Turning of high quality Al alloys with minimum costs
Reibenschuh, Marko ; Čuš, Franc, 1953- ; Župerl, Uroš
Turning is one of the most common used metal cutting procedures. To optimize such cutting process, some adaptations must be made. Implementing tool wear conditioning and the use of dry cutting can ...significantly lower the production cost. This research focuses on the cost effectiveness of using dry cutting in comparison with the use of cutting fluids and the use of different tool geometry. A series of tests were conducted and in the end the results are given.
It was not necessary to add the material to the shelf.
Bibliographic material was successfully added on shelf.
Adding bibliographical material on shelf was not successful.
Material is already on the shelf.
Permalink
URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year
Impact factor
Edition
Category
Classification
JCR
SNIP
JCR
SNIP
JCR
SNIP
JCR
SNIP
Select the library membership card:
DRS,
in which the journal is indexed
Database name
Field
Year
Links to authors' personal bibliographies
Links to information on researchers in the SICRIS system
Subject headings in COBISS General List of Subject Headings
Select pickup location
The material from the parent unit is free. If the material is delivered to the pickup location from another unit, the library may charge you for this service.
