-
Improvement of electric discharge machining (EDM) performance of Ti-6Al-4v alloy with added graphite powder to dielectricUnses, Emre ; Cogun, CanTi-6Al-4V is a well-known Ti alloy widely used in the aerospace industry and belongs to the group of difficult-to-machine materials. It is less suitable for both conventional chip removal (machining) ... techniques and electric discharge machining (EDM). The very low material removal rate (MRR) of the Ti alloys during the EDM process causes prohibitively long machining durations. The goal of this study was to improve the EDM performance of the Ti-6Al-4V alloy by the addition of graphite powder into the kerosene dielectric liquid. The EDM performance was quantified by MRR, tool electrode wear rate (EWR), relative wear (RW), surface roughness and texture properties. The experiments conducted have shown that the use of graphite powder mixed with the kerosene dielectric (GPMKD) during machining considerably increases the MRR, improves the R a and R z(DIN) surface roughness and decreases the RW. 3D topographic views of the machined workpiece surfaces attained with GPMKD revealed uniformly distributed surface valleys and peaks over the surface and peaks with short and round tops since the discharge energy of a spark is distributed over a large area at the machining gap. The experimental results strongly indicate the adaptability of the proposed technique to EDM die sinking and EDM drilling applications of the Ti-6Al-4V alloy in the aerospace industry. The ED machining performance of Ti-6Al-4V alloy using GPMKD is also compared to that of AISI 1040 steel, which is commonly used in EDM applications.Source: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 61, no. 6, Jun. 2016, str. 409-418)Type of material - article, component partPublish date - 2015Language - englishCOBISS.SI-ID - 14054939
Author
Unses, Emre |
Cogun, Can
Topics
electric discharge machining |
EDM |
Ti-6Al-4V |
graphite powder |
material removal |
tool electrode wear |
roughness |
3D surface topography |
elektroerozijska obdelava |
Ti-6Al-4V |
grafitni prah |
odstranjevanje materiala |
obraba orodne elektrode |
hrapavost |
3D-topografija površine
![loading ... loading ...](themes/default/img/ajax-loading.gif)
source: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 61, no. 6, Jun. 2016, str. 409-418)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Shelf entry
Permalink
- URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year | Impact factor | Edition | Category | Classification | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Select the library membership card:
DRS, in which the journal is indexed
Database name | Field | Year |
---|
Links to authors' personal bibliographies | Links to information on researchers in the SICRIS system |
---|---|
Unses, Emre | ![]() |
Cogun, Can | ![]() |
Select pickup location:
Material pickup by post
Notification
Subject headings in COBISS General List of Subject Headings
Select pickup location
Pickup location | Material status | Reservation |
---|
Please wait a moment.