Measuring the ground reaction forces (GRF) underlying sprint acceleration is important to understanding the performance of such a common task. Until recently direct measurements of GRF during sprinting were limited to a few steps per trial, but a simple method (SM) was developed to estimate GRF across an entire acceleration. The SM utilizes displacement- or velocity-time data and basic computations applied to the runner’s center of mass and was validated against compiled force plate (FP) measurements; however, this validation used multiple-trials to generate a single acceleration profile, and consequently fatigue and error may have introduced noise into the analyses. In this study, we replicated the original validation by comparing the main sprint kinetics and force-velocity-power variables (e.g. GRF and its horizontal and vertical components, mechanical power output, ratio of horizontal component to resultant GRF) between synchronized FP data from a single sprinting acceleration and SM data derived from running velocity measured with a 100 Hz laser. These analyses were made possible thanks to a newly developed 50-m FP system providing seamless GRF data during a single sprint acceleration. Sixteen trained male sprinters performed two all-out 60-m sprints. We observed good agreement between the two methods for kinetic variables (e.g. grand average bias of 4.71%, range 0.696 ± 0.540–8.26 ± 5.51%), and high inter-trial reliability (grand average standard error of measurement of 2.50% for FP and 2.36% for the SM). This replication study clearly shows that when implemented correctly, this method accurately estimates sprint acceleration kinetics.