Application Specific Integrated Circuits, ASICs, similar to those envisaged for the readout electronics of the central calorimeters of detectors for a future lepton collider have been exposed to ...high-energy electromagnetic showers. A salient feature of these calorimeters is that the readout electronics will be embedded into the calorimeter layers. In this article it is shown that interactions of shower particles in the volume of the readout electronics do not alter the noise pattern of the ASICs. No signal at or above the MIP level has been observed during the exposure. The upper limit at the 95% confidence level on the frequency of fake signals is smaller than
1
×
10
−
5
for a noise threshold of about 60% of a MIP. For ASICs with similar design to those which were tested, it can thus be largely excluded that the embedding of the electronics into the calorimeter layers compromises the performance of the calorimeters.
The DELPHI silicon strip microvertex detector with double sided readout Chabaud, V.; Collins, P.; Dijkstra, H. ...
Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment,
01/1996, Letnik:
368, Številka:
2
Journal Article, Conference Proceeding
Recenzirano
Odprti dostop
The silicon strip microvertex detector of the DELPHI experiment at the CERN LEP collider has been recently upgraded from two coordinates (RΦ only) to three coordinates reconstruction (RΦ and z). The ...new Microvertex detector consists of 125 952 readout channels, and uses novel techniques to obtain the third coordinate. These include the use of AC coupled double sided silicon detectors with strips orthogonal to each other on opposite sides of the detector wafer. The routing of signals from the z strips to the end of the detector modules is done with a second metal layer on the detector surface, thus keeping the material in the sensitive area to a minimum. Pairs of wafers are daisy chained, with the wafers within each pair flipped with respect to each other in order to minimize the load capacitance on the readout amplifiers. The design of the detector and its various components are described. Results on the performance of the new detector are presented, with special emphasis on alignment, intrinsic precision and impact parameter resolution. The new detector has been taking data since spring of 1994, performing up to design specifications.
The production of single- and multi-photon events has been studied in the reaction e(+) e(-) --> gamma(gamma) + invisible particles. The data collected with the DELPHI detector during the years 1999 ...and 2000 at centre-of-mass energies between 191 GeV and 209 GeV was combined with earlier data to search for phenomena beyond the Standard Model. The measured number of light neutrino families was consistent with three and the absence of an excess of events beyond that predicted by the Standard Model processes was used to set limits on new physics. Both model-independent searches and searches for new processes predicted by supersymmetric and extra-dimensional models have been made. Limits on new non-standard model interactions between neutrinos and electrons were also determined.
An analysis of the direct soft photon production rate as a function of the parent jet characteristics is presented, based on hadronic events collected by the DELPHI experiment at LEP1. The ...dependences of the photon rates on the jet kinematic characteristics (momentum, mass, etc.) and on the jet charged, neutral and total hadron multiplicities are reported. Up to a scale factor of about four, which characterizes the overall value of the soft photon excess, a similarity of the observed soft photon behavior to that of the inner hadronic bremsstrahlung predictions is found for the momentum, mass, and jet charged multiplicity dependences. However for the dependence of the soft photon rate on the jet neutral and total hadron multiplicities a prominent difference is found for the observed soft photon signal as compared to the expected bremsstrahlung from final state hadrons. The observed linear increase of the soft photon production rate with the jet total hadron multiplicity and its strong dependence on the jet neutral multiplicity suggest that the rate is proportional to the number of quark pairs produced in the fragmentation process, with the neutral pairs being more effectively radiating than the charged ones.
A measurement of the W boson mass and width has been performed by the DELPHI collaboration using the data collected during the full LEP2 programme (1996-2000). The data sample has an integrated ...luminosity of 660 pb(-1) and was collected over a range of centre-of-mass energies from 161 to 209 GeV. Results are obtained by applying the method of direct reconstruction of the mass of the W from its decay products in both the W+W- -> l (nu) over bar (l) and W+W- -> q (q) over bar'(q) over barq'channels. The W mass result for the combined data set is M-W = 80.336 +/- 0.055(Stat.) +/- 0.028(Syst.) +/- 0.025(FSI) +/- 0.009(LEP) GeV/c(2) , where FSI represents the uncertainty due to final state interaction effects in the q (q) over bar'(q) over barq' channel, and LEP represents that arising from the knowledge of the collision energy of the accelerator. The combined value for the W width is Gamma(W) = 2.404 +/- 0.140(Stat.) +/- 0.077(Syst.) +/- 0.065(FSI) GeV/c(2). These results supersede all values previously published by the DELPHI collaboration.
The hadronic part of the electron structure function F-2(e) has been measured for the first time, using e(+)e(-) data collected by the DELPHI experiment at LEP, at centre-of-mass energies of root s = ...91.2-209.5 GeV. The data analysis is simpler than that of the measurement of the photon structure function. The electron structure function F-2(e) data are compared to predictions of phenomenological models based on the photon structure function. It is shown that the contribution of large target photon virtualities is significant. The data presented can serve as a cross-check of the photon structure function F-2(gamma) analyses and help in refining existing parameterisations.
PDF
