The energy levels of hydrogen-like atomic systems can be calculated with great precision. Starting from their quantum mechanical solution, they have been refined over the years to include the ...electron spin, the relativistic and quantum field effects, and tiny energy shifts related to the complex structure of the nucleus. These energy shifts caused by the nuclear structure are vastly magnified in hydrogen-like systems formed by a negative muon and a nucleus, so spectroscopy of these muonic ions can be used to investigate the nuclear structure with high precision. Here we present the measurement of two 2S-2P transitions in the muonic helium-4 ion that yields a precise determination of the root-mean-square charge radius of the α particle of 1.67824(83) femtometres. This determination from atomic spectroscopy is in excellent agreement with the value from electron scattering
, but a factor of 4.8 more precise, providing a benchmark for few-nucleon theories, lattice quantum chromodynamics and electron scattering. This agreement also constrains several beyond-standard-model theories proposed to explain the proton-radius puzzle
, in line with recent determinations of the proton charge radius
, and establishes spectroscopy of light muonic atoms and ions as a precise tool for studies of nuclear properties.
A hybrid-system approach using a low-gain Yb:YAG single crystal booster amplifier behind a state-of-the-art industrial high-power femtosecond fiber system is studied to significantly increase the ...output pulse energy of the fiber amplifier. With this system, more than 60 W of average power is demonstrated at 100 kHz for pulse duration of 400 fs, corresponding to an energy per pulse of 600 µJ. Reducing the repetition rate, the energy is increased up to 2.5 mJ (before compression), which corresponds to the limitation due to laser damage threshold of the optical coatings. To scale further the energy, passive divided-pulse amplification is then implemented at the entrance of the bulk amplifier. Using this geometry, a safe nominal operating point is presented with output pulse energies of 3 mJ before and 2.3 mJ after compression and with a pulse duration of 520 fs, corresponding to a peak power of 4.4 GW.
We present Ytterbium-doped CaF2 as a laser active material with good prospects for high-power operation in thin-disk laser configuration owing to its favorable thermal properties. Thanks to its broad ...emission bandwidth the material is also suitable for the generation of ultra-short pulses. The properties of the crystal as well as the challenges related to the coating, polishing, mounting and handling processes which are essential to achieve high power laser oscillation in thin-disk configuration are discussed. A wavelength tunability of 92 nm is demonstrated, which confirms the potential of Yb:CaF2 for the generation of ultra-short pulses. An output power of 250 W with an optical efficiency of η opt = 47% was measured in CW multimode thin-disk laser operation with a pump spot diameter of 3.6 mm. Using a smaller pump spot diameter of 1 mm the fundamental mode output power was 13 W with an optical efficiency of η opt = 34%.
We report on the first demonstration of a passively (SESAM) mode-locked Yb:CaF(2) thin-disk laser operating at a repetition rate of 35 MHz with close to diffraction-limited beam quality (M(2) ≈ 1.1) ...at an average output power of up to 6.6 W. The optical efficiency was 15.3%. Nearly transform limited pulses with a duration of 445 fs and a spectral width of 2.6 nm at full width half maximum (FWHM) were obtained at the maximum output power. This corresponds to a pulse-energy of approximately 0.19 μJ and a peak-power of 0.4 MW.
A single-layer resonant-waveguide grating consisting of a sub-wavelength grating coupler etched into a waveguide is proposed in order to achieve high polarization and high spectral selectivity inside ...an Yb:YAG thin-disk laser resonator. The designed structure was fabricated with the help of a Lloyd's-mirror interference lithography setup followed by reactive ion beam etching down to the desired grating groove depth. The wavelength and polarization dependent reflectivity is measured and compared to the design results. The behaviour of the device at higher temperatures is also investigated in the present work. The device is introduced as the end mirror of an Yb:YAG thin-disk laser cavity. Output powers of up to 123 W with a spectral bandwidth of about 0.5 nm (FWHM) is demonstrated in a multimode configuration (M2~6). In fundamental-mode operation (TEM00 with M2~1.1) 70 W of power with a spectral bandwidth of about 20 pm have been obtained. Moreover, the degree of linear polarization was measured to be higher than 99% for both multimode and fundamental mode operation.
The first demonstration of an Yb:YAl3(BO3)4 thin-disk laser is reported. An output power of 109 W with an optical efficiency of 50.2% was achieved in multimode CW-operation which is to the best of ...our knowledge a significant record performance compared to previous reports on CW-lasers with this material. At a lower power level of 19.3 W the material proved its suitability for efficient operation with an optical efficiency of 60.4%. In fundamental-mode operation the extracted output power was 10.4 W with an optical efficiency of 44.5% and a beam propagation factor M(2) = 1.39. The broad emission bandwidth of the material was confirmed by measuring a continuous wavelength tuning range from 1001 to 1053 nm with a maximum output power of 36 W at 1040 nm.