Sr2+-substituted β-tricalcium phosphate (β-TCP) powders were synthesized using the mechano-chemical activation method with subsequent pressing and sintering to obtain ceramics. The concentration of ...Sr2+ in the samples was 0 (non-substituted TCP, as a reference), 3.33 (0.1SrTCP), and 16.67 (0.5SrTCP) mol.% with the expected Ca3(PO4)2, Ca2.9Sr0.1(PO4)2, and Ca2.5Sr0.5(PO4)2 formulas, respectively. The chemical compositions were confirmed by the energy-dispersive X-ray spectrometry (EDX) and the inductively coupled plasma optical emission spectroscopy (ICP-OES) methods. The study of the phase composition of the synthesized powders and ceramics by the powder X-ray diffraction (PXRD) method revealed that β-TCP is the main phase in all compounds except 0.1SrTCP, in which the apatite (Ap)-type phase was predominant. TCP and 0.5SrTCP ceramics were soaked in the standard saline solution for 21 days, and the phase analysis revealed the partial dissolution of the initial β-TCP phase with the formation of the Ap-type phase and changes in the microstructure of the ceramics. The Sr2+ ion release from the ceramic was measured by the ICP-OES. The human osteosarcoma MG-63 cell line was used for viability, adhesion, spreading, and cytocompatibility studies. The results show that the introduction of Sr2+ ions into the β-TCP improved cell adhesion, proliferation, and cytocompatibility of the prepared samples. The obtained results provide a base for the application of the Sr2+-substituted ceramics in model experiments in vivo.
A new series of Sr-based phosphates, Sr9−xMnxEu(PO4)7, were synthesized using the high-temperature solid-state method in air. It was found that these compounds have the same structure as ...strontiowhitlockite, which is a β-Ca3(PO4)2 (or β-TCP) structure. The concentration of Mn2+ ions required to form a pure strontiowhitlockite phase was determined. An unusual partial reduction of Eu3+ to Eu2+ in air was observed and confirmed by photoluminescence (PL) and electron spin resonance (ESR) spectra measurements. The PL spectra recorded under 370 nm excitation showed transitions of both 4f5d–4f Eu2+ and 4f–4f Eu3+. The total integral intensity of the PL spectra, monitored at 395 nm, decreased with increasing Mn2+ concentration due to quenching effect of Eu3+ by the Mn2+ levels. The temperature dependence of Eu2+ photoluminescence in a Sr9−xMnxEu(PO4)7 host was investigated. The conditions for the reduction of Eu3+ to Eu2+ in air were discussed.
An alternative approach for the currently used replacement therapy in dentistry is to apply materials that restore tooth tissue. Among them, composites, based on biopolymers with calcium phosphates, ...and cells can be applied. In the present work, a composite based on polyvinylpyrrolidone (PVP) and alginate (Alg) with carbonate hydroxyapatite (CHA) was prepared and characterized. The composite was investigated by X-ray diffraction, infrared spectroscopy, electron paramagnetic resonance (EPR) and scanning electron microscopy methods, and the microstructure, porosity, and swelling properties of the material were described. In vitro studies included the MTT test using mouse fibroblasts, and adhesion and survivability tests with human dental pulp stem cells (DPSC). The mineral component of the composite corresponded to CHA with an admixture of amorphous calcium phosphate. The presence of a bond between the polymer matrix and CHA particles was shown by EPR. The structure of the material was represented by micro- (30-190 μm) and nano-pores (average 8.71 ± 4.15 nm). The swelling measurements attested that CHA addition increased the polymer matrix hydrophilicity by 200%.
studies demonstrated the biocompatibility of PVP-Alg-CHA (95 ± 5% cell viability), and DPSC located inside the pores. It was concluded that the PVP-Alg-CHA porous composite is promising for dentistry applications.
The solid solution Ca9Zn1–xMnxNa(PO4)7 (0 ≤ x ≤ 1.0) was obtained by solid-phase reactions under the control of a reducing atmosphere. It was demonstrated that Mn2+-doped phosphors can be obtained ...using activated carbon in a closed chamber, which is a simple and robust method. The crystal structure of Ca9Zn1–xMnxNa(PO4)7 corresponds to the non-centrosymmetric β-Ca3(PO4)2 type (space group R3c), as confirmed by powder X-ray diffraction (PXRD) and optical second-harmonic generation methods. The luminescence spectra in visible area consist of a broad red emission peak centered at 650 nm under 406 nm of excitation. This band is attributed to the 4T1 → 6A1 electron transition of Mn2+ ions in the β-Ca3(PO4)2-type host. The absence of transitions corresponding to Mn4+ ions confirms the success of the reduction synthesis. The intensity of the Mn2+ emission band in Ca9Zn1–xMnxNa(PO4)7 rising linearly with increasing of x at 0.05 ≤ x ≤ 0.5. However, a negative deviation of the luminescence intensity was observed at x = 0.7. This trend is associated with the beginning of a concentration quenching. At higher x values, the intensity of luminescence continues to increase but at a slower rate. PXRD analysis of the samples with x = 0.2 and x = 0.5 showed that Mn2+ and Zn2+ ions replace calcium in the M5 (octahedral) sites in the β-Ca3(PO4)2 crystal structure. According to Rietveld refinement, Mn2+ and Zn2+ ions jointly occupy the M5 site, which remains the only one for all manganese atoms within the range of 0.05 ≤ x ≤ 0.5. The deviation of the mean interatomic distance (∆l) was calculated and the strongest bond length asymmetry, ∆l = 0.393 Å, corresponds to x = 1.0. The large average interatomic distances between Mn2+ ions in the neighboring M5 sites are responsible for the lack of concentration quenching of luminescence below x = 0.5.
Gd3+ and Sm3+ co-activation, the effect of cation substitutions and the creation of cation vacancies in the scheelite-type framework are investigated as factors influencing luminescence properties. ...AgxGd((2−x)/3)−0.3−ySmyEu3+0.3☐(1−2x)/3WO4 (x = 0.50, 0.286, 0.20; y = 0.01, 0.02, 0.03, 0.3) scheelite-type phases (AxGSyE) have been synthesized by a solid-state method. A powder X-ray diffraction study of AxGSyE (x = 0.286, 0.2; y = 0.01, 0.02, 0.03) shows that the crystal structures have an incommensurately modulated character similar to other cation-deficient scheelite-related phases. Luminescence properties have been evaluated under near-ultraviolet (n–UV) light. The photoluminescence excitation spectra of AxGSyE demonstrate the strongest absorption at 395 nm, which matches well with commercially available UV-emitting GaN-based LED chips. Gd3+ and Sm3+ co-activation leads to a notable decreasing intensity of the charge transfer band in comparison with Gd3+ single-doped phases. The main absorption is the 7F0 → 5L6 transition of Eu3+ at 395 nm and the 6H5/2 → 4F7/2 transition of Sm3+ at 405 nm. The photoluminescence emission spectra of all the samples indicate intense red emission due to the 5D0 → 7F2 transition of Eu3+. The intensity of the 5D0 → 7F2 emission increases from ~2 times (x = 0.2, y = 0.01 and x = 0.286, y = 0.02) to ~4 times (x = 0.5, y = 0.01) in the Gd3+ and Sm3+ co-doped samples. The integral emission intensity of Ag0.20Gd0.29Sm0.01Eu0.30WO4 in the red visible spectral range (the 5D0 → 7F2 transition) is higher by ~20% than that of the commercially used red phosphor of Gd2O2S:Eu3+. A thermal quenching study of the luminescence of the Eu3+ emission reveals the influence of the structure of compounds and the Sm3+ concentration on the temperature dependence and behavior of the synthesized crystals. Ag0.286Gd0.252Sm0.02Eu0.30WO4 and Ag0.20Gd0.29Sm0.01Eu0.30WO4, with the incommensurately modulated (3 + 1)D monoclinic structure, are very attractive as near-UV converting phosphors applied as red-emitting phosphors for LEDs.
In this study, a new series of phosphors, Ca9−xZnxGd0.9(PO4)7:0.1Eu3+ (x = 0.00–1.00, step dx 0.05), was synthesized, consisting of centro- and non-centrosymmetric phases with β-Ca3(PO4)2-type ...structure. Crystal structures with space groups R3c (0.00 ≤ x < 0.35) and R3¯c (x > 0.8) were determined using X-ray powder diffraction and the method of optical second harmonic generation. In the region 0.35 ≤ x ≤ 0.75, phases R3c and R3¯c were present simultaneously. Refinement of the Ca8ZnGd(PO4)7 crystal structure with the Rietveld method showed that 71% of Gd3+ ions are in M3 sites and 29% are in M1 sites. A luminescent spectroscopy study of Ca9−xZnxGd0.9(PO4)7:0.1Eu3+ indicated the energy transfer from the crystalline host to the Gd3+ and Eu3+ luminescent centers. The maximum Eu3+ luminescence intensity corresponds to the composition with x = 1.
TmMgB5O10 spontaneous crystals were synthesized via the flux-growth technique from a K2Mo3O10-based solvent. The crystal structure of the compound was solved and refined within the space group P21/n. ...The first principles calculations of the electronic structure reveal that TmMg-pentaborate with an ideal not defected crystal structure is an insulator with an indirect energy band gap of approximately 6.37 eV. Differential scanning calorimetry measurements and powder X-ray diffraction studies of heat-treated solids show that TmMgB5O10 is an incongruent melting compound. A characteristic band of the Tm3+ cation corresponding to the 3H6 → 1D2 transition is observed in the photoluminescence excitation spectra of TmMg-borate. The as-obtained crystals exhibit intense blue emission with the emission peaks centered at 455, 479, 667, and 753 nm. The most intensive band corresponds to the 1D2 → 3F4 transition. TmMgB5O10 solids demonstrate the thermal stability of photoluminescence.
A new series of Sr-based phosphates, Srsub.9−xMnxEu(POsub.4)sub.7, were synthesized using the high-temperature solid-state method in air. It was found that these compounds have the same structure as ...strontiowhitlockite, which is a β-Casub.3(POsub.4)sub.2 (or β-TCP) structure. The concentration of Mnsup.2+ ions required to form a pure strontiowhitlockite phase was determined. An unusual partial reduction of Eusup.3+ to Eusup.2+ in air was observed and confirmed by photoluminescence (PL) and electron spin resonance (ESR) spectra measurements. The PL spectra recorded under 370 nm excitation showed transitions of both 4f5d–4f Eusup.2+ and 4f–4f Eusup.3+. The total integral intensity of the PL spectra, monitored at 395 nm, decreased with increasing Mnsup.2+ concentration due to quenching effect of Eusup.3+ by the Mnsup.2+ levels. The temperature dependence of Eusup.2+ photoluminescence in a Srsub.9−xMnxEu(POsub.4)sub.7 host was investigated. The conditions for the reduction of Eusup.3+ to Eusup.2+ in air were discussed.
Our systematic explorations of the complex rare earth tellurite halide family have added several new Ln12(TeO3)12M6X24 (M = Cd, Mn, Co) representatives containing strongly deficient and disordered ...metal-halide layers based on transition metal cations. The degree of disorder increases sharply with decrease of M2+ radius and the size disagreements between the cationic Ln12(TeO3)12+12 and anionic M6Cl24−12 layers. From the crystal chemical viewpoint, this indicates that the families of both rare-earth selenites and tellurites can be further extended; one can expect formation of some more complex structure types, particularly among selenites. Analysis of the polytypism of compounds have been performed using the approach of OD (“order–disorder”) theory.
A composite material based on electrospinning printed polyhydroxybutyrate fibers impregnated with brushite cement containing Zn substitution was developed for bone implant applications. Powder X-ray ...Diffraction (PXRD), Fourier Transform Infrared Spectroscopy and Scanning Electron Microscopy were applied for materials characterization. Soaking the composite in Ringer's solution led to the transformation of brushite into apatite phase, accompanied by the morphology changes of the material. The bending strength of the composite material was measured to be 3.1 ± 0.5 MPa. NCTC mouse fibroblast cells were used to demonstrate by means of the MTT test that the developed material was not cytotoxic. The behavior of the human dental pulp stem cells on the surface of the composite material investigated by the direct contact method was similar to the control. It was found that the developed Zn containing composite material possessed antibacterial properties, as testified by microbiology investigations against bacteria strains of
and
. Thus, the developed composite material is promising for the treatment of damaged tissues with bacterial infection complications.
