•Two different types of piezoelectric actuators were developed for ITER diagnostics to operate in vacuum under high thermal and neutron fluxes.•Results of irradiation test of the piezoelectric ...actuators are analyzed.•Four types of the most common piezoelectric ceramic materials were tested.•Effects of radiation on piezoelectric ceramics are discussed as a challenge for piezoelectric actuators at ITER.•It is shown that depolarization of the piezoelectric ceramics related to irradiation and multiple baking in ITER can be reversed remotely.
As a part of ITER diagnostics design and development, ultrasonic and stick-slip piezoelectric motors and several types of piezoelectric ceramics were tested under severe neutron and gamma ray irradiation (∼ 1019 per cm2 at E > 0.1 MeV) in a pool-type fission reactor. The fission neutron and gamma ray spectra were corrected to comply with conditions expected under ITER divertor cassettes. Taking into account possible neutron-induced amorphization of crystal structure, four types of piezoelectric ceramics were pre-selected. To restore the electronic structure of piezoelectric ceramic damaged by gamma rays, recovery polarization (i.e. heating while applying reverse bias) was suggested. The motors and piezoceramic samples were assessed for performance before and after irradiation as well as after recovery polarization. Recovery polarization was performed at 330 °C as it is expected close to the divertor cassettes during baking. Two most promising types of piezoelectric ceramics survived multiple cycles of depolarization/polarization at both 330 °C and 200 °C as appropriate for baking ITER divertor and vacuum vessel, respectively. All the experiments and procedures are described in detail.
An important part of high-temperature plasma study is the determination of the electron temperature dynamics in the tokamak plasma. At spherical tokamaks, one can use Thomson scattering diagnostics ...as well as soft X-ray emission diagnostics (SXR). The capabilities of electron temperature measurement by the first diagnostics are limited by the repetition rate of laser pulses and their number in one tokamak discharge. Data of the second diagnostics are continuous in time and are determined by the time resolution of the detectors; however, obtaining the electron temperature using these data encounters a number of difficulties considered in this study. A method of combined processing of results of these diagnostics using machine learning algorithms was developed for overcoming these difficulties and applying the adVoprosy Atomnoi Nauki i Tekhniki, Seriya: Termoyadernyi Sintezages of both diagnostics. Training data include soft X-ray diagnostic data, hard X-ray diagnostic data, and CIII line emissivity diagnostic data. Thomson local scattering measurements were used as labels for supervised machine learning. The developed technique provides significant extension of the possibilities of determining the electron temperature at the Globus-M2 tokamak.
It is shown that the radial profile of the electron temperature in the Globus-M2 spherical tokamak is related to the radial profile of the electron density by a power law
. An analytical model of the ...density attractor, assuming the dependence of
on the specific poloidal volume
v
, previously tested on the TCV and JET tokamaks with a large aspect ratio, holds on the spherical tokamak, and the approximation of 162 experimental profiles has resulted in
. The proposed model makes it possible to calculate the spatial distribution
and
according to a known magnetic configuration.
The high-confinement mode in tokamaks (H-mode) is characterized by high pressure gradients at plasma edge, which results in the appearance of edge localized modes (ELMs). They are studied at the ...Globus-M2 spherical tokamak too, where edge localized modes are observed mainly in regimes with neutral beam injection. One of the ways for studying ELMs is the use of the Doppler backscattering (DBS) diagnostics installed at Globus-M2. It makes possible to estimate the amplitude of plasma density fluctuations and measure the radial electric field
E
r
. In this work, the effect of edge localized modes on the
E
r
field is studied in the radial range 0.4 < ρ < 1.1. It is shown that during ELMs the electric field increases in the entire measurement range. This indicates that ELMs affect the inner plasma regions as well. This is not consistent with the general ideas concerning the peripheral localization of ELMs, but is confirmed experimentally not only at Globus-M2. In addition, the results for the regime with ELMs are compared with those for the regime with limit cycle oscillations (LCOs) and it is shown that during LCOs such effect is not observed.
The thermal energy stored in plasma
, normalized internal plasma inductance
and current beta
are calculated via the free-boundary equilibrium PET code. The equilibrium reconstruction algorithm is ...iterative method of minimizing two parameters, the distance between the reconstructed plasma boundary and that simulated by the PET code, as well as the difference between the plasma diamagnetic flux from PET and the experimental one. The discharges from the Globus-M2 tokamak with a toroidal magnetic field up to 0.9 T and a plasma current of 0.3–0.4 MA in a mode with auxiliary heating by two atomic injectors are analyzed. The possibility of using approximate formulas for estimating
and
is considered. The measured diamagnetic flux is used to determine
and then to calculate
. The normalized internal plasma inductance
is additionally determined from the measured vertical magnetic field under the assumption that
.
Divertor Thomson Scattering on Globus-M2 Ermakov, N. V.; Zhiltsov, N. S.; Kurskiev, G. S. ...
Plasma physics reports,
12/2023, Volume:
49, Issue:
12
Journal Article
Peer reviewed
We present the first Thomson scattering (TS) measurements of electron temperature in the lower divertor of the Globus-M2 tokamak. The divertor TS diagnostics is designed for local measurements of the
...T
e
(
z
,
t
) in the range of 1–100 eV and
n
e
(
z
,
t
) in the range of
m
–3
. Parameters of the probing Nd:YAG laser are as follows 1064 nm/2 J/100 Hz/3 ns. The probing chord is launched vertically at
R
= 24 cm and covers areas of the inner leg, vicinity of separatrix and private flux region. Along probing chord of 110 mm, 9 spatial points were realized. Advanced filter polychromators were used to analyze Thomson scattering spectra.
Data on plasma disruption processes in the modernized Globus-M2 spherical tokamak are presented. Electron temperature and density profiles before the disruption, immediately after thermal quench and ...in the stage of plasma current quench are measured using the diagnostics of Thomson scattering of laser radiation. The dependence of the plasma current decay time during disruption on the pre-disruption current value is determined. The distribution of the toroidal current, which is induced during disruption, in the shell of the vessel is determined on the basis of magnetic measurements. Electromagnetic loads on the vessel are calculated.
diagnostics of the plasma electron component by the metho d of Thomson scattering
T
e
(
R
,
t
) of laser radiation makes it possible to reliably measure the spatial distributions of the electron ...temperature and density. One of the obstacles to the implementation of TS diagnostics in thermonuclear reactors is the distortion of the spectral characteristics of the optical system due to radiation-induced absorption and contamination of optical elements with erosion products of the first wall. As a consequence, the reliability of measurements by the TS method will decrease over time. The paper describes the method of multi-laser Thomson scattering, which will solve this problem. The results of the first experiments on the Globus-M2 tokamak are also presented.
The diagnostic complex of the Globus-M2 spherical tokamak (
R
= 36 cm,
a
= 24 cm), the only operating tokamak in Russia with a divertor plasma configuration, which operates in the range of ...subthermonuclear temperatures (
T
e
to 1.6 keV,
T
i
to 4.5 keV) and densities (
n
e
to 2 × 10
20
m
–3
), is described. The Globus‑M2 tokamak is the unique scientific facility, which is a part of the Federal Center for Collective Use of the Ioffe Institute, Russian Academy of Sciences “Materials Science and Diagnostics in Advanced Technologies.” This allows third parties to perform their research using it. The work contains a list of all diagnostics currently available on the tokamak. The description of the diagnostics is structured in such a way that the reader gets an idea of their capabilities for measuring plasma parameters with an emphasis on the limits and accuracy of the measured values, and also spatial and time resolution. At the same time, many technical details are omitted in order to save space; references are given to papers with a more detailed description of individual diagnostics.
Absorbed power of the neutral-injection beam in spherical tokamaks Globus-M/M2 is estimated numerically. Deceleration of fast particles is simulated by means of the NUBEAM code. The signal of ...analyzer of charge-exchange atoms is simulated by means of the FIDASIM code using the distribution function of fast ions calculated by means of the NUBEAM code. Comparison of calculated and experimental signals allowed determining the degree of influence of instabilities on confinement of fast particles along with absorbed beam power.
