Many areas of the Earth's crust deform by distributed extensional faulting and complex fault interactions are often observed. Geodetic data generally indicate a simpler picture of continuum ...deformation over decades but relating this behaviour to earthquake occurrence over centuries, given numerous potentially active faults, remains a global problem in hazard assessment. We address this challenge for an array of seismogenic faults in the central Italian Apennines, where crustal extension and devastating earthquakes occur in response to regional surface uplift. We constrain fault slip-rates since ~18 ka using variations in cosmogenic
Cl measured on bedrock scarps, mapped using LiDAR and ground penetrating radar, and compare these rates to those inferred from geodesy. The
Cl data reveal that individual faults typically accumulate meters of displacement relatively rapidly over several thousand years, separated by similar length time intervals when slip-rates are much lower, and activity shifts between faults across strike. Our rates agree with continuum deformation rates when averaged over long spatial or temporal scales (10
yr; 10
km) but over shorter timescales most of the deformation may be accommodated by <30% of the across-strike fault array. We attribute the shifts in activity to temporal variations in the mechanical work of faulting.
A new 1MV NEC pelletron AMS system at ANSTO is presented. The spectrometer comprises large radius magnets for actinide measurements. A novel feature of the system is fast switching between isotopes ...both at low and high energy sections allowing measurements of up to 8 isotopes within a single sequence. Technical details and layout of the spectrometer is presented. Performance data for 14C, 10Be, 26Al and actinides demonstrate the system is ready for routine AMS measurements.
Reworking of old sediment in the Murray-Darling implies alteration of environmental signals traveling from source to sink.
Understanding how sediment transport and storage will delay, attenuate, and ...even erase the erosional signal of tectonic and climatic forcings has bearing on our ability to read and interpret the geologic record effectively. Here, we estimate sediment transit times in Australia’s largest river system, the Murray-Darling basin, by measuring downstream changes in cosmogenic
26
Al/
10
Be/
14
C ratios in modern river sediment. Results show that the sediments have experienced multiple episodes of burial and reexposure, with cumulative lag times exceeding 1 Ma in the downstream reaches of the Murray and Darling rivers. Combined with low sediment supply rates and old sediment blanketing the landscape, we posit that sediment recycling in the Murray-Darling is an important and ongoing process that will substantially delay and alter signals of external environmental forcing transmitted from the sediment’s hinterland.
A single-stage accelerator mass spectrometer (SSAMS) is a good alternative to conventional spectrometers based on tandem electrostatic acceleration for radiocarbon measurement and permits ...experimentation with both negative and positive carbon ions. However, such 14C AMS of either polarity ions is limited by an interference. In the case of anion acceleration we have newly determined this to be summed 13C and 16O by improvising an additional Wien filter on our SSAMS deck. Also, 14C AMS might be improved by removing its dependency on negative-ionisation in a sputter ion source. This requires negative-ionisation of sample atoms elsewhere to suppress the 14N interference, which we accomplish by transmitting initially positive ions through a thin membrane. The ionisation dependence on ion-energy is found to be consistent with previous experimentation with vapours and thicker foils.
A first international
36
Cl interlaboratory comparison has been initiated. Evaluation of the final results of the eight participating accelerator mass spectrometry (AMS) laboratories on three ...synthetic AgCl samples with
36
Cl/Cl ratios at the 10
−11
, 10
−12
, and 10
−13
level shows no difference in the sense of simple statistical significance. However, more detailed statistical analyses demonstrate certain interlaboratory bias and underestimation of uncertainties by some laboratories. Following subsequent remeasurement and reanalysis of the data from some AMS facilities, the round-robin data indicate that
36
Cl/Cl data from two individual AMS laboratories can differ by up to 17%. Thus, the demand for further work on harmonising the
36
Cl-system on a worldwide scale and enlarging the improvement of measurements is obvious.
We report a comprehensive inventory of 10Be-based basin-wide denudation rates (n = 160) and 26Al/10Be ratios (n = 67) from 48 drainage basins along a 3000 km stretch of the East Australian passive ...continental margin. We provide data from both basins draining east of the continental divide (n = 37) and discharging into the Tasman and Coral Seas, and from basins draining to the west as part of the larger Murray-Darling and Lake Eyre river systems (n = 11). 10Be-derived denudation rates in mainstem samples from east-draining basins range between 7.7 ± 1.9 (± 1σ; Mary) and 54.6 ± 13.7 mm kyr−1 (North Johnstone). Denudation rates in tributary samples range between 3.0 ± 0.7 (Burdekin) and 70.2 ± 18.9 mm kyr−1 (Liverpool). For west-draining basins, denudation rates are overall lower and with a more restricted range of 4.8 ± 1.2 (Barcoo) to 15.4 ± 3.6 mm kyr−1 (Maranoa) in mainstem samples, and between 4.4 ± 1.0 (Murrumbidgee) and 38.5 ± 7.8 mm kyr−1 (Murray) in tributary samples. East Australian denudation rates (median = 14.5 mm kyr−1) are similar to those found in other postorogenic landscapes (global median = 12.4 mm kyr−1) and the medians of the top 10% denudation rates recorded here (46.5 mm kyr−1) and in other passive margin settings are also similar, despite differences in topography and precipitation. These median denudation rate values are close to the 95th percentile denudation rate for all tectonically passive basins (≈53 mm kyr−1) and are very similar to the global silicate weathering speed limit (≈58 mm kyr−1) calculated as the 95th percentile of global soil weathering rates. The above suggests that in post-orogenic terrain, the overall rates of topographic decay have a ‘speed limit’ that is imposed by the rate at which rock is converted to soil by chemical weathering. Denudation rates along the East Australian margin correlate with topographic metrics at both the mainstem basin scale and at the smaller tributary basin scale suggesting that topography exerts the main control on rates of landscape lowering in this setting. An important link between denudation rate and rainfall is also inferred: the highest mainstem 10Be denudation rates all occur in basins which also have the highest rainfall amounts and there is a strong correlation between the distance knickpoints have travelled upstream from the river mouth and basin area — a proxy for discharge and so to some extent also rainfall. On both sides of the divide, in all but a few of the samples, 26Al/10Be ratios are consistently lower than what is expected in a setting where sediments experience a simple and continuous exposure history. East of the continental divide, the lowest 26Al/10Be ratios are found in basins that also experience increased flood variability. We posit that there is a causal link between the hydrological variability that characterises the coastal rivers of eastern Australia and the observed non-steady state 26Al/10Be ratios: the periodic stripping of vertically accreted floodplains by large floods means that deeper and potentially older material is periodically incorporated into the sediment mix transported by the modern river.
•Young faults often undetected but potentially crucial for seismic hazard assessments.•First geomorphic evidence for the Southern San Cayetano fault (SSCF).•10Be dating of offset terraces records ...Holocene slip rate of 1.3+0.5−0.3 mm yr−1.•SSCF has major implications for seismic hazard in southern California.
We present surface evidence and displacement rates for a young, active, low-angle (∼20°) reverse thrust fault in close proximity to major population centers in southern California (USA), the Southern San Cayetano fault (SSCF). Active faulting along the northern flank of the Santa Clara River Valley displaces young landforms, such as late Quaternary river terraces and alluvial fans. Geomorphic strain markers are examined using field mapping, high-resolution lidar topographic data, 10Be surface exposure dating, and subsurface well data to provide evidence for a young, active SSCF along the northern flank of the Santa Clara River Valley. Displacement rates for the SSCF are calculated over 103–104 yr timescales with maximum slip rates for the central SSCF of 1.9+1.0−0.5 mm yr−1 between ∼19–7 ka and minimum slip rates of 1.3+0.5−0.3 mm yr−1 since ∼7 ka. Uplift rates for the central SSCF have not varied significantly over the last ∼58 ka, with a maximum value of 1.7+0.9−0.6 mm yr−1 for the interval ∼58–19 ka, and a minimum value of 1.2±0.3 mm yr−1 since ∼7 ka. The SSCF is interpreted as a young, active structure with onset of activity at some time after ∼58 ka. The geometry for the SSCF presented here, with a ∼20° north dip in the subsurface, is the first interpretation of the SSCF based on geological field data. Our new interpretation is significantly different from the previously proposed model-derived geometry, which dips more steeply at 45–60° and intersects the surface in the middle of the Santa Clara River Valley. We suggest that the SSCF may rupture in tandem with the main San Cayetano fault. Additionally, the SSCF could potentially act as a rupture pathway between the Ventura and San Cayetano faults in large-magnitude, multi-fault earthquakes in southern California. However, given structural complexities, including significant changes in dip and varying Holocene displacement rates along strike, further work is required to examine the possible mechanism, likelihood, and frequency of potential through-going ruptures between the Ventura and San Cayetano faults. Confirmation of the SSCF in a previously well-studied area, such as southern California, demonstrates that identification of young faults is critical for accurate seismic hazard assessment. We suggest that many young, active faults remain undetected in other structurally complex and tectonically active regions globally, and that significant seismic hazards can be overlooked.
Actinides AMS on the VEGA accelerator Hotchkis, M.A.C.; Child, D.P.; Froehlich, M.B. ...
Nuclear instruments & methods in physics research. Section B, Beam interactions with materials and atoms,
01/2019, Letnik:
438
Journal Article
Recenzirano
The VEGA 1MV accelerator at ANSTO is designed to be a highly versatile AMS instrument. In this paper we focus on describing those aspects of the system that are designed to optimise its performance ...for actinides isotopic analysis, in particular the implementation of fast isotope cycling and multiple isotope detection methods to enable isotope detection across a wide range of rates and currents. Charge state yields are reported in the energy range from 0.3 to 1.0 MeV with helium gas stripping, showing that the highest yield for the 3+ charge state occurs around 1 MeV and exceeds 40%. Accuracy and precision for uranium isotope ratios are shown to approach 1% over a wide range of concentrations and isotope ratios. The ionisation efficiency for plutonium is shown to exceed 3%, leading to overall detection efficiency over 1%. In the absence of background, this leads to sub-attogram detection limits for several Pu isotopes including 244Pu.
PDF
