Different cooling rates, such as room temperature water cooling (WQ), furnace cooling (FC), and water cooling + furnace cooling (FC +WQ), were introduced to study the effect on the solution-treated ...Mg-9Gd-4Y-2Zn-0.5Zr (w/%) alloy microstructure and mechanical properties. The grain size decreases as the cooling rate increases. With the lengthening of the cooling process time, the LPSO phase had enough time to nucleate and diffuse, the LPSO (long-period stacking order) phase filled the whole matrix crystal grains at the same time. In the process of furnace cooling and water cooling, the brightness of the LPSO phase was different, so it could be seen that the cooling rate would affect the contrast and morphology of the LPSO phase. The tensile yield strengths of the samples cooled with the furnace were better than those of the water-cooled samples, but their ultimate tensile strength and elongation to failure were poor. The fracture modes of the samples under different cooling rates were all subject to cleavage fracture, and the number and area of the cleavage planes and cleavage steps increased with the decrease of cooling speed, and the tearing area decreased, resulting in poor ultimate tensile strength and stretchability.
Aluminium alloys of group 2xxx contain copper as the main alloying element. Copper increases the strength and workability of the alloy, but also reduces the corrosion resistance and weldability. ...During casting, a nonequilibrium solidification occurs. Therefore, the cast alloy needs to be heat treated with a so-called homogenization process. Homogenization allows us to eliminate crystalline segregations and low-melting eutectics, and also causes changes in the morphology of intermetallic phases. The forming ability is in this way increased. In this research the subject of the investigations was the aluminium alloy with designation EN AW 2011 (AlCuBiPb), whereas the comparative analysis before and after homogenization annealing was made. Homogenization was conducted at 520 °C for 6 h. First, slices from two rods before and after homogenization were cut out, where three samples from each slice of the rod, namely in the middle, on D/4 and at the edge of the slice were prepared. Differential scanning calorimetry (DSC) was performed on all six samples, the results were compared with each other in order to establish the structure homogeneity before and after the homogenization process through the cross-section of the rod. Samples for light (LM) and scanning electron microscopy (SEM) were also prepared, whereas the phase composition and chemical homogeneity were analysed. Using the Thermo-Calc program, the nonequilibrium solidification was simulated and the phase formation during solidification was examined. From the obtained results, it was concluded that the homogenization was carried out successfully, due to a homogeneous chemical distribution in the examined phases and to a fairly homogeneous chemical composition throughout the cross-section of the rod slice.
PDF
