Summary
This article presents a two‐layered framework to investigate the output synchronization problem in nonhomogeneous agent systems in the presence of periodic energy‐limited denial‐of‐service ...(DoS) attacks with an event‐triggered control strategy. Under the developed framework, the proposed controller for different agents is composed of a dynamic compensator and a regulator, where the dynamic compensator on the first layer can copy the dynamics of the leader node. DoS attacks with a periodic (partially known) attack strategy are based on a time sequence and interrupt the data exchange over a shard network consisting of the leader node and dynamic compensators in the first layer. An event‐triggered control protocol is proposed to reduce the update frequency of the controller, and it also ensures that the output of every dynamic compensator can track the output of the leader node without occurring “Zeno phenomenon.” Based on the output regulator theory, the regulator for every agent can guarantee that all nonhomogeneous agents can converge to the trajectory of every dynamic compensator in the bottom layer. Finally, a simulation example is demonstrated to verify the new design method developed.
For decreasing communication load and overcoming network constrains, such as the limited bandwidth and data loss in multi-agent networks, this paper integrates the two control strategies to ...investigate the bounded consensus problem of multi-agent systems (MASs) with external disturbance on the basis of an undirected graph, namely, the quantized control and the event-triggered control. In the existence of the external disturbance, two types of the high-gain control laws with the uniform quantized relative state measurements for the bounded consensus problem of MASs are first discussed, respectively. Then, in order to save the limited network resources in a multi-agent network, the event-triggered quantized communication protocols are designed based on the first case to obtain the bounded consensus in multi-agent systems. Moreover, it is shown that "Zeno behavior" phenomenon can be excluded under the two event-triggered quantized control mechanisms, and the boundness of the relative state error can be adjusted by selecting the different parameters. Finally, two examples are shown to validate the feasibility and efficiency of our theoretical analysis.
In this article, a distributed observer- and event-based practical consensus control for networked systems subject to adaptive nonlinear couplings is investigated. Considering that the node's state ...is not always measurable and the finite communication bandwidth exists in engineering systems, two distributed adaptive event-triggered control protocols subject to nonlinear couplings are proposed under observer-based dynamic output feedback. Then, distributed dynamic event-triggered control policies corresponding to two abovementioned adaptive controllers are proposed, respectively. The proposed nonlinear coupled event-triggered control schemes not only overcome continuous communication among nodes, but also relax the requirement of relying on global information for achieving a distributed practical consensus. Finally, the theoretical analysis is verified through a team of practical networked ground vehicles implemented through MATLAB/Simulink and robot operating systems environment.
Core–shell or striped heteroatomic lanthanide metal–organic framework hierarchical single crystals were obtained by liquid‐phase anisotropic epitaxial growth, maintaining identical periodic ...organization while simultaneously exhibiting spatially segregated structure. Different types of domain and orientation‐controlled multicolor photophysical models are presented, which show either visually distinguishable or visible/near infrared (NIR) emissive colors. This provides a new bottom‐up strategy toward the design of hierarchical molecular systems, offering high‐throughput and multiplexed luminescence color tunability and readability. The unique capability of combining spectroscopic coding with 3D (three‐dimensional) microscale spatial coding is established, providing potential applications in anti‐counterfeiting, color barcoding, and other types of integrated and miniaturized optoelectronic materials and devices.
A colorful turn: Core–shell (see picture, left) or striped (right) heteroatomic lanthanide metal–organic framework hierarchical single crystals are assembled from solution‐mediated epitaxial growth. By manipulation of the domain and orientation, tunable multicolor to white light emissions can be achieved. Multiplexed and high‐throughput capabilities are provided through the combination of spectroscopy with 3D‐space operation.
In this article, we address the distributed event-triggered leader-follower formation tracking control problem of general linear multiagent systems with a dynamic leader in sampled-data settings. A ...novel locally computable state-estimate-based event generator is established for each follower agent to regulate the interagent communication at each sampling instant. Then, we propose a distributed formation tracking protocol based on the triggered sampled information such that the formation tracking control problem can be formulated as a stability-analysis problem of the closed-loop formation error dynamics. The event generator and formation tracking controller gains can then be co-designed using the feasible linear matrix inequality conditions that are derived from Lyapunov-based stability-analysis methods that guarantee the ultimate boundedness of the closed-loop formation error dynamics. Finally, numerical simulations along with experiment implementations were conducted for a group of linearized unicycle-type mobile robots to demonstrate the effectiveness and advantages of the proposed method.
In this article, an adaptive nonsingular terminal sliding-mode (ANTSM) method is proposed for the motion tracking control of a bilateral teleoperation system. Efforts in this article seek to improve ...the position tracking performance of nonlinear systems subject to time-varying network delays, parametric uncertainties, and unknown external disturbances and frictions. Another issue addressed in this article is the common delay-induced phase shift of tracking profiles in many control methods, which is greatly reduced by introducing a novel mixed type of feedback signals in the ANTSM control design. Furthermore, the proposed adaptive control design with two online-estimated compensatory bounds removes the requirement of exact knowledge of network delays and disturbance bounds as a prior. In the master side, a force predictor is used to estimate the current environmental force for the reference signal generator. Therefore, the direct transmission of force signals is avoided. By comparing with the existing model-based and model-free methods, numerical simulation results with six-degree-of-freedom manipulators illustrate the merits of the developed robust and adaptive controllers. Experimental results with two Phantom Omni devices are also provided to demonstrate the effectiveness and the significant performance improvements of the proposed controllers.
Summary
This article addresses a novel multilateral teleoperation control scheme for single‐master multiple slave systems, which can be extended to n masters and n slaves without the loss of ...generality, where the master is a m degrees of freedom (DOF) manipulator arm and the slaves are m DOF mobile manipulators. The human operator operates the master robot to remotely control the slaves handling a target object. The master position signal is transmitted to the slave side to generate a desired object trajectory as well as the reference mobile base velocity. An adaptive robust controller is designed for the slaves to follow the desired trajectory from the master, which not only provides the excellent trajectory tracking but also optimize the internal force distribution of the object. A null space controller is designed for the mobile platforms of the mobile manipulators to achieve the velocity consensus while achieving the main task of object transportation. The novel control design uses the transmission of the environmental force feedback over the communication channel by the estimated parameters of the environment, which helps retain the stability of the overall system. The environmental force is predicted on the master side based on the estimated environmental parameters. The proposed control design can simultaneously achieve the objectives of stability, synchronization, and optimal internal force distribution. The simulation results of a single‐master and three slaves teleoperation system validate the efficacy of the proposed control algorithm.
Mechanotransduction couples mechanical stimulation with ion flux, which is critical for normal biological processes involved in neuronal cell development, pain sensation, and red blood cell volume ...regulation. Although they are key mechanotransducers, mechanosensitive ion channels in mammals have remained difficult to identify. In 2010, Coste and colleagues revealed a novel family of mechanically activated cation channels in eukaryotes, consisting of Piezo1 and Piezo2 channels. These have been proposed as the long-sought-after mechanosensitive cation channels in mammals. Piezo1 and Piezo2 exhibit a unique propeller-shaped architecture and have been implicated in mechanotransduction in various critical processes, including touch sensation, balance, and cardiovascular regulation. Furthermore, several mutations in Piezo channels have been shown to cause multiple hereditary human disorders, such as autosomal recessive congenital lymphatic dysplasia. Notably, mutations that cause dehydrated hereditary xerocytosis alter the rate of Piezo channel inactivation, indicating the critical role of their kinetics in normal physiology. Given the importance of Piezo channels in understanding the mechanotransduction process, this review focuses on their structural details, kinetic properties and potential function as mechanosensors. We also briefly review the hereditary diseases caused by mutations in Piezo genes, which is key for understanding the function of these proteins.
In this article, we focus on the experimental validation of the developed adaptive nonsingular terminal sliding mode (ANTSM) controller for a networked manipulator system. The proposed control ...approach is designed to deal with a combination of adverse and inexactly known conditions in practice, including parametric uncertainties, frictions, exogenous disturbances, and random time-varying network delays. Another issue addressed in this article is the tradeoff between achieving a smooth convergence and a high tracking accuracy in the physical implementation of the ANTSM controller. Hence, a novel time-varying gain in a form of logistic function is introduced to provide converging smoothness and meanwhile improve the tracking accuracy. Experimental results and empirical analysis are provided to demonstrate the effectiveness and performance improvement of the proposed controller with a time-varying gain.
PDF