A
bstract
In this paper we revisit the idea of measuring the magnetic dipole moments of the charm baryons and, in particular, of
Λ
c
+
by studying the spin precession induced by the strong effective ...magnetic field inside the channels of a bent crystal. We present a detailed sensitivity study showing the feasibility of such an experiment at the LHC in the coming years.
In this paper, we discuss the theoretical framework and the experimental measurements of the magnetic moment of the charmed baryons. We first review the theoretical predictions of the
Λ
c
+
magnetic ...moment and show that the measurements of the magnetic moments of other charmed baryons, such as
Ξ
c
, allow to perform detailed spectroscopy studies. The magnetic moment of the charm quark can be determined using radiative charmonium decay, which can be compared to the
Λ
c
+
magnetic moment within theoretical models. The present results show a tension with majority of theoretical predictions. The magnetic moment of the charmed baryons could potentially be measured directly, using bent-crystal experiments at LHC. The possibility to measure precisely the magnetic moments of charmed baryons needs precise measurement of their polarisation and weak decay parameters. In this paper, we revisit the formalism of the angular analysis needed for these measurements and make a detailed evaluation of initial polarisation of deflected
Λ
c
baryons as a function of crystal orientation. We found a special orientation of the crystal that gives the opportunity to measure the
Λ
c
dimensionless electric dipole moment almost with the same precision as its
g
-factor, which is more than an order of magnitude more efficient than suggested before.
Mitigation of beam backgrounds via collimators is critical for the success of the Belle II experiment at the SuperKEKB electron-positron collider. We report on an improved simulation methodology, ...which includes a refined physical description of the collimators and beam pipe, our first implementation of collimator tip scattering, and in which the existing beam particle tracking software has been embedded into a new sequential tracking framework. These improvements resolve longstanding discrepancies between measured and predicted Belle II background levels, and significantly reduce the computing time required to optimize the collimation system in simulation. Finally, we report on collimator aperture scans, which confirm the accuracy of the simulation and suggest a new method for aligning the collimators.
The rate of inelastic nuclear interactions in a short bent silicon crystal was precisely measured for the first time using a 180 GeV/c positive hadron beam produced in the North Experimental Area of ...the CERN SPS. An angular asymmetry dependence on the crystal orientation in the vicinity of the planar channeling minimum has been observed. For the inspected crystal, this probability is about
∼
20
%
larger than in the amorphous case because of the atomic density increase along the particle trajectories in the angular range of volume reflection, whose dimension is determined by the crystal bending angle. Instead, for the opposite angular orientation with respect to the planar channeling, there is a smaller probability excess of
∼
4
%
.
The UA9 Experiment at CERN-SPS investigates channeling processes in bent silicon crystals with the aim to manipulate hadron beams. Monitoring and characterization of channeled beams in the high ...energy accelerators environment ideally requires in-vacuum and radiation hard detectors. For this purpose the Cherenkov detector for proton Flux Measurement (CpFM) was designed and developed. It is based on thin fused silica bars in the beam pipe vacuum which intercept charged particles and generate Cherenkov light. The first version of the CpFM is installed since 2015 in the crystal-assisted collimation setup of the UA9 experiment.
In this paper the procedures to make the detector operational and fully integrated in the UA9 setup are described. The most important standard operations of the detector are presented. They have been used to commission and characterize the detector, providing moreover the measurement of the integrated channeled beam profile and several functionality tests as the determination of the crystal bending angle. The calibration has been performed with Lead (Pb) and Xenon (Xe) beams and the results are applied to the flux measurement discussed here in detail.
Double-crystal measurements at the CERN SPS Scandale, W.; Arduini, G.; Cerutti, F. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
11/2021, Volume:
1015
Journal Article
Peer reviewed
Open access
The UA9 setup, installed in the Super Proton Synchrotron (SPS) at CERN, was exploited for a proof of principle of the double-crystal scenario, proposed to measure the electric and the magnetic ...moments of short-lived baryons in a high-energy hadron collider, such as the Large Hadron Collider (LHC). Linear and angular actuators were used to position the crystals and establish the required beam configuration. Timepix detectors and high-sensitivity Beam Loss Monitors were exploited to observe the deflected beams. Linear and angular scans allowed exploring the particle interactions with the two crystals and recording their efficiency. The measured values of the beam trajectories, profiles and of the channeling efficiency agree with the results of a Monte-Carlo simulation.
We present the experimental observation of the reduction of multiple scattering of high-energy positively charged particles during channeling in single crystals. According to our measurements the rms ...angle of multiple scattering in the plane orthogonal to the plane of the channeling is less than half that for non-channeled particles moving in the same crystal. In the experiment we use focusing bent single crystals. Such crystals have a variable thickness in the direction of beam propagation. This allows us to measure rms angles of scattering as a function of thickness for channeled and non-channeled particles. The behaviour with thickness of non-channeled particles is in agreement with expectations whereas the behaviour of channeled particles has unexpected features.
The UA9 setup for the double-crystal experiment in CERN-SPS Scandale, W.; Cerutti, F.; Esposito, L.S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
09/2020, Volume:
975
Journal Article
Peer reviewed
Experiments to measure the electric and the magnetic moments of short-lived baryons using an internal target and two bent crystals in the vicinity of one of the existing LHC detectors were recently ...proposed, in the frame of the Physics Beyond Colliders Working Group at CERN. Investigating fixed-target physics in the LHC with in-vacuum solid targets is an unprecedented challenge. As a preparatory step, the layout of the UA9 experiment, installed in the CERN SPS to explore beam manipulations assisted by bent crystals, has been modified to study the feasibility of the double-crystal scenario in a circular accelerator. Ideally, the first crystal should capture halo protons in channeling states directing them onto the internal target to produce rare baryons, whilst the second crystal, located just downstream of the target, should channel the baryons, rotate their polarization vector and deflect them towards the detector area. The upgraded UA9 layout is presented. Preliminary measurements providing an insight of the beam behavior are reported.
Characterisation of the fused silica surface quality with a β-source Natochii, A.; Burmistrov, L.; Addesa, F. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2018, Volume:
910
Journal Article
Peer reviewed
Open access
A method to characterise the quality of a fused silica surface using a β-source is presented. Two fused silica bars (5×10×400mm3) were fabricated for the Cherenkov detector for proton Flux ...Measurement installed at vacuum chamber of the Super Proton Synchrotron at CERN. The resolution of such device is defined by the collection efficiency of the Cherenkov light, which is produced by relativistic charged particles in the fused silica. Thus, the surface quality of the radiator should be as good as possible to avoid light losses. The method is based on the scanning of the radiator surface with a 90Sr radioactive source and measurements of the Cherenkov light rate, detected by a PMT attached to the quartz bars. The data have been compared with a Monte-Carlo simulation, providing an estimation of the radiator’s probability of the total internal reflection and inefficient area at the edges of the bars.
PDF
