The uncontrolled interaction of a quantum system with its environment is detrimental for quantum coherence. For quantum bits in the solid state, decoherence from thermal vibrations of the surrounding ...lattice can typically only be suppressed by lowering the temperature of operation. Here, we use a nano-electro-mechanical system to mitigate the effect of thermal phonons on a spin qubit - the silicon-vacancy colour centre in diamond - without changing the system temperature. By controlling the strain environment of the colour centre, we tune its electronic levels to probe, control, and eventually suppress the interaction of its spin with the thermal bath. Strain control provides both large tunability of the optical transitions and significantly improved spin coherence. Finally, our findings indicate the possibility to achieve strong coupling between the silicon-vacancy spin and single phonons, which can lead to the realisation of phonon-mediated quantum gates and nonlinear quantum phononics.
Grain size in polycrystalline halide perovskite films is known to have an impact on the optoelectronic properties of the films, but its influence on their soft structural properties and phase ...transitions is unclear. Here, temperature‐dependent X‐ray diffraction, absorption, and macro‐ and micro‐photoluminescence measurements are used to investigate the tetragonal to orthorhombic phase transition in thin methylammonium lead iodide films with grain sizes ranging from the micrometer scale down to the tens of nanometer scale. It is shown that the phase transition nominally at ≈150 K is increasingly suppressed with decreasing grain size and, in the smallest grains, the first evidence of a phase transition is only seen at temperatures as low as ≈80 K. With decreasing grain size, an increasing magnitude of the hysteresis is also seen in the structural and optoelectronic properties when cooling to, and then upon heating from, 100 K. This work reveals the remarkable sensitivity of the optoelectronic, physical, and phase properties to the local environment of the perovskite structure, which will have large ramifications for phase and defect engineering in operating devices.
Temperature‐dependent X‐ray diffraction, absorption and photoluminescence measurements on methylammonium lead iodide thin films with grain sizes ranging from the micrometer to the tens of nanometer scale reveal that the low‐temperature phase transition is increasingly suppressed with decreasing grain size. These results unveil the remarkable sensitivity of optoelectronic and structural properties to the local environment in perovskite thin films.
Abstract
Quasi-two-dimensional transition-metal dichalcogenides are a key platform for exploring emergent nanoscale phenomena arising from complex interactions. Access to the underlying ...degrees-of-freedom on their natural time scales motivates the use of advanced ultrafast probes sensitive to self-organised atomic-scale patterns. Here, we report the ultrafast investigation of TaTe
2
, which exhibits unique charge and lattice trimer order characterised by a transition upon cooling from stripe-like chains into a (3 × 3) superstructure of trimer clusters. Utilising MeV-scale ultrafast electron diffraction, we capture the photo-induced TaTe
2
structural dynamics – exposing a rapid ≈ 1.4 ps melting of its low-temperature ordered state followed by recovery via thermalisation into a hot cluster superstructure. Density-functional calculations indicate that the initial quench is triggered by intra-trimer Ta charge transfer which destabilises the clusters, unlike melting of charge density waves in other TaX
2
compounds. Our work paves the way for further exploration and ultimately rapid optical and electronic manipulation of trimer superstructures.
Metal halide perovskites are of great interest for various high-performance optoelectronic applications. The ability to tune the perovskite bandgap continuously by modifying the chemical composition ...opens up applications for perovskites as coloured emitters, in building-integrated photovoltaics, and as components of tandem photovoltaics to increase the power conversion efficiency. Nevertheless, performance is limited by non-radiative losses, with luminescence yields in state-of-the-art perovskite solar cells still far from 100 per cent under standard solar illumination conditions. Furthermore, in mixed halide perovskite systems designed for continuous bandgap tunability (bandgaps of approximately 1.7 to 1.9 electronvolts), photoinduced ion segregation leads to bandgap instabilities. Here we demonstrate substantial mitigation of both non-radiative losses and photoinduced ion migration in perovskite films and interfaces by decorating the surfaces and grain boundaries with passivating potassium halide layers. We demonstrate external photoluminescence quantum yields of 66 per cent, which translate to internal yields that exceed 95 per cent. The high luminescence yields are achieved while maintaining high mobilities of more than 40 square centimetres per volt per second, providing the elusive combination of both high luminescence and excellent charge transport. When interfaced with electrodes in a solar cell device stack, the external luminescence yield-a quantity that must be maximized to obtain high efficiency-remains as high as 15 per cent, indicating very clean interfaces. We also demonstrate the inhibition of transient photoinduced ion-migration processes across a wide range of mixed halide perovskite bandgaps in materials that exhibit bandgap instabilities when unpassivated. We validate these results in fully operating solar cells. Our work represents an important advance in the construction of tunable metal halide perovskite films and interfaces that can approach the efficiency limits in tandem solar cells, coloured-light-emitting diodes and other optoelectronic applications.
Perovskite solar cells and light-emission devices are yet to achieve their full potential owing in part to microscale inhomogeneities and defects that act as non-radiative loss pathways. These sites ...have been revealed using local photoluminescence mapping techniques but the short absorption depth of photons with energies above the bandgap means that conventional one-photon excitation primarily probes the surface recombination. Here, we use two-photon time-resolved confocal photoluminescence microscopy to explore the surface and bulk recombination properties of methylammonium lead halide perovskite structures. By acquiring 2D maps at different depths, we form 3D photoluminescence tomography images to visualise the charge carrier recombination kinetics. The technique unveils buried recombination pathways in both thin film and micro-crystal structures that aren't captured in conventional one-photon mapping experiments. Specifically, we reveal that light-induced passivation approaches are primarily surface-sensitive and that nominal single crystals still contain heterogeneous defects that impact charge-carrier recombination. Our work opens a new route to sensitively probe defects and associated non-radiative processes in perovskites, highlighting additional loss pathways in these materials that will need to be addressed through improved sample processing or passivation treatments.
Perovskite solar cells and light-emission devices are yet to achieve their full potential owing in part to microscale inhomogeneities and defects that act as non-radiative loss pathways. These sites ...have been revealed using local photoluminescence mapping techniques but the short absorption depth of photons with energies above the bandgap means that conventional one-photon excitation primarily probes the surface recombination. Here, we use two-photon time-resolved confocal photoluminescence microscopy to explore the surface and bulk recombination properties of methylammonium lead halide perovskite structures. By acquiring 2D maps at different depths, we form 3D photoluminescence tomography images to visualise the charge carrier recombination kinetics. The technique unveils buried recombination pathways in both thin film and micro-crystal structures that aren't captured in conventional one-photon mapping experiments. Specifically, we reveal that light-induced passivation approaches are primarily surface-sensitive and that nominal single crystals still contain heterogeneous defects that impact charge-carrier recombination. Our work opens a new route to sensitively probe defects and associated non-radiative processes in perovskites, highlighting additional loss pathways in these materials that will need to be addressed through improved sample processing or passivation treatments.
Perovskite solar cells and light-emission devices are yet to achieve their full potential owing in part to spatially heterogeneous non-radiative loss pathways that are both on, and buried beneath, the surfaces of films and crystals.
Perovskite solar cells and light-emission devices are yet to achieve their full potential owing in part to spatially heterogeneous non-radiative loss pathways that are both on, and buried beneath, ...the surfaces of films and crystals.
Perovskite solar cells and light-emission devices are yet to achieve their full potential owing in part to microscale inhomogeneities and defects that act as non-radiative loss pathways. These sites have been revealed using local photoluminescence mapping techniques but the short absorption depth of photons with energies above the bandgap means that conventional one-photon excitation primarily probes the surface recombination. Here, we use two-photon time-resolved confocal photoluminescence microscopy to explore the surface and bulk recombination properties of methylammonium lead halide perovskite structures. By acquiring 2D maps at different depths, we form 3D photoluminescence tomography images to visualise the charge carrier recombination kinetics. The technique unveils buried recombination pathways in both thin film and micro-crystal structures that aren’t captured in conventional one-photon mapping experiments. Specifically, we reveal that light-induced passivation approaches are primarily surface-sensitive and that nominal single crystals still contain heterogeneous defects that impact charge-carrier recombination. Our work opens a new route to sensitively probe defects and associated non-radiative processes in perovskites, highlighting additional loss pathways in these materials that will need to be addressed through improved sample processing or passivation treatments.
Halide perovskites have shown great potential for light emission and photovoltaic applications due to their remarkable electronic properties. Although the device performances are promising, they are ...still limited by microscale heterogeneities in their photophysical properties. Here, we study the impact of these heterogeneities on the diffusion of charge carriers, which are processes crucial for efficient collection of charges in light-harvesting devices. A photoluminescence tomography technique is developed in a confocal microscope using one- and two-photon excitation to distinguish between local surface and bulk diffusion of charge carriers in methylammonium lead bromide single crystals. We observe a large dispersion of local diffusion coefficients with values between 0.3 and 2 cm2·s–1 depending on the trap density and the morphological environmenta distribution that would be missed from analogous macroscopic or surface measurements. This work reveals a new framework to understand diffusion pathways, which are extremely sensitive to local properties and buried defects.
PDF
