E-viri
Recenzirano
-
Xueguang, Zhang; Wenjie, Zhang; Jiaming, Chen; Dianguo, Xu
IEEE transactions on energy conversion, 06/2014, Letnik: 29, Številka: 2Journal Article
Module parallel connection for three-phase VSC can increase the system level effectively. However, the circulating currents problem will occur. The circulating currents will distort the three-phase currents, increase the power loss and decrease the system efficiency. A novel deadbeat circuiting currents control method is proposed in this paper. Based on the analysis of the average model of parallel system, a circuiting currents deadbeat controller is designed while presenting the design method. The control strategy is realized by adjusting the voltage zero vector of space-vector pulse-width modulation in each paralleled module. No additional hardware is needed through the method. Fast dynamic response can be achieved and the performance of circulating currents is better compared with conventional PI controller. This method can be applied to common dc-link double parallel three-phase voltage converters with communication line. The validity of proposed theory was verified by simulation and experimental results. It is shown that the parallel converters can operate with different line inductor or different line currents by using this novel control strategy.
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.