•The impervious surface has the most contribution to storm runoff of the community.•The reduction capacity of single GI was limited, especially in bigger storms.•The integrated GIs has significantly ...reduction effects and can optimize the benefits.
The risk of urban flooding is increasing as a result of rapid urbanization. Green infrastructure (GI) is an emerging planning and design concept to mitigate urban flooding. A community scale simulation model was developed to quantify the effectiveness of GI on reducing the volume and peak flow of urban flooding. Five scenarios, namely expanding green space, converting to concave green space, constructing a runoff retention structure, converting to porous brick pavement, and combining previous four measures were considered for an urban community in Beijing. The outcomes showed that the model performed responsively to simulate the storm runoffs at varying recurrence intervals under these scenarios. Simulation results showed that, the impervious surfaces have the most contribution to the storm runoffs of the community. The reduction capacity for single GI facility was limited, especially in bigger storm events. The integrated GI configuration has effective reduction percentage, such as the total runoff reduction was ranged from 100% to 85.0% and the peak flow reduced 100–92.8%. This work can guide local planners and decision makers in their actions on green infrastructures in community scale.
The growing water stress both in terms of water scarcity and quality deterioration promotes the development of reclaimed water as a new water resource use. This paper reviewed wastewater reuse ...practices in China, and the opportunities and challenges of expanding reclaimed water use were analyzed. Rapid urbanization with the increasing of water demand and wastewater discharge provides an opportunity for wastewater reuse. The vast amount of wastewater discharge and low reclaimed water production mean that wastewater reuse still has a great potential in China. Many environmental and economic benefits and successful reclamation technologies also provide opportunities for wastewater reuse. In addition, the overall strategy in China is also encouraging for wastewater reuse. In the beginning stage of wastewater reclamation and reuse, there are many significant challenges to expand wastewater reuse in China including slow pace in adopting urban wastewater reuse programs, the establishment of integrated water resources management framework and guidelines for wastewater reuse programs, incoherent water quality requirements, the limited commercial development of reclaimed water and the strengthening of public awareness and cooperation among stakeholders.
An overview of reclaimed water reuse in China Yi, Lili; Jiao, Wentao; Chen, Xiaoning ...
Journal of environmental sciences (China),
01/2011, Letnik:
23, Številka:
10
Journal Article
Recenzirano
China is facing severe water problems including scarcity and pollution which are now becoming key factors restricting developments. Creating an alternative water resource and reducing effluent ...discharges, water reuse has been recognized as an integral part of water and wastewater management scheme in China. The government has launched nationwide efforts to optimize the benefits of utilizing reclaimed water. This article reviewed the water reuse activities in China, including: (1) application history and current status; (2) potentials of reclaimed water reuse; (3) laws, policies and regulations governing reclaimed water reuse; (4) risks associated with reclaimed water reuse; (5) issues in reclaimed water reuse. Reclaimed water in Beijing and Tianjin were given as examples. Suggestions for improving the efficiencies of reusing urban wastewater were advanced. Being the largest user of reclaimed wastewater in the world, China's experience can benefit the development of water reuse in other regions.
We studied the source, concentration, spatial distribution and health risk of 16 polycyclic aromatic hydrocarbons (PAHs) in urban soils of Beijing. The total mass concentration of 16 PAHs ranged from ...93 to 13 141 μg kg
−1 with a mean of 1228 μg kg
−1. The contour map of soil PAH concentrations showed that the industrial zone, the historical Hutong district and the university district of Beijing have significantly higher concentrations than those in remainder of the city. The results of sources identification suggested that the primary sources of PAHs were vehicle exhaust and coal combustion and the secondary source was the atmospheric deposition of long-range transported PAHs. The incremental lifetime cancer risks (ILCRs) of exposing to PAHs in the urban soils of Beijing for adult were 1.77 × 10
−6 and 2.48 × 10
−5, respectively under normal and extreme conditions. For child, they were 8.87 × 10
−7 and 6.72 × 10
−6, respectively under normal and extreme conditions.
► The primary sources of PAHs in Beijing soil were vehicle exhaust and coal combustion and the secondary source was the atmospheric deposition of long-range transported PAHs. ► Three areas of high PAH concentration soils are identified by Kriging interpolation included the industrial zone, the historical Hutong district and the university district. ► The estimated incremental lifetime cancer risks associated with exposing to soil PAHs in Beijing for both adults and children are acceptable.
A systematic investigation demonstrates the sources, distribution and health risk in Beijing urban soil using mathematical, statistical and geostatistical methods.
We report on a study of the design, phase formation, microstructure, mechanical behavior and strengthening mechanisms of a novel single-phase Co25Ni25Fe25Al7.5Cu17.5 (at.%) high-entropy alloy (HEA). ...In this investigation, a bulk nanocrystalline (nc) Co25Ni25Fe25Al7.5Cu17.5 HEA with the face-centered cubic (FCC) crystal structure was fabricated by mechanical alloying (MA) followed by consolidation via spark plasma sintering (SPS). The X-ray diffraction (XRD) and transmission electron microscopy (TEM) results revealed that a single FCC solid-solution phase with an average grain diameter of 24 nm was produced following MA. Following SPS, bulk samples exhibiting a bimodal microstructure with both nanoscale grains and ultra-fine grains (UFGs) and with an average grain diameter of 95 nm were obtained, possessing a single FCC solid-solution phase identical to that in the milled powders. The single-phase feature of the Co25Ni25Fe25Al7.5Cu17.5 HEA principally resulted from remarkably high mutual solubility in most binary atom-pairs of the constituent elements, which appears to correspond to a high entropy of mixing. Approximately 5 vol.% of nanoscale twins were observed in the bulk nc samples. The bulk nc Co25Ni25Fe25Al7.5Cu17.5 HEA exhibits a compressive yield strength of 1795 MPa with a hardness of 454 Hv, which is dramatically higher than the yield strength of most previously reported FCC structured HEAs (∼130–700 MPa). Compared to those of the bulk coarse-grained (CG) Co25Ni25Fe25Al7.5Cu17.5 HEA fabricated by arc-melting, the yield strength and Vickers hardness values of the bulk nc samples increased by 834.9% and 251.9%, respectively. Quantitative calculations of the respective contributions from each strengthening mechanism demonstrate that grain boundary strengthening and dislocation strengthening are principally responsible for the measured ultra-high strength of the bulk nc Co25Ni25Fe25Al7.5Cu17.5 HEA.
Display omitted
Accumulations of heavy metals in urban soils are highly spatial heterogeneity and affected by multiple factors including soil properties, land use and pattern, population and climatic conditions. We ...studied accumulation risks of Cd, Cu, Pb and Zn in unban soils of Beijing and their influencing based on the regression tree analysis and a GIS-based overlay model. Result shows that Zinc causes the most extensive soil pollution and Cu result in the most acute soil pollution. The soil's organic carbon content and CEC and population growth are the most significant factors affecting heavy metal accumulation. Other influence factors in land use pattern, urban landscape, and wind speed also contributed, but less pronounced. The soils in areas with higher degree of urbanization and surrounded by intense vehicular traffics have higher accumulation risk of Cd, Cu, Pb, and Zn.
•Zn accumulations were the most extensive and Cu accumulations were the most acute.•Accumulations of Cd, Cu, Pb and Zn in urban soils were caused by different sets of influence factors.•Soil's organic carbon content and CEC and population growth were the most significant factors.•Accumulation risks were highly related with urbanization level and human activities.
A combined approach of employing geographical information systems and regression tree analyses identify the potential risks of accumulation Cd, Cu, Pb, and Zn in urban soils according to soil properties, urban land use patterns, urban landscape, demographics, and microclimatic conditions.
Application of phosphate fertilizer can be a significant contributor of potentially hazardous trace elements such as arsenic, cadmium, and lead in croplands. These trace elements have the potential ...to accumulate in soils and be transferred through the food chain. We articulated the environmental risks of trace elements associated with long-term phosphate fertilizer applications by combining data from the literature and results from model simulations. Results illustrate that under normal cropping practice, the impact of phosphate fertilizers applications on trace element accumulation in receiving soils has been limited and localized. Their plant uptake varied greatly depending on the fertilizer application rates, soil and plant characteristics. This has led to a great deal of uncertainty in characterizing soil distribution coefficients, Kd, and plant uptake factors, PUF, two of the most used parameters in assessing the risks of accumulations. Therefore, the risks may be more appropriately assessed based on the probabilistic distributions of Kd and PUF.
Environmental risks of trace elements associated with long-term phosphate fertilizer applications were articulated by combining data from the literature and results from model simulations.
Soils provide the service of attenuating and detoxifying pollutants. Such ability, natural attenuation capacity (NAC), is one of the most important ecosystem services for urban soils. We improved the ...ecosystem-service performance index (EPX) model by integrating with entropy weight determination method to evaluate the NAC of residential soils in Beijing. Eleven parameters related to the soil process of pollutants fate and transport were selected and 115 residential soil samples were collected. The results showed that bulk density, microbial functional diversity and soil organic matter had high weights in the NAC evaluation. Urban socio-economic indicators of residential communities such as construction age, population density and property & management fee could be employed in kinetic fittings of NAC. It could be concluded urbanization had significant impacts on NAC in residential soils. The improved method revealed reasonable and practical results, and it could be served as a potential measure for application to other quantitative assessment.
Display omitted
•The ecosystem-service performance index (EPX) model was improved for soil service evaluation.•Soil natural attenuation capacity (NAC) was quantitatively evaluated by soil properties.•Bulk density, microbial functional diversity and soil organic matter play significant roles in the NAC evaluation.•Urbanization process had significant effects on NAC in residential soils.
A quantitative evaluation method for ecosystem services was elaborated and how urbanization process influenced the natural attenuation capacity was investigated.
Abstract
There has been renewed interests in the exploration of natural products (NPs) for drug discovery, and continuous investigations of the therapeutic claims and mechanisms of traditional and ...herbal medicines. In-silico methods have been employed for facilitating these studies. These studies and the optimization of in-silico algorithms for NP applications can be facilitated by the quantitative activity and species source data of the NPs. A number of databases collectively provide the structural and other information of ∼470 000 NPs, including qualitative activity information for many NPs, but only ∼4000 NPs are with the experimental activity values. There is a need for the activity and species source data of more NPs. We therefore developed a new database, NPASS (Natural Product Activity and Species Source) to complement other databases by providing the experimental activity values and species sources of 35 032 NPs from 25 041 species targeting 5863 targets (2946 proteins, 1352 microbial species and 1227 cell-lines). NPASS contains 446 552 quantitative activity records (e.g. IC50, Ki, EC50, GI50 or MIC mainly in units of nM) of 222 092 NP-target pairs and 288 002 NP-species pairs. NPASS, http://bidd2.nus.edu.sg/NPASS/, is freely accessible with its contents searchable by keywords, physicochemical property range, structural similarity, species and target search facilities.