Display omitted •The Cu2O films were fabricated under various oxidizing conditions by anodic oxidation.•The film quality was improved by decreasing the load current density.•The film quality means the crystal grain size, crystallinity and CuCl contamination.•The improvement of film quality was leading to more powerful Cu2O/Cu solar cells. In this paper, we demonstrate that improvements in the Cu2O film quality and consequently the output power of Cu2O/Cu solar cells can be achieved by decreasing the load current density used in production of the film by anodic oxidation. Cu2O films were fabricated under various oxidizing condition in an aqueous solution of CuSO4, NaCl and LiCl at a temperature of 86°C. The load current density and loading time were varied. The variations in the output power of the solar cells with film thickness and quality, determined by the electrical resistance, the amount of CuCl in the Cu2O film, and the crystal quality and crystal grain size of the Cu2O, were evaluated. From the maximum value of the output power, the best film thickness of the Cu2O film was found to be about 8–10μm. Moreover, Cu2O films with lower electrical resistance, less CuCl, greater crystal quality and larger crystal grain size led to more powerful solar cells, i.e., higher output power. These Cu2O films were obtained by decreasing the load current density used in fabrication. The highest output power achieved (with load current density=1.25mA/cm2, loading time=8h) was 702nW.