The MASCOT radiometer MARA is a multi-spectral instrument which measures net radiative flux in six wavelength bands. MARA uses thermopile sensors as sensing elements, and the net flux between the ...instrument and the surface in the
18
∘
field of view is determined by evaluating the thermoelectric potential between the sensors’ absorbing surface and the thermopile’s cold-junction. MARA houses 4 bandpass channels in the spectral range of 5.5–7, 8–9.5, 9.5–11.5, and 13.5–15.5 μm, as well as one long-pass channel, which is sensitive in the
>
3
μm
range. In addition, one channel is similar to that used by the Hayabusa 2 orbiter thermal mapper, which uses a wavelength range of 8–12 μm. The primary science objective of the MARA instrument it the determination of the target asteroid’s surface brightness temperature, from which surface thermal inertia can be derived. In addition, the spectral bandpass channels will be used to estimate the spectral slope of the surface in the thermal infrared wavelength range. The instrument has been calibrated using a cavity blackbody, and the temperature uncertainty is 1 K in the long pass channel for target temperatures of
>
173
K
. Measurement uncertainty in the spectral bandpasses is 1 K for target temperatures above 273 K.
Scheduled for launch on board the BepiColombo Mercury Planetary Orbiter (MPO) in 2014, the Mercury Radiometer and Thermal Infrared Spectrometer (MERTIS) is an innovative instrument for studying the ...surface composition and mineralogy of planet Mercury. MERTIS combines an uncooled grating push broom IR-spectrometer (TIS) with a radiometer (TIR), which will operate in the wavelength region of 7–14 and 7–40
μm, respectively. The spatial resolution of the MERTIS observations will be about 500
m globally and better than 500
m for approximately 5–10% of the surface. The thermal infrared range offers unique diagnostic capabilities to study the surface composition of Mercury. In particular, feldspars can easily be detected and characterized, because they show several diagnostic spectral signatures in the 7–14
μm range: the Christiansen feature, reststrahlen bands, and the transparency feature. In addition, MERTIS will allow the identification and mapping of elemental sulfur, pyroxenes, olivines, and other complex minerals. The scientific objectives of MERTIS include: (1) characterization of Mercury's surface composition, (2) identification of rock-forming minerals, (3) mapping of the surface mineralogy, and (4) study of surface temperature variations and the thermal inertia. In preparation for the MERTIS data interpretation, we are performing spectral measurements of appropriate analogue materials in the Planetary Emissivity Laboratory (PEL) and are building a spectral library (Berlin Emissivity Database (BED)) of these materials for a variety of grain sizes.
The near-Earth asteroid (162173) Ryugu, the target of Hayabusa2 space mission, was observed via both orbiter and the lander instruments. The infrared radiometer on the MASCOT lander (MARA) is the ...only instrument providing spectrally resolved mid-infrared (MIR) data, which is crucial for establishing a link between the asteroid material and meteorites found on Earth. Earlier studies revealed that the single boulder investigated by the lander belongs to the most common type found on Ryugu. Here we show the spectral variation of Ryugu's emissivity using the complete set of in-situ MIR data and compare it to those of various carbonaceous chondritic meteorites, revealing similarities to the most aqueously altered ones, as well as to asteroid (101955) Bennu. The results show that Ryugu experienced strong aqueous alteration prior to any dehydration.
•The 0.7 µm feature in hydrated carbonaceous chondrites correlates with water content.•Continuum reflectance is not related to carbon content but primary mineralogy.•The CR1 has a spectra very ...similar to CM, and shows an 0.7 µm feature.•The surface of Cgh/Ch asteroids is a mixture of hydrated and not hydrated material.•Goethite like 3-µm band are observed for some CR chondrites and heated CM.
In order to determine the controls on the reflectance spectra of hydrated carbonaceous chondrites, reflectance spectra were measured for a series of samples with well-determined mineralogy, water-content, and thermal history. This includes 5 CR chondrites, 11 CM chondrites, and 7 thermally metamorphosed CM chondrites. These samples were characterized over the 0.35–150 µm range by reflectance spectroscopy in order to cover the full spectral range accessible from ground based observation, and that will be determined in the near-future by the Hayabusa-2 and Osiris-REx missions. While spectra show absorption features shortward of 35 µm, no strong absorption bands were identified in this suite of samples longward of 35 µm. This work shows that the 0.7-µm band observed in hydrated carbonaceous chondrites is correlated with the total water content as well as with the band depth at 2.7 µm, confirming the suggestion that they are related to Mg-rich, Fe-bearing phyllosilicates. A feature at 2.3 µm, diagnostic of such phyllosilicates was found for all samples with a detectable 0.7-µm band, also indicative of Mg-rich phyllosilicates.
A strong variability is found in the shape of the 3-µm band among CM chondrites, and between CM, CR and thermally metamorphosed CM chondrites. Heavily altered CM chondrites show a single strong band around 2.72 µm while more thermally metamorphosed CM samples show an absorption band at higher wavelength. The CR chondrite GRO 95577 has a 3-µm feature very similar to those of extensively altered CM chondrites while other CR chondrite rather shows goethite-like signatures (possibly due to terrestrial weathering of metals). Thermally metamorphosed CM chondrites all have 3-µm features, which are not purely due to terrestrial adsorbed water. The band shape ranges from heavily altered CM-like to goethite-like.
The overall reflectance was found to be significantly higher for CR chondrites than for CM chondrites. This is also true for the hydrated CR chondrite GRO 95577 whose reflectance spectrum is almost identical to spectra obtained for CM chondrites except that it is brighter by about 40% in the visible. Another possibility to distinguish hydrated CM from hydrated CR chondrites is to use the combination of band depths at 0.7 and 2.3 µm.
When comparing the spectra obtained with Cg and Cgh spectral end member, it is found that the band depth determined for hydrated chondrites (0.7 and 2.3 µm) are always higher than calculated for these spectral endmembers. If one considers only asteroids with unambiguous hydration detection, band depth at 0.7 µm is of similar value to those measured for hydrated carbonaceous chondrites.
Abstract
Solar System bodies undergo to daily and periodical variations of temperature that mainly depend on their closeness to the Sun. It is known that mineral expansion and contraction due to such ...variations modify the thermal infrared spectra acquired on solid surfaces. Therefore, it becomes crucial to know the best temperature range at which the acquisition itself should be carried out to get reliable information on the mineralogy of such bodies. Here we provide the thermal expansion of olivine between 20 and 298 K determined by X-ray diffraction. Our data reveal the non-linear behaviour of silicates that undergo to low temperatures, where volume variations appear positively correlated with temperatures. Subtle bond-length variations occurring at low temperatures are then expected to minimally affect vibrational absorption positions. We suggest that thermal infrared spectra of those Solar-System surfaces that are not exceeding 300 K provide reliable information about not only the silicate mineral identification but also on their chemical composition, regardless of the instantaneous temperature.
Launched onboard the BepiColombo Mercury Planetary Orbiter (MPO) in October 2018, the Mercury Radiometer and Thermal Infrared Spectrometer (MERTIS) is on its way to planet Mercury. MERTIS consists of ...a push-broom IR-spectrometer (TIS) and a radiometer (TIR), which operate in the wavelength regions of 7-14 μm and 7-40 μm, respectively. This wavelength region is characterized by several diagnostic spectral signatures: the Christiansen feature (CF), Reststrahlen bands (RB), and the Transparency feature (TF), which will allow us to identify and map rock-forming silicates, sulfides as well as other minerals. Thus, the instrument is particularly well-suited to study the mineralogy and composition of the hermean surface at a spatial resolution of about 500 m globally and better than 500 m for approximately 5-10% of the surface. The instrument is fully functional onboard the BepiColombo spacecraft and exceeds all requirements (e.g., mass, power, performance). To prepare for the science phase at Mercury, the team developed an innovative operations plan to maximize the scientific output while at the same time saving spacecraft resources (e.g., data downlink). The upcoming fly-bys will be excellent opportunities to further test and adapt our software and operational procedures. In summary, the team is undertaking action at multiple levels, including performing a comprehensive suite of spectroscopic measurements in our laboratories on relevant analog materials, performing extensive spectral modeling, examining space weathering effects, and modeling the thermal behavior of the hermean surface.
The Didim meteorite contains multiple lithologies and clasts of different petrologic types in a single stone. A mixture of H5 clasts in an unequilibrated H3 host was previously observed in Didim, ...according to the initial characterization reported in the Meteoritical Bulletin Database, providing an opportunity to investigate molecular composition that contains varying degree of equilibrium with varying mineralogy. We have taken a “from large scale to small scale” approach to spectroscopically investigate the chemical content of Didim. Centimeter‐scale biconical reflectance spectra show that Didim contains abundant olivine, pyroxene, and other optically active minerals, evident from a strong Band I near 0.93 µm and a weak Band II near 1.75 µm. Micrometer‐scale Raman spectroscopic investigations reveal the presence of carbonaceous material in addition to forsteritic olivine, pyroxene (augite and enstatite), feldspars, and opaque phases such as chromite and hematite. 3‐D Raman tomographic imaging shows that the carbonaceous material near chondrules extends underneath a large olivine grain, going further down toward the interior, indicating that the observed carbonaceous matter is likely indigenous. Nano‐scale infrared measurements reveal that the observed chemical materials in Didim contain spectral, and therefore, molecular, variations at the ~20 nm spatial scale. These chemical variations are normally not accessible via conventional infrared techniques, and indicate the presence of different cations in the molecular composition of observed minerals. By taking the “large scale to small scale” approach, we show that these compositional variations can be captured and investigated nondestructively in meteorites to understand formation/evolution of chemical components in the parent body.
In situ information on the surface composition of Venus is based on measurements of a small number of landing sites. In the laboratory, we measured the emissivity of a range of igneous rocks at ...temperatures up to 480°C. We show that high-temperature laboratory spectra of basalts are consistent with the only existing multispectral data from the surface of Venus obtained by the photometers on the Venera 9 and 10 landers. We derive the FeO abundances for these landing sites of 12.2 and 9.5 weight %, respectively. From orbit, Venus' surface is only observable on the nightside through small spectral windows near 1 μm where the CO
atmosphere is largely transparent. The new laboratory data show that different rock types can be distinguished using only a small set of spectral bands. Therefore, future orbital spectral observations can provide a much-needed global composition map.
PDF
