Single crystal CVD (scCVD) diamond is an attractive material for particle detection in high energy physics for its good time resolution and reported outstanding radiation tolerance. In addition to ...direct signal loss via charge carrier trapping, polarization effect, caused by non-homogeneous filling of trap defects, is a known cause of signal degradation in irradiated scCVD diamond. This phenomenon was studied by intentionally polarizing irradiated diamonds. Even the relatively lightly irradiated (1014 protons/cm2) diamonds exhibited strong enough polarization to collapse the electric field with moderate rate of 5 MeV alpha particles. The transient current measurements were reproduced with TCAD simulations. The hypothesis that the polarization is caused by single neutral defect type in the bulk, was tested using two generic models. Neither one has a satisfactory agreement with the measurement data, which indicates that trapping at the interfaces play a significant role in space charge polarization.
Display omitted
•Space charge polarization was studied with irradiated single crystal diamond sensors.•Full collapse of the electric field was observed for all irradiated samples.•To remove polarization in low fluence samples switching bias voltage on-off effective•Polarization very likely cannot be explained by trapping in the bulk only.
The Phase-2 upgrade of the Large Hadron Collider (LHC) to High-Luminosity LHC (HL-LHC) allows an increase in the operational luminosity value by a factor of 5–7 that will result in delivering ...3000 fb−1 or more integrated luminosity. Due to high luminosity, the number of interactions per bunch crossings (pileup) will increase up to a value of 140–200. To cope with high pileup rates, a precision minimum ionising particles (MIPs) timing detector (MTD) with a time resolution of ∼30–40 ps and hermetic coverage up to a pseudo-rapidity of |η|=3 is proposed by the Compact Muon Solenoid (CMS) experiment. An endcap part (1.6<|η|<3) of the MTD, called the endcap timing layer, will be based on low-gain avalanche detector (LGAD) technology. LGADs provide a good timing resolution due to a combination of a fast signal rise time and high signal-to-noise ratio. The performance of the ETL depends on optimising the crucial features of the sensors, namely; gain, signal homogeneity, fill factor, leakage current, uniformity of multiple-pad sensors and long term stability. The paper mainly focuses on the study of the fill factor of LGADs with varying temperature and irradiation at varying proton fluences as these sensors will be operated at low temperatures and are subjected to a high radiation environment.
The 3.1 production of LGADs from Hamamatsu Photonics K.K. (HPK) includes 2x2 sensors with different structures, in particular, different values of narrower inactive region widths between the pads, called the no-gain region. In this paper, the term interpad-gap is used instead of no-gain region in order to follow the conventional terminology. These sensors have been designed to study their fill factor, which is the ratio of the area within the active region (gain region) to the total sensor area. A comparative study on the dependence of breakdown voltage with the interpad-gap width for the sensors has been carried out. Using infrared light (as the electron–hole pair creation by IR laser mimics closely to the traversing of MIPs) from the Scanning-Transient Current Technique (Scanning-TCT) set-up shows that the fill factor does not vary significantly with a variation in temperature and irradiation at high proton fluences.
Abstract
The TOTEM collaboration has measured the elastic proton-proton differential cross section
$$\mathrm{d}\sigma /\mathrm{d}t$$
d
σ
/
d
t
at
$$\sqrt{s}=13$$
s
=
13
TeV LHC energy using ...dedicated
$$\beta ^{*}=90$$
β
∗
=
90
m beam optics. The Roman Pot detectors were inserted to 10
$$\sigma $$
σ
distance from the LHC beam, which allowed the measurement of the range 0.04 GeV
$$^{2}$$
2
; 4 GeV
$$^{2}$$
2
$$$$
in four-momentum transfer squared |
t
|. The efficient data acquisition allowed to collect about 10
$$^{9}$$
9
elastic events to precisely measure the differential cross-section including the diffractive minimum (dip), the subsequent maximum (bump) and the large-|
t
| tail. The average nuclear slope has been found to be
$$B=(20.40 \pm 0.002^{\mathrm{stat}} \pm 0.01^{\mathrm{syst}})~$$
B
=
(
20.40
±
0
.
002
stat
±
0
.
01
syst
)
GeV
$$^{-2}$$
-
2
in the |
t
|-range 0.04–0.2 GeV
$$^{2}$$
2
. The dip position is
$$|t_{\mathrm{dip}}|=(0.47 \pm 0.004^{\mathrm{stat}} \pm 0.01^{\mathrm{syst}})~$$
|
t
dip
|
=
(
0.47
±
0
.
004
stat
±
0
.
01
syst
)
GeV
$$^{2}$$
2
. The differential cross section ratio at the bump vs. at the dip
$$R=1.77\pm 0.01^{\mathrm{stat}}$$
R
=
1.77
±
0
.
01
stat
has been measured with high precision. The series of TOTEM elastic pp measurements show that the dip is a permanent feature of the pp differential cross-section at the TeV scale.
The TOTEM experiment has made a precise measurement of the elastic proton–proton differential cross-section at the centre-of-mass energy s=8 TeV based on a high-statistics data sample obtained with ...the β⁎=90 m optics. Both the statistical and systematic uncertainties remain below 1%, except for the t-independent contribution from the overall normalisation. This unprecedented precision allows to exclude a purely exponential differential cross-section in the range of four-momentum transfer squared 0.027<|t|<0.2 GeV2 with a significance greater than 7 σ. Two extended parametrisations, with quadratic and cubic polynomials in the exponent, are shown to be well compatible with the data. Using them for the differential cross-section extrapolation to t=0, and further applying the optical theorem, yields total cross-section estimates of (101.5±2.1) mb and (101.9±2.1) mb, respectively, in agreement with previous TOTEM measurements.
The TOTEM collaboration has measured the proton–proton total cross section at
s
=
13
TeV
with a luminosity-independent method. Using dedicated
β
∗
=
90
m
beam optics, the Roman Pots were inserted ...very close to the beam. The inelastic scattering rate has been measured by the T1 and T2 telescopes during the same LHC fill. After applying the optical theorem the total proton–proton cross section is
σ
tot
=
(
110.6
±
3.4
) mb, well in agreement with the extrapolation from lower energies. This method also allows one to derive the luminosity-independent elastic and inelastic cross sections:
σ
el
=
(
31.0
±
1.7
)
mb
and
σ
inel
=
(
79.5
±
1.8
)
mb
.
The TOTEM experiment at the LHC has performed the first measurement at
s
=
13
TeV
of the
ρ
parameter, the real to imaginary ratio of the nuclear elastic scattering amplitude at
t
=
0
, obtaining the ...following results:
ρ
=
0.09
±
0.01
and
ρ
=
0.10
±
0.01
, depending on different physics assumptions and mathematical modelling. The unprecedented precision of the
ρ
measurement, combined with the TOTEM total cross-section measurements in an energy range larger than
10
TeV
(from 2.76 to
13
TeV
), has implied the exclusion of all the models classified and published by COMPETE. The
ρ
results obtained by TOTEM are compatible with the predictions, from other theoretical models both in the Regge-like framework and in the QCD framework, of a crossing-odd colourless 3-gluon compound state exchange in the
t
-channel of the proton–proton elastic scattering. On the contrary, if shown that the crossing-odd 3-gluon compound state
t
-channel exchange is not of importance for the description of elastic scattering, the
ρ
value determined by TOTEM would represent a first evidence of a slowing down of the total cross-section growth at higher energies. The very low-|
t
| reach allowed also to determine the absolute normalisation using the Coulomb amplitude for the first time at the LHC and obtain a new total proton–proton cross-section measurement
σ
tot
=
(
110.3
±
3.5
)
mb
, completely independent from the previous TOTEM determination. Combining the two TOTEM results yields
σ
tot
=
(
110.5
±
2.4
)
mb
.
The TOTEM collaboration has measured the elastic proton-proton differential cross section
d
σ
/
d
t
at
s
=
13
TeV LHC energy using dedicated
β
∗
=
90
m beam optics. The Roman Pot detectors were ...inserted to 10
σ
distance from the LHC beam, which allowed the measurement of the range 0.04 GeV
2
; 4 GeV
2
in four-momentum transfer squared |
t
|. The efficient data acquisition allowed to collect about 10
9
elastic events to precisely measure the differential cross-section including the diffractive minimum (dip), the subsequent maximum (bump) and the large-|
t
| tail. The average nuclear slope has been found to be
B
=
(
20.40
±
0
.
002
stat
±
0
.
01
syst
)
GeV
-
2
in the |
t
|-range 0.04–0.2 GeV
2
. The dip position is
|
t
dip
|
=
(
0.47
±
0
.
004
stat
±
0
.
01
syst
)
GeV
2
. The differential cross section ratio at the bump vs. at the dip
R
=
1.77
±
0
.
01
stat
has been measured with high precision. The series of TOTEM elastic pp measurements show that the dip is a permanent feature of the pp differential cross-section at the TeV scale.
The TOTEM experiment at the CERN LHC has measured elastic proton–proton scattering at the centre-of-mass energy
s
=
8
TeV and four-momentum transfers squared, |
t
|, from
6
×
10
-
4
to 0.2 GeV
2
. ...Near the lower end of the
t
-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the
ρ
-parameter is found to be
0.12
±
0.03
. The results for the total hadronic cross-section are
σ
tot
=
(
102.9
±
2.3
)
mb and
(
103.0
±
2.3
)
mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.
We describe an analysis comparing the p (p) over bar elastic cross section as measured by the D0 Collaboration at a center-of-mass energy of 1.96 TeV to that in pp collisions as measured by the TOTEM ...Collaboration at 2.76, 7, 8, and 13 TeVusing a model-independent approach. The TOTEM cross sections, extrapolated to a center-of-mass energy of root s = 1.96 TeV, are compared with the D0 measurement in the region of the diffractive minimum and the second maximum of the pp cross section. The two data sets disagree at the 3.4s level and thus provide evidence for the t-channel exchange of a colorless, C-odd gluonic compound, also known as the odderon. We combine these results with a TOTEM analysis of the same C-odd exchange based on the total cross section and the ratio of the real to imaginary parts of the forward elastic strong interaction scattering amplitude in pp scattering for which the significance is between 3.4s and 4.6s. The combined significance is larger than 5 sigma and is interpreted as the first observation of the exchange of a colorless, C-odd gluonic compound.
PDF
