Zn0.5Fe2.5O4 nanoparticles (NPs) of 22 nm are synthesized by a one-pot approach and coated with silica for magnetic hyperthermia agents. The NPs exhibit superparamagnetic characteristics, ...high-specific absorption rate (SAR) (1083 wg-1, f = 430 kHz, H = 27 kAm-1), large saturation magnetization (M s = 85 emu g-1), excellent colloidal stability and low cytotoxicity. The cell uptake properties have been investigated by Prussian blue staining, transmission electron microscopy and the inductively coupled plasma-mass spectrometer, which resulted in time-dependent and concentration-dependent internalization. The internalization appeared between 0.5 and 2 h, the NPs were mainly located in the lysosomes and kept in good dispersion after incubation with human osteosarcoma MG-63 cells. Then, the relationship between cell uptake and magnetic hyperthermia performance was studied. Our results show that the hyperthermia efficiency was related to the amount of internalized NPs in the tumour cells, which was dependent on the concentration and incubation time. Interestingly, the NPs could still induce tumour cells to apoptosis/necrosis when extracellular NPs were rinsed, but the cell kill efficiency was lower than that of any rinse group, which indicated that local temperature rise was the main factor that induced tumour cells to death. Our findings suggest that this high SAR and biocompatible silica-coated Zn0.5Fe2.O4 NPs could serve as new agents for magnetic hyperthermia.
Magnesium potassium phosphate cement (MKPC) has attracted considerable attention as a bone regeneration material. However, there are only a few reports on its biomechanical properties. To evaluate ...the biomechanical properties of MKPC, we compared the mechanical parameters of pedicle screws enhanced with either MKPC or polymethyl methacrylate (PMMA) bone cement. The results show that the maximum pull-out force of the pedicle screws was 417.86 ± 55.57 and 444.43 ± 19.89 N after MKPC cement setting for 30 min and 12 h, respectively, which was better than that of the PMMA cement. In fatigue tests, the maximum pull-out force of the MKPC cement group was 435.20 ± 7.96 N, whereas that of the PMMA cement in the control group was 346.80 ± 7.66 N. Furthermore, the structural characterization analysis of the MKPC cement revealed that its microstructure after solidification was an irregular tightly packed crystal, which improved the mechanical strength of the cement. The maximum exothermic temperature of the MKPC reaction was 45.55 ± 1.35 °C, the coagulation time was 7.89 ± 0.37 min, and the compressive strength was 48.29 ± 4.76 MPa, all of which meet the requirements of clinical application. In addition, the MKPC cement did not significantly inhibit cell proliferation or increase apoptosis, thus indicating good biocompatibility. In summary, MKPC exhibited good biomechanical properties, high initial strength, good biocompatibility, and low exothermic reaction temperature, demonstrating an excellent application potential in the field of orthopedics.
To review the research progress of different surgical approaches in the treatment of acetabular both-column fractures.
The domestic and foreign related research literature on surgical approaches for ...acetabular both-column fractures was extensively consulted. The anatomical characteristics, exposure ranges, advantages, disadvantages, and indications of various common surgical approaches for both-column fractures were mainly summarized.
The ilioinguinal approach is more suitable for both-column fractures if the anterior column fracture is complicated or combined with the anterior wall fracture while the posterior column fracture is simple and stable. The modified Stoppa approach or the lateral (para) rectus abdominal approach is the preferred choice when both-column fractures are combined with a quadrilateral fracture or femoral head dislocation. What's more, the Kocher-Langenbeck approach is required when the posterior column fractures are complicated or combined with posterior wall fractures. In addition, the
Abstract
The treatment of bone defect after bone tumor resection is a great challenge for orthopedic surgeons. It should consider that not only to inhibit tumor growth and recurrence, but also to ...repair the defect and preserve the limb function. Hence, it is necessary to find an ideal functional biomaterial that can repair bone defects and inactivate tumor. Magnetic nanoparticles (MNPs) have its unique advantages to achieve targeted hyperthermia to avoid damage to surrounding normal tissues and promote osteoblastic activity and bone formation. Based on the previous stage, we successfully prepared hydroxyapatite (HAP) composite poly(lactic-co-glycolic acid) (PLGA) scaffolds and verified its good osteogenic properties, in this study, we produced an HAP composite PLGA scaffolds modified with MNPs. The composite scaffold showed appropriate porosity and mechanical characteristics, while MNPs possessed excellent magnetic and thermal properties. The cytological assay indicated that the MNPs have antitumor ability and the composite scaffold possessed good biocompatibility. In vivo bone defect repair experiment revealed that the composite scaffold had good osteogenic capacity. Hence, we could demonstrate that the composite scaffolds have a good effect in bone repair, which could provide a potential approach for repairing bone defect after bone tumor excision.
The treatment of critical-size bone defects remains a complicated clinical challenge. Recently, bone tissue engineering has emerged as a potential therapeutic approach for defect repair. This study ...examined the biocompatibility and repair efficacy of hydroxyapatite-mineralized bionic polylactic acid (PLA) scaffolds, which were prepared through a combination of 3D printing technology, plasma modification, collagen coating, and hydroxyapatite mineralization coating techniques. Physicochemical analysis, mechanical testing, and in vitro and animal experiments were conducted to elucidate the impact of structural design and microenvironment on osteogenesis. Results indicated that the PLA scaffold exhibited a porosity of 84.1% and a pore size of 350 μm, and its macrostructure was maintained following functionalization modification. The functionalized scaffold demonstrated favorable hydrophilicity and biocompatibility and promoted cell adhesion, proliferation, and the expression of osteogenic genes such as ALP, OPN, Col-1, OCN, and RUNX2. Moreover, the scaffold was able to effectively repair critical-size bone defects in the rabbit radius, suggesting a novel strategy for the treatment of critical-size bone defects.
Background
The position and number of cages in minimally invasive transforaminal interbody fusion (MIS-TLIF) are mainly determined by surgeons based on their individual experience. Therefore, it is ...important to investigate the optimal number and position of cages in MIS-TLIF.
Methods
The lumbar model was created based on a 24-year-old volunteer's computed tomography data and then tested using three different cage implantation methods: single transverse cage implantation (model A), single oblique 45° cage implantation (model B), and double vertical cage implantation (model C). A preload of 500 N and a moment of 10 Nm were applied to the models to simulate lumbar motion, and the models' range of motion (ROM), ROM ratio, peak stress of the internal fixation system, and cage were assessed.
Results
The ROM ratios of models A, B, and C were significantly reduced by >71% compared with the intact model under all motions. Although there were subtle differences in the ROM ratio for models A, B, and C, the trends were similar. The peak stress of the internal fixation system appeared in model B of 136.05 MPa (right lateral bending), which was 2.07 times that of model A and 1.62 times that of model C under the same condition. Model C had the lowest cage stress, which was superior to that of the single-cage model.
Conclusion
In MIS-TLIF, single long-cage transversal implantation is a promising standard implantation method, and double short-cage implantation is recommended for patients with severe osteoporosis.
Conventional open transforaminal lumbar interbody fusion (TLIF) using unilateral pedicle screws and a translaminar facet screw has been performed for many years with good results. The outcomes of ...minimally invasive TLIF (MIS TLIF) are similar to the good outcomes of open TLIF, with the additional benefits of reducing iatrogenic injury, shortening hospital stays, and reducing the recovery duration. Instead of using small cuts on both sides, we performed MIS TLIF through a single cut using unilateral pedicle screws and a translaminar facet screw. The operative feasibility, efficacy safety, and benefits of single-level MIS TLIF of such techniques require further clarification.
A total of 60 patients with various single-segment lower lumbar vertebral diseases were treated in our department from January 2010 to March 2013. All the patients were initially performed single-level MIS TLIF using a hybrid construction of unilateral pedicle screws and a translaminar facet screw. Patient demographics and operative data were collected. The clinical outcomes were assessed before surgery and 3, 6, 12, and 24 months after surgery using the visual analog scale (VAS) for back and leg pain and the Oswestry Disability Index (ODI). Radiologic assessment of the lumbar spine with static and dynamic plain radiographs was performed 3, 6, 12, and 24 months after surgery. The fusion rates were assessed by an independent radiologist 2 years after surgery according to the Bridwell interbody fusion grading system.
No patients experienced significant postoperative complications. Excepting two cases, 58 cases were followed up for 24-38 months, averaged 29.9 ± 4.1 months. The patients' average age was 46.6 ± 11.5 years, operative time 109.7 ± 17.8 min, intraoperative blood loss 67.3 ± 29.7 ml, length of incision 29.0 ± 3.2 mm, fluoroscopy time 31.1 ± 7.2 s, time to ambulation 20.3 ± 7.0 h, length of hospital stay 5.1 ± 1.1 days, and length of the translaminar facet screw 51.7 ± 3.4 mm. Screw position results: type I, 54 cases with 54 segments; type II, four cases with four segments. There were two (3.4%) translaminar facet screw failures, which were intraoperatively converted to a bilateral pedicle screw fixation procedure and excluded from the research. The postoperative images showed good positioning of the hybrid internal fixation, and all of the translaminar facet screws penetrated the facet joint. Two (3.6%) translaminar facet screws penetrated the lateral lamina and two (3.6%) translaminar facet screws penetrated the medial lamina without any serious neural complications. During the follow-up, there was no screw loosening or pedicle fracture observed. The VAS and ODI scores were significantly improved compared with the preoperative scores (P < 0.05), and the symptoms disappeared gradually. Fifty-one patients (87.9%) achieved grade I fusion radiographically at the final follow-up.
MIS TLIF using a hybrid construction of unilateral pedicle screws and a translaminar facet screw is safe and effective in the treatment of single-segment lower lumbar vertebral disease, and it can be used as an optimal choice for fixation and fusion of some single-segment lower lumbar vertebral diseases.
To compare the effectiveness of minimally invasive transforaminal lumbar interbody fusion (MIS-TLIF) with bilateral decompression via unilateral approach and bilateral decompression via bilateral ...approaches in the treatment of single-segment lumbar spinal stenosis.
Between February 2015 and January 2017, 70 cases of single-segment lumbar spinal stenosis were treated with MIS-TLIF. The bilateral decompression via unilateral approach (group U) was performed in 36 cases and bilateral decompression via bilateral approaches (group B) in 34 cases. There was no significant difference in age, gender, body mass index, disease duration, distribution of responsibility segments, preoperative visual analogue scale (VAS) score of low back pain and leg pain and Oswestry disability index (ODI) score (
>0.05). The operation time, intraoperative blood loss, hospitalization stay after operation, complications related to operation, incidence of asymptomatic lateral root symptoms, VAS scores of low back pain and leg pain, and ODI
Fracture nonunion is the cessation of a normal reparative process of fracture healing. With an incidence of 2.5%-4.4%, it is one of difficult problem for orthopedics surgeons. Definition, ...classification, treatment and causes of fracture nonunion are reviewed in this article. The therapeutic principles and methods are introduced systematically combined with causes of fracture nonunion.
Immediate hemorrhage control and infection prevention are pivotal for saving lives in critical situations such as battlefields, natural disasters, traffic accidents, and so on. In situ hydrogels are ...promising candidates, but their mechanical strength is often not strong enough for use in critical situations. In this study, we constructed three hydrogels with different amounts of Schiff-base moieties from 4-arm-PEG-NH2, 4-arm-PEG-NHS, and 4-arm-PEG-CHO in which vancomycin was incorporated as an antimicrobial agent. The hydrogels possess porous structures, excellent mechanical strength, and high swelling ratio. The cytotoxicity studies indicated that the composite hydrogel systems possess good biocompatibility. The Schiff bases incorporated improve the adhesiveness and endow the hydrogels with bacteria-sensitivity. The in vivo hemostatic and antimicrobial experiments on rabbits and pigs demonstrated that the hydrogels are able to aid in rapid hemorrhage control and infection prevention. In summary, vancomycin-loaded hydrogels may be excellent candidates as hemostatic and antibacterial materials for first aid treatment of the wounded in critical situations.
PDF
