In this study, the solution casting method was employed to prepare plasticized polymer electrolytes of chitosan (CS):LiCO2CH3:Glycerol with electrochemical stability (1.8 V). The electrolyte studied ...in this current work could be established as new materials in the fabrication of EDLC with high specific capacitance and energy density. The system with high dielectric constant was also associated with high DC conductivity (5.19 × 10−4 S/cm). The increase of the amorphous phase upon the addition of glycerol was observed from XRD results. The main charge carrier in the polymer electrolyte was ion as tel (0.044) < tion (0.956). Cyclic voltammetry presented an almost rectangular plot with the absence of a Faradaic peak. Specific capacitance was found to be dependent on the scan rate used. The efficiency of the EDLC was observed to remain constant at 98.8% to 99.5% up to 700 cycles, portraying an excellent cyclability. High values of specific capacitance, energy density, and power density were achieved, such as 132.8 F/g, 18.4 Wh/kg, and 2591 W/kg, respectively. The low equivalent series resistance (ESR) indicated that the EDLC possessed good electrolyte/electrode contact. It was discovered that the power density of the EDLC was affected by ESR.
In this work, plasticized magnesium ion-conducting polymer blend electrolytes based on chitosan:methylcellulose (CS:MC) were prepared using a solution cast technique. Magnesium acetate Mg(CH3COO)2 ...was used as a source of the ions. Nickel metal-complex Ni(II)-complex) was employed to expand the amorphous phase. For the ions dissociation enhancement, glycerol plasticizer was also engaged. Incorporating 42 wt% of the glycerol into the electrolyte system has been shown to improve the conductivity to 1.02 × 10−4 S cm−1. X-ray diffraction (XRD) analysis showed that the electrolyte with the highest conductivity has a minimum crystallinity degree. The ionic transference number was estimated to be more than the electronic transference number. It is concluded that in CS:MC:Mg(CH3COO)2:Ni(II)-complex:glycerol, ions are the primary charge carriers. Results from linear sweep voltammetry (LSV) showed electrochemical stability to be 2.48 V. An electric double-layer capacitor (EDLC) based on activated carbon electrode and a prepared solid polymer electrolyte was constructed. The EDLC cell was then analyzed by cyclic voltammetry (CV) and galvanostatic charge–discharge methods. The CV test disclosed rectangular shapes with slight distortion, and there was no appearance of any redox currents on both anodic and cathodic parts, signifying a typical behavior of EDLC. The EDLC cell indicated a good cyclability of about (95%) for throughout of 200 cycles with a specific capacitance of 47.4 F/g.
This work indicates that glycerolized chitosan-NH4F polymer electrolytes incorporated with zinc metal complexes are crucial for EDLC application. The ionic conductivity of the plasticized system was ...improved drastically from 9.52 × 10−4 S/cm to 1.71 × 10−3 S/cm with the addition of a zinc metal complex. The XRD results demonstrated that the amorphous phase was enhanced for the system containing the zinc metal complex. The transference number of ions (tion) and electrons (te) were measured for two of the highest conducting electrolyte systems. It confirmed that the ions were the dominant charge carriers in both systems as tion values for CSNHG4 and CSNHG5 electrolytes were 0.976 and 0.966, respectively. From the examination of LSV, zinc improved the electrolyte electrochemical stability to 2.25 V. The achieved specific capacitance from the CV plot reveals the role of the metal complex on storage properties. The charge–discharge profile was obtained for the system incorporated with the metal complex. The obtained specific capacitance ranged from 69.7 to 77.6 F/g. The energy and power densities became stable from 7.8 to 8.5 Wh/kg and 1041.7 to 248.2 W/kg, respectively, as the EDLC finalized the cycles.
Crimean-Congo haemorrhagic fever virus (CCHFV) is a tick-borne virus causing Crimean-Congo haemorrhagic fever (CCHF), a disease reported to have a high fatality rate in numerous countries. The virus ...is geographically widespread due to its vector, and numerous wild and domestic animals can develop asymptomatic infection. Serological and limited molecular evidence of CCHFV has previously been reported in
(the dromedary, or one-humped camel) in the United Arab Emirates (UAE). In this study, 238 camel samples were screened for CCHFV RNA where 16 camel samples were positive for CCHFV by RT-PCR. Analysis of full-length CCHFV genome sequences revealed a novel lineage in camels from the UAE, and potential reassortment of the M segment of the genome.
The polymer electrolyte based on Dx:Cs:Mg(CH
COO)
:Ni with three different glycerol concentrations have been prepared. The impedance study has verified that the electrolyte with 42 wt.% of glycerol ...(A3) has the highest ionic conductivity of 7.71 × 10
S cm
at room temperature. The ionic conductivity is found to be influenced by the transport parameters. From the dielectric analysis, it was shown that the electrolytes in this system obeyed the non-Debye behavior. The A3 electrolyte exhibited a dominancy of ions (
>
) with a breakdown voltage of 2.08 V. The fabricated electrochemical double layer capacitor (EDLC) achieved the specific capacitance values of 24.46 F/g and 39.68 F/g via the cyclic voltammetry (CV) curve and the charge-discharge profile, respectively. The other significant parameters to evaluate the performance of EDLC have been determined, such as internal resistance (186.80 to 202.27 Ω) energy density (4.46 Wh/kg), power density (500.58 to 558.57 W/kg) and efficiency (92.88%).
Particleboards made of Rhizophora spp. with addition of tannin adhesive were fabricated at target density of 1.0 g/cm3. The physical and mechanical properties of the particleboards including internal ...bond strength (IB) and modulus of rupture (MOR) were measured based on Japanese Industrial Standards (JIS A-5908). The characterisation of the particleboards including the effective atomic number, CT number and relative electron density were determined and compared to water. The mass attenuation coefficient of the particleboards were measured and compared to the calculated value of water using photon cross-section database (XCOM). The results showed that the physical and mechanical properties of the particleboards complied with Type 13 and 18 of JIS A-5908. The values of effective atomic number, CT number and relative electron density were also close to the value of water. The value of mass attenuation coefficients of the particleboards showed good agreement with water (XCOM) at low and high energy photon indicated by the χ2 values.
•We demonstrated a passively Q-switched erbium-doped fiber laser with ultranarrow linewidth.•Ultranarrow linewidth laser operation is realized based on spectral filtering effect.•A linewidth value of ...17.5 kHz, which may be the narrowest linewidth for a Q-switched fiber laser to the best of our knowledge.
A tunable passively Q-switched erbium-doped fiber laser with ultranarrow linewidth is proposed and demonstrated. With the single wall carbon nanotubes (SWCNTs) as the passive Q-switch, the ultranarrow linewidth laser operation is realized based on spectral filtering effect.
using an ultranarrow tunable bandpass filter (UNTBF). The Q-switched laser spectrum is tunable from 1525 to 1561 nm, covering a wavelength range of 36 nm. At 1545 nm, the highest repetition rate of ~38 kHz and the lowest pulse width of 1.15 μs are obtained, with the corresponding pulse energy of approximately 0.18nJ. The linewidth measurement using self-heterodyne technique yields a linewidth value of 17.5 kHz, which may be the narrowest linewidth for a Q-switched fiber laser to the best of our knowledge.
Studies on the influence of social support on activity limitation among older persons remain limited. A better understanding of this relationship will help with resource planning and policy making ...aimed to reduce burden of care. The objective of this study was to assess the influence of social support on limitation in daily living among older persons in Malaysia.
Data from the National Health and Morbidity Survey 2018, a nation-wide, cross-sectional survey using a two-stage stratified sampling design, were analyzed. A representative sample of individuals aged ≥60 years identified through national sampling frames throughout Malaysia was included. Face-to-face interviews were conducted using validated questionnaires on activities of daily living (ADL) and instrumental ADL (IADL). Social support was measured using the Duke Social Support Index.
The overall prevalence of the presence of any limitations in ADL and IADL was 17.0% and 42.9% respectively. Overall prevalence of the older persons with low to fair social support was 30.8% and high to very high social support was 69.2%. Logistic regression analysis identified the following factors as being associated with limitations in ADL and IADL: being female, of older age, having a monthly income <RM 1000 and reporting low to fair social support.
Low social support was associated with limitation in daily living among older persons in Malaysia. Future studies should consider evaluating the potential benefits of increasing social support on the activity limitation of our older population. Geriatr Gerontol Int 2020; 20: 26-32.
The linearity of Al2O3 OSL dosimeters (OSLD) were evaluated for dosimetry works in clinical photons and electrons. The measurements were made at a reference depth of Zref according to IAEA TRS ...398:2000 codes of practice at 6 and 10 MV photons and 6 and 9 MeV electrons. The measured dose was compared to the thermoluminescence dosimeters (TLD) and ionization chamber commonly used for dosimetry works for higher energy photons and electrons. The results showed that the measured dose in OSL dosimeters were in good agreement with the reported by the ionization chamber in both high energy photons and electrons. A reproducibility test also reported excellent consistency of readings with the OSL at similar energy levels. The overall results confirmed the suitability of OSL dosimeters for dosimetry works involving high energy photons and electrons in radiotherapy.
Abstract
Leading the palm oil industry, Malaysia strives to become the powerhouse of palm oil producers. However, it is crucial that the industry does not influence the environment negatively in any ...way. Thus, reusing and repurposing palm oil residues in mushroom farming is one of the potential solutions for agricultural waste management. In this study, the objective of this study is to determine the mycelial performance of
V. volvacea
in palm oil empty fruit bunch (EFB) fibre as substrate and to evaluate the mycelial growth performance of
V. volvacea
in two different substrate treatment. The substrate treatment involved the non-treated EFB fibres (N substrate) and EFB fibres treated with 10% Calcium Carbonate (CaCO
3
) (T substrate), and mycelium treatment involved in gamma-irradiated mycelium (G sample) and non-irradiated mycelium (NG sample). Results shows that mycelium inoculated on treated EFB fibres exhibited a higher growth rate compared to non-treated EFB fibres. The full colonization days of mycelial run-on substrate using treated substrate was found reduced from 15 days to 9 days, as compared to the non-treated substrate. However, gamma irradiated mycelium was found giving no significant changes to the rate of mycelial run. In conclusion, substrate treated with CaCO
3
, increased the growth of mycelium. In future, it is suggested to measure the effect of irradiation using different gamma irradiation exposure.
PDF
