Ring lasers are inertial sensors for angular velocity based on the Sagnac effect. In recent years they have reached a very high sensitivity and accuracy; the best performing one, the ring Laser G in ...Wettzell (Germany), a square ring with 16 m perimeter, has reached a sensitivity of 12prad/s very close to the shot noise limit inferred from ring-down time measurements. On this basis it is expected that an array of six square ring lasers of 36 m perimeter, can perform a 1% accuracy test for the measurement of the Lense-Thirring frame dragging after 2 years of integration time. Essential for this measurement is the comparison between the Earth angular velocity and orientation in space measured with the ring array and compared to the measurement series maintained by the International Earth Rotation and Reference System Service (IERS), which measures Earth Rotation and pole position with respect to remote quasars. It has been shown that the accuracy of G in Wettzell is limited by the low frequency motion of the near surface laboratory, which is of the order of several prad/s, roughly 100 times larger than the Lense-Thirring contribution. For this reason the entire experiment should be placed in a quite underground laboratory, where these perturbations are reduced. The feasibility to properly place such a device inside the GranSasso INFN National Laboratory has been investigated.
Aims. The detection and measurement of gravitational-waves from coalescing neutron-star binary systems is an important science goal for ground-based gravitational-wave detectors. In addition to ...emitting gravitational-waves at frequencies that span the most sensitive bands of the LIGO and Virgo detectors, these sources are also amongst the most likely to produce an electromagnetic counterpart to the gravitational-wave emission. A joint detection of the gravitational-wave and electromagnetic signals would provide a powerful new probe for astronomy. Methods. During the period between September 19 and October 20, 2010, the first low-latency search for gravitational-waves from binary inspirals in LIGO and Virgo data was conducted. The resulting triggers were sent to electromagnetic observatories for followup. We describe the generation and processing of the low-latency gravitational-wave triggers. The results of the electromagnetic image analysis will be described elsewhere. Results. Over the course of the science run, three gravitational-wave triggers passed all of the low-latency selection cuts. Of these, one was followed up by several of our observational partners. Analysis of the gravitational-wave data leads to an estimated false alarm rate of once every 6.4 days, falling far short of the requirement for a detection based solely on gravitational-wave data.
Aims. A transient astrophysical event observed in both gravitational wave (GW) and electromagnetic (EM) channels would yield rich scientific rewards. A first program initiating EM follow-ups to ...possible transient GW events has been developed and exercised by the LIGO and Virgo community in association with several partners. In this paper, we describe and evaluate the methods used to promptly identify and localize GW event candidates and to request images of targeted sky locations. Methods. During two observing periods (Dec. 17, 2009 to Jan. 8, 2010 and Sep. 2 to Oct. 20, 2010), a low-latency analysis pipeline was used to identify GW event candidates and to reconstruct maps of possible sky locations. A catalog of nearby galaxies and Milky Way globular clusters was used to select the most promising sky positions to be imaged, and this directional information was delivered to EM observatories with time lags of about thirty minutes. A Monte Carlo simulation has been used to evaluate the low-latency GW pipeline’s ability to reconstruct source positions correctly. Results. For signals near the detection threshold, our low-latency algorithms often localized simulated GW burst signals to tens of square degrees, while neutron star/neutron star inspirals and neutron star/black hole inspirals were localized to a few hundred square degrees. Localization precision improves for moderately stronger signals. The correct sky location of signals well above threshold and originating from nearby galaxies may be observed with ~50% or better probability with a few pointings of wide-field telescopes.
We present the first multi-wavelength follow-up observations of two candidate gravitational-wave (GW) transient events recorded by LIGO and Virgo in their 2009-2010 science run. The events were ...selected with low latency by the network of GW detectors (within less than 10 minutes) and their candidate sky locations were observed by the Swift observatory (within 12 hr). Image transient detection was used to analyze the collected electromagnetic data, which were found to be consistent with background. Off-line analysis of the GW data alone has also established that the selected GW events show no evidence of an astrophysical origin; one of them is consistent with background and the other one was a test, part of a "blind injection challenge." With this work we demonstrate the feasibility of rapid follow-ups of GW transients and establish the sensitivity improvement joint electromagnetic and GW observations could bring. This is a first step toward an electromagnetic follow-up program in the regime of routine detections with the advanced GW instruments expected within this decade. In that regime, multi-wavelength observations will play a significant role in completing the astrophysical identification of GW sources. We present the methods and results from this first combined analysis and discuss its implications in terms of sensitivity for the present and future instruments.
The sensitivity of gravitational wave interferometric detectors is ultimately limited by the quantum noise, which arises from the quantum nature of light and it is driven by vacuum fluctuations of ...the optical field entering from the dark port of the interferometer. One way to improve the sensitivity of gravitational wave interferometers is to inject squeezed vacuum into the dark port. This has been already demonstrated for the main gravitational wave detectors (GEO, Advanced LIGO and Advanced VIRGO). We are studying tricks to produce a "frequency- dependent squeezing": a standard method is to filter the squeezed optical field with one or more optical cavities (300 m long cavities). An alternative method using a pair of squeezed EPR (Einstein-Podolsky-Rosen) entangled beams to produce frequency-dependent squeezing by a non-degenerate OPO (Optical Parametric Oscillator) will be discussed in this paper. This method promises to achieve a frequency-dependent optimization of the injected squeezed light fields without the need for an external filter cavity.
PDF
