Massive MIMO is a promising technique for increasing the spectral efficiency (SE) of cellular networks, by deploying antenna arrays with hundreds or thousands of active elements at the base stations ...and performing coherent transceiver processing. A common rule-of-thumb is that these systems should have an order of magnitude more antennas M than scheduled users K because the users' channels are likely to be near-orthogonal when M/K 10. However, it has not been proved that this rule-of-thumb actually maximizes the SE. In this paper, we analyze how the optimal number of scheduled users K* depends on M and other system parameters. To this end, new SE expressions are derived to enable efficient system-level analysis with power control, arbitrary pilot reuse, and random user locations. The value of K* in the large-M regime is derived in closed form, while simulations are used to show what happens at finite M, in different interference scenarios, with different pilot reuse factors, and for different processing schemes. Up to half the coherence block should be dedicated to pilots and the optimal M/K is less than 10 in many cases of practical relevance. Interestingly, K* depends strongly on the processing scheme and hence it is unfair to compare different schemes using the same K.
A key challenge of massive MTC (mMTC), is the joint detection of device activity and decoding of data. The sparse characteristics of mMTC makes compressed sensing (CS) approaches a promising solution ...to the device detection problem. However, utilizing CS-based approaches for device detection along with channel estimation, and using the acquired estimates for coherent data transmission is suboptimal, especially when the goal is to convey only a few bits of data. First, we focus on the coherent transmission and demonstrate that it is possible to obtain more accurate channel state information by combining conventional estimators with CS-based techniques. Moreover, we illustrate that even simple power control techniques can enhance the device detection performance in mMTC setups. Second, we devise a new non-coherent transmission scheme for mMTC and specifically for grant-free random access. We design an algorithm that jointly detects device activity along with embedded information bits. The approach leverages elements from the approximate message passing (AMP) algorithm, and exploits the structured sparsity introduced by the non-coherent transmission scheme. Our analysis reveals that the proposed approach has superior performance compared with application of the original AMP approach.
Far-field microwave power transfer (MPT) will free wireless sensors and other mobile devices from the constraints imposed by finite battery capacities. Integrating MPT with wireless communications to ...support simultaneous wireless information and power transfer (SWIPT) allows the same spectrum to be used for dual purposes without compromising the quality of service. A novel approach is presented in this paper for realizing SWIPT in a broadband system where orthogonal frequency division multiplexing and transmit beamforming are deployed to create a set of parallel sub-channels for SWIPT, which simplifies resource allocation. Based on a proposed reconfigurable mobile architecture, different system configurations are considered by combining single-user/multi-user systems, downlink/uplink information transfer, and variable/fixed coding rates. Optimizing the power control for these configurations results in a new class of multi-user power-control problems featuring the circuit-power constraints, specifying that the transferred power must be sufficiently large to support the operation of the receiver circuitry. Solving these problems gives a set of power-control algorithms that exploit channel diversity in frequency for simultaneously enhancing the throughput and the MPT efficiency. For the system configurations with variable coding rates, the algorithms are variants of water-filling that account for the circuit-power constraints. The optimal algorithms for those configurations with fixed coding rates are shown to sequentially allocate mobiles their required power for decoding in ascending order until the entire budgeted power is spent. The required power for a mobile is derived as simple functions of the minimum signal-to-noise ratio for correct decoding, the circuit power and sub-channel gains.
We show that end-to-end learning of communication systems through deep neural network autoencoders can be extremely vulnerable to physical adversarial attacks. Specifically, we elaborate how an ...attacker can craft effective physical black-box adversarial attacks. Due to the openness (broadcast nature) of the wireless channel, an adversary transmitter can increase the block-error-rate of a communication system by orders of magnitude by transmitting a well-designed perturbation signal over the channel. We reveal that the adversarial attacks are more destructive than the jamming attacks. We also show that classical coding schemes are more robust than the autoencoders against both adversarial and jamming attacks.
The rate and energy efficiency of wireless channels can be improved by deploying software-controlled metasurfaces to reflect signals from the source to the destination, especially when the direct ...path is weak. While previous works mainly optimized the reflections, this letter compares the new technology with classic decode-and-forward (DF) relaying. The main observation is that very high rates and/or large metasurfaces are needed to outperform DF relaying, both in terms of minimizing the total transmit power and maximizing the energy efficiency, which also includes the dissipation in the transceiver hardware.
Reconfigurable intelligent surfaces (RIS) is a promising solution to build a programmable wireless environment via steering the incident signal in fully customizable ways with reconfigurable passive ...elements. In this paper, we consider a RIS-aided multiuser multiple-input single-output (MISO) downlink communication system. Our objective is to maximize the weighted sum-rate (WSR) of all users by joint designing the beamforming at the access point (AP) and the phase vector of the RIS elements, while both the perfect channel state information (CSI) setup and the imperfect CSI setup are investigated. For perfect CSI setup, a low-complexity algorithm is proposed to obtain the stationary solution for the joint design problem by utilizing the fractional programming technique. Then, we resort to the stochastic successive convex approximation technique and extend the proposed algorithm to the scenario wherein the CSI is imperfect. The validity of the proposed methods is confirmed by numerical results. In particular, the proposed algorithm performs quite well when the channel uncertainty is smaller than 10%.
5G wireless communication networks are currently being deployed, and B5G networks are expected to be developed over the next decade. AI technologies and, in particular, ML have the potential to ...efficiently solve the unstructured and seemingly intractable problems by involving large amounts of data that need to be dealt with in B5G. This article studies how AI and ML can be leveraged for the design and operation of B5G networks. We first provide a comprehensive survey of recent advances and future challenges that result from bringing AI/ML technologies into B5G wireless networks. Our survey touches on different aspects of wireless network design and optimization, including channel measurements, modeling, and estimation, physical layer research, and network management and optimization. Then ML algorithms and applications to B5G networks are reviewed, followed by an overview of standard developments of applying AI/ML algorithms to B5G networks. We conclude this study with future challenges on applying AI/ML to B5G networks.
Deep learning (DL), despite its enormous success in many computer vision and language processing applications, is exceedingly vulnerable to adversarial attacks. We consider the use of DL for radio ...signal (modulation) classification tasks, and present practical methods for the crafting of white-box and universal black-box adversarial attacks in that application. We show that these attacks can considerably reduce the classification performance, with extremely small perturbations of the input. In particular, these attacks are significantly more powerful than classical jamming attacks, which raises significant security and robustness concerns in the use of DL-based algorithms for the wireless physical layer.
Intelligent reflecting surfaces can improve the communication between a source and a destination. The surface contains metamaterial that is configured to "reflect" the incident wave from the source ...towards the destination. Two incompatible pathloss models have been used in prior work. In this letter, we derive the far-field pathloss using physical optics techniques and explain why the surface consists of many elements that individually act as diffuse scatterers but can jointly beamform the signal in a desired direction with a certain beamwidth. We disprove one of the previously conjectured pathloss models.
Reconfigurable Intelligent Surface (RIS) is a promising solution to reconfigure the wireless environment in a controllable way. To compensate for the double-fading attenuation in the RIS-aided link, ...a large number of passive reflecting elements (REs) are conventionally deployed at the RIS, resulting in large surface size and considerable circuit power consumption. In this paper, we propose a new type of RIS, called active RIS, where each RE is assisted by active loads (negative resistance), that reflect and amplify the incident signal instead of only reflecting it with the adjustable phase shift as in the case of a passive RIS. Therefore, for a given power budget at the RIS, a strengthened RIS-aided link can be achieved by increasing the number of active REs as well as amplifying the incident signal. We consider the use of an active RIS to a single input multiple output (SIMO) system. However, it would unintentionally amplify the RIS-correlated noise, and thus the proposed system has to balance the conflict between the received signal power maximization and the RIS-correlated noise minimization at the receiver. To achieve this goal, it has to optimize the reflecting coefficient matrix at the RIS and the receive beamforming at the receiver. An alternating optimization algorithm is proposed to solve the problem. Specifically, the receive beamforming is obtained with a closed-form solution based on linear minimum-mean-square-error (MMSE) criterion, while the reflecting coefficient matrix is obtained by solving a series of sequential convex approximation (SCA) problems. Simulation results show that the proposed active RIS-aided system could achieve better performance over the conventional passive RIS-aided system with the same power budget.
PDF
