated astrophysical scenarios can easily account for the significance of the anisotropies reported by Auger , even with large source densities. Second, the direction in which the maximum flux excess is found in the Auger data differs from the region where it is found in most of our simulated datasets, although an angular distance as large as that between the Auger direction and the direction expected from the simulated models at infinite statistics, of the order of ∼20°, occurs in ∼25% of the cases. Third, for datasets simulated with the same underlying astrophysical scenario, and thus the same actual UHECR sources, the significance with which the isotropy hypothesis is rejected through the Auger likelihood analysis can be largest either when ‘all galaxies’ or when only ‘starburst’ galaxies are used to model the signal, depending on which model is used to model the Galactic magnetic field and the resulting deflections. Fourth, the study of the energy evolution of the anisotropy patterns can be very instructive and provide new astrophysical insight about the origin of the UHECRs. Fifth, the direction in which the most significant flux excess is found in the Auger dataset above 8 EeV appears to essentially disappear in the dataset above 32 EeV, and, conversely, the maximum excess at high energy has a much reduced significance in the lower energy dataset. Sixth, both of these appear to be very uncommon in the simulated datasets, which could point to a failure of some generic assumption in the investigated astrophysical scenarios, such as the dominance of one type of source with essentially the same composition and spectrum in the observed UHECR flux above the ankle. Seventh, given the currently observed level of anisotropy signals, a meaningful measurement of their energy evolution, say from 10 EeV to the highest energies, will require a significant increase in statistics and a new generation of UHECR observatories.
► Combination of carbon nanotubes and capped platinum electrocatalyst for ORR. ► Diffusion area for ORR is determined inporous electrode structures. ► Diffusion area is related to platinum loading. ► ...The lower the platinum coverage density the higher the diffusion area. ► Diffusion area relates toelectrocatalyst accessibility on its carbon support.
In this paper we report the determination of the diffusion area for oxygen reduction in porous electrode structure having a controlled platinum loading and based on capped platinum electrocatalysts and carbon nanotubes. Such a parameter is expected to be higher than the macroscopic geometrical area of the active porous layer. The oxygen diffusion area is determined by cyclic voltammetry after impregnation of the electrode structure by the electrolyte, and using the equations available for peak potential and peak current as a function of scan speed for irreversible redox couple. First it is found first that the oxygen diffusion area is dependent on the total amount of platinum in the electrode. Second, for a given platinum loading, the diffusion area is higher when the mass ratio of platinum to carbon nanotube decreases. This point indicates that the accessibility of platinum capped electrocatalyst is better in such cases. It is thus concluded that the oxygen diffusion area determination in porous electrode structures may be used to characterize the accessibility of the capped electrocatalysts for oxygen reduction. Even if this area is different in nature from the one calculated by Hydrogen Underpotential Deposition, we believe that its determination might be of interest for the characterization of porous electrodes structures in which the electrocatalyst is combined with a finely divided carbon support.
Recently we reported the preparation and electrochemical behaviour of porous electrodes based on the controlled combination of carbon nanotubes and capped platinum nanoparticles towards oxygen ...reduction. Due to the organic crown of the nanoparticles, the electrodes exhibited low hydrogen underpotential deposition (H upd) electroactive surface areas but significant activity towards oxygen reduction was recorded down to very low platinum loadings of few μg/cm
2. While the presence of organic stabilizing material, at the surface of the electrocatalyst synthesized by wet chemistry, may be considered as a potential drawback in fuel cell community, we present in this paper results showing that our capped electrocatalyst associated with carbon nanotubes can be used without any pre-treatment and exhibit high performances in fuel cell devices, in spite of low platinum loadings. Beyond the practical interest of such capped nanoparticles in fuel cell technology demonstrated here, fundamental question related to the high performances of the capped electrocatalyst are still opened and are currently under investigation.
Abstract
We report the discovery of four Fast Radio Bursts (FRBs) in the ongoing SUrvey for Pulsars and Extragalactic Radio Bursts at the Parkes Radio Telescope: FRBs 150610, 151206, 151230 and ...160102. Our real-time discoveries have enabled us to conduct extensive, rapid multimessenger follow-up at 12 major facilities sensitive to radio, optical, X-ray, gamma-ray photons and neutrinos on time-scales ranging from an hour to a few months post-burst. No counterparts to the FRBs were found and we provide upper limits on afterglow luminosities. None of the FRBs were seen to repeat. Formal fits to all FRBs show hints of scattering while their intrinsic widths are unresolved in time. FRB 151206 is at low Galactic latitude, FRB 151230 shows a sharp spectral cut-off, and FRB 160102 has the highest dispersion measure (DM = 2596.1 ± 0.3 pc cm−3) detected to date. Three of the FRBs have high dispersion measures (DM > 1500 pc cm−3), favouring a scenario where the DM is dominated by contributions from the intergalactic medium. The slope of the Parkes FRB source counts distribution with fluences >2 Jy ms is $\alpha =-2.2^{+0.6}_{-1.2}$ and still consistent with a Euclidean distribution (α = −3/2). We also find that the all-sky rate is $1.7^{+1.5}_{-0.9}\times 10^3$FRBs/(4π sr)/day above ${\sim }2{\rm \, }\rm {Jy}{\rm \, }\rm {ms}$ and there is currently no strong evidence for a latitude-dependent FRB sky rate.
A bottom-up approach is used here to combine carbon nanotubes synthesized by CVD and organically capped platinum nanoparticles electrocatalyst exhibiting a direct electrochemical activity towards ...oxygen reduction. Both nano-objects are handled in liquid suspension and are associated together in a controlled way. The nanocomposite liquid dispersions can be precisely controlled in terms of platinum nanoparticles to carbon nanotubes weight ratios (NP/NT) which correspond to different coverages of nanotubes by nanoparticles. Electrodes with low to ultra-low platinum loadings can then be prepared on porous fuel cell carbon supports by filtration. The direct electrochemical activity towards aqueous oxygen reduction reaction (ORR) of electrodes with platinum loadings ranging from about 1 to 60
μg/cm
2 is reported without any activation step in order to keep the features of the nanoparticles intact. Before that, we studied the responses obtained when impregnating our hydrophobic electrodes by a voltamperometric gas consumption procedure. These responses are also dependent of the composition of our electrodes. Whereas our results are of particular interest with respect to the optimization of platinum loading in fuel cell electrodes, the specific behaviour of these capped platinum nanoparticles towards proton adsorption–desorption reveals the difficulty to determine reliable active surface area with related regard to the platinum loading and point to the necessity to determine other characteristic parameters for the electrodes.
This study focuses on the directionality of wheat leaf reflectance as a function of leaf surface characteristics. Wheat leaf BRF measurements were completed under 45° zenith illumination angle in ...three visible broad spectral bands with a conoscope that provides very high angular resolution data over a large portion of the whole hemisphere, including around the illumination direction. The measurements show a clear anisotropy with a specular lobe in the forward scattering direction and a small but significant hotspot feature in the backward scattering direction. The BRF directional features further depend on the illumination orientation because of the leaf roughness created by longitudinal veins: the specular lobe was more pronounced when the illumination was perpendicular to the veins, while specular reflection was more spread over azimuths for longitudinal illumination. Moreover, a sharp hotspot feature was observed for transversal illumination where the apparent roughness is the largest. The scattering was tentatively decomposed into specular, hotspot and isotropic components. Results showed that the hotspot contribution to the directional hemispherical reflectance factor (DHRF) was marginal conversely to that of the specular component that ranges between 0.036 and 0.050 (absolute DHRF value). The specular component was almost the same in the three visible bands considered. The isotropic component originating from volume scattering was contributing the most to the DHRF and was depending on wavelength, ranging between 0.055 and 0.097 in absolute DHRF value. A simple model was proposed to estimate the volume scattering from the isotropic and the surface components. Consequences of these findings were drawn on the ability to estimate leaf biochemical composition independently from leaf surface scattering, as well as on the interpretation of remote sensing at the canopy level.
► Wheat leaf bidirectional reflectance was measured with a conoscope. ► DHRF was computed from the BRF measurements. ► The contribution of scattering processes such as hotspot on the BRDF was estimated. ► An oriented roughness corresponding to the longitudinal veins of wheat leaves was observed. ► The volume scattering was tentatively estimated from the BRDF.
The next generation of water Cherenkov neutrino telescopes in the Mediterranean Sea are under construction offshore France (KM3NeT/ORCA) and Sicily (KM3NeT/ARCA). The KM3NeT/ORCA detector features an ...energy detection threshold which allows to collect atmospheric neutrinos to study flavour oscillation. This paper reports the KM3NeT/ORCA sensitivity to this phenomenon. The event reconstruction, selection and classification are described. The sensitivity to determine the neutrino mass ordering was evaluated and found to be 4.4
σ
if the true ordering is normal and 2.3
σ
if inverted, after 3 years of data taking. The precision to measure
Δ
m
32
2
and
θ
23
were also estimated and found to be
85
.
10
-
6
eV
2
and
(
-
3.1
+
1.9
)
∘
for normal neutrino mass ordering and,
75
.
10
-
6
eV
2
and
(
-
7.0
+
2.0
)
∘
for inverted ordering. Finally, a unitarity test of the leptonic mixing matrix by measuring the rate of tau neutrinos is described. Three years of data taking were found to be sufficient to exclude
event rate variations larger than 20% at
3
σ
level.
Sources of gravitational waves are often expected to be observable through several messengers, such as gamma-rays, X-rays, optical, radio, and/or neutrino emission. The simultaneous observation of ...electromagnetic or neutrino emission with a gravitational-wave signal could be a crucial aspect for the first direct detection of gravitational waves. Furthermore, combining gravitational waves with electromagnetic and neutrino observations will enable the extraction of scientific insight that was hidden from us before. We discuss the method that enables the joint search with the LIGO-Virgo-IceCube-ANTARES global network, as well as its methodology, science reach, and outlook for the next generation of gravitational-wave detectors.