Tests of FARICH prototype with precise photon position detection Barnyakov, A.Yu; Barnyakov, M.Yu; Basok, I.Yu ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2014, Letnik:
766
Journal Article
Recenzirano
In June 2012 a FARICH prototype from Philips Digital Photon Counting (PDPC) based on a photon camera with dimensions of 200200 mm has been tested at CERN. Remarkable particle separation has been ...achieved with a 4-layer aerogel sample: the pi /K separation at a 6 GeV/c momentum is 3.5 sigma , the mu / pi mu / pi separation is 5.3 sigma at 1 GeV/c. The analysis of the data has shown that the main contribution to the accuracy of the ring radius measurement comes from aerogel. The development of focusing aerogels is proceeding in two main directions: tuning of production technology of multilayer blocks and development of a new production method with continuous density (refractive index) gradient along the block depth. The beam test was carried out in December 2012-January 2013 at the electron beam test facility at the VEPP-4 M e super(+)e super(-) collider. The goal of this test was to measure different single layer and focusing aerogel samples, both multilayer and gradient. Aerogel samples were tested with a PDPC FARICH prototype. A part of DPC SPADs in each pixel was disabled to form an active area of 11 mm super(2). The collected data proved that gradient aerogel samples focus Cherenkov light.
PID system based on focusing aerogel RICH for the super C-τ factory Barnyakov, A.Yu; Barnyakov, M.Yu; Boborovnikov, V.S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
A high performance particle identification (PID) system is essential for the successful realization of the broad physics program at the future Super C-τ Factory in Novosibirsk. The main requirements ...for the PID system are as follows: good π/K-separation in the entire operational momentum range and good μ∕π-separation in the momentum range from 0.3 to 1.2 GeV/c. The RICH detector based on focusing aerogel radiator (FARICH) and position-sensitive photon detector meets all these requirements. The FARICH method is described, and the beam test results are presented. The FARICH system design outline for the Super C-τ Factory project is presented. Most promising photon detector options are considered.
Using the KEDR detector at the VEPP-4M e+e− collider, we have determined the values of R at thirteen points of the center-of-mass energy between 1.84 and 3.05 GeV. The achieved accuracy is about or ...better than 3.9% at most of the energy points with a systematic uncertainty less than 2.4%.
Using the KEDR detector at the VEPP-4M e+e− collider, we have measured the values of Ruds and R at seven points of the center-of-mass energy between 3.12 and 3.72 GeV. The total achieved accuracy is ...about or better than 3.3% at most of energy points with a systematic uncertainty of about 2.1%. At the moment it is the most accurate measurement of R(s) in this energy range.
—
The review presents the experiments performed with the KEDR detector at the
collider VEPP-4M in the energy range of
= 1.84–3.88 GeV. The cross section of
annihilation to hadrons was measured at 22 ...points of this range and the search for narrow resonances was conducted below 3.1 GeV. The masses of
and
mesons were measured with a record accuracy better than
; their partial and total widths were determined. Measurements of the tau lepton mass and masses of charged and neutral
mesons were performed with high precision. The measurements of the
parameters are discussed, and attention is drawn to some inconsistency of the procedure employed by the Particle Data Group for determining its parameters.
Prion and some other incurable human neurodegenerative diseases are associated with misfolding of specific proteins, followed by the formation of amyloids. Despite the widespread usage of the ...transmission electron and of the atomic force microscopy for studing such amyloids, many related methodological issues still have not been studied until now. Here, we consider one of the first amyloids found in Saccharomyces cerevisiae yeast, i.e. Sup35NMp, to study the adsorption of monomeric protein and its fibrils on the surface of mica, silica, gold and on formvar film. Comparison of linear characteristics of these units calculated by processing of images obtained by the atomic force, transmission and scanning electron microscopy was carried out. The minimal number of measurements of fibril diameters to obtain the values in a given confidence interval were determined. We investigated the film formed by monomeric protein on mica surface, which veiled some morphology features of fibrils. Besides, we revealed that parts of the Sup35NMp excluded from the fibril core can form a wide “coat”. The length of the protein forming the core of the fibrils was estimated.
C-Ag+−C based repetitive DNA sequence Popova, M A; Rolich, V I; Ramazanov, R R ...
Journal of physics. Conference series,
11/2020, Letnik:
1679, Številka:
2
Journal Article
Recenzirano
Odprti dostop
DNA is a convenient and well-studied tool for nanostructures fabrication. Metal-mediated hybridization of DNA strands opens up new possibilities for nanobiotechnology. In this work, we studied the ...possibility of long DNA formation from short ones by gluing them through the formation of C-Ag+−C complexes. Such long formations were investigated using static light scattering and atomic force microscopy. It was found that the duplexes can efficiently be linked in the presence of silver ions if the length of the cytosine sequence exceeds 6 nucleobases.
PDF
