Since its establishment in 2000, EARLINET (European Aerosol Research Lidar NETwork) has provided, through its database, quantitative aerosol properties, such as aerosol backscatter and aerosol ...extinction coefficients, the latter only for stations able to retrieve it independently (from Raman or high-spectral-resolution lidars). These coefficients are stored in terms of vertical profiles, and the EARLINET database also includes the details of the range resolution of the vertical profiles. In fact, the algorithms used in the lidar data analysis often alter the spectral content of the data, mainly acting as low-pass filters to reduce the high-frequency noise. Data filtering is described by the digital signal processing (DSP) theory as a convolution sum: each filtered signal output at a given range is the result of a linear combination of several signal input data samples (relative to different ranges from the lidar receiver), and this could be seen as a loss of range resolution of the output signal. Low-pass filtering always introduces distortions in the lidar profile shape. Thus, both the removal of high frequency, i.e., the removal of details up to a certain spatial extension, and the spatial distortion produce a reduction of the range resolution. This paper discusses the determination of the effective resolution (ERes) of the vertical profiles of aerosol properties retrieved from lidar data. Large attention has been dedicated to providing an assessment of the impact of low-pass filtering on the effective range resolution in the retrieval procedure.
Since 2000, regular lidar observations of the vertical aerosol distribution over Europe have been performed within the framework of EARLINET, the European Aerosol Research Lidar Network. A ...statistical analysis concerning the vertical distribution of the volume light extinction coefficients of particles derived from Raman lidar measurements at 10 EARLINET stations is presented here. The profiles were measured on a fixed schedule with up to two measurements per week; they typically covered the height range from 500 m to 6000 m above ground level (agl). The analysis is made for the planetary boundary layer (PBL) as well as for several fixed layers above ground. The results show typical values of the aerosol extinction coefficient and the aerosol optical depth (AOD) in different parts of Europe, with highest values in southeastern Europe and lowest values in the northwestern part. Annual cycles and cumulative frequency distributions are also presented. We found that higher aerosol optical depths in southern Europe compared to the northern part are mainly attributed to larger amounts of aerosol in higher altitudes. At 9 of the 10 sites the frequency distribution of the aerosol optical depth in the planetary boundary layer follows a lognormal distribution at the 95% significance level.
A measurement of the absolute fluorescence yield of the 337 nm nitrogen band, relevant to ultra-high energy cosmic ray (UHECR) detectors, is reported. Two independent calibrations of the fluorescence ...emission induced by a 120 GeV proton beam were employed: Cherenkov light from the beam particle and calibrated light from a nitrogen laser. The fluorescence yield in air at a pressure of 1013 hPa and temperature of 293 K was found to be Y 337 = 5.61 +/- 0.06 stat +/- 0.22 syst photons/MeV. When compared to the fluorescence yield currently used by UHECR experiments, this measurement improves the uncertainty by a factor of three, and has a significant impact on the determination of the energy scale of the cosmic ray spectrum.
One of the techniques adopted by the Pierre Auger Observatory to detect ultra high energy cosmic rays is based on air fluorescence detection. The knowledge of atmospheric properties during data ...acquisition is of primary importance. Together with other instruments, a system of four steerable elastic LIDARs, currently in operation, and a Raman LIDAR, that has taken data for about one year, provide measurements of the cloud coverage and of the aerosol optical transmission. This paper describes the hardware designs, the operational procedures, and the analyses performed on the collected data: aerosol optical properties and their vertical distributions.
We observed a long-range transport event of mineral dust from North Africa to South Europe during the Saharan Mineral Dust Experiment (SAMUM) 2006. Geometrical and optical properties of that dust ...plume were determined with Sun photometer of the Aerosol Robotic Network (AERONET) and Raman lidar near the North African source region, and with Sun photometers of AERONET and lidars of the European Aerosol Research Lidar Network (EARLINET) in the far field in Europe. Extinction-to-backscatter ratios of the dust plume over Morocco and Southern Europe do not differ. Ångström exponents increase with distance from Morocco. We simulated the transport, and geometrical and optical properties of the dust plume with a dust transport model. The model results and the experimental data show similar times regarding the appearance of the dust plume over each EARLINET site. Dust optical depth from the model agrees in most cases to particle optical depth measured with the Sun photometers. The vertical distribution of the mineral dust could be satisfactorily reproduced, if we use as benchmark the extinction profiles measured with lidar. In some cases we find differences. We assume that insufficient vertical resolution of the dust plume in the model calculations is one reason for these deviations.
EARLINET has been collecting high quality aerosol optical profiles over Europe since 2000. The comparison with automatic collected dataset of aerosol optical depth (AOD) from AERONET and MODIS ...demonstrates the effectiveness of EARLINET regular measurement schedule for climatological studies. The analysis of optical properties in the local boundary layer indicates that the general decrease of AOD observed by different platforms over Europe in the last decade could be due to the modification of aerosol properties (towards less absorbing and larger particles) in the lower troposphere.
In this paper we present the automated software tool ELDA (EARLINET Lidar Data Analyzer) for the retrieval of profiles of optical particle properties from lidar signals. This tool is one of the ...calculus modules of the EARLINET Single Calculus Chain (SCC) which allows for the analysis of the data of many different lidar systems of EARLINET in an automated, unsupervised way. ELDA delivers profiles of particle extinction coefficients from Raman signals as well as profiles of particle backscatter coefficients from combinations of Raman and elastic signals or from elastic signals only. Those analyses start from pre-processed signals which have already been corrected for background, range dependency and hardware specific effects. An expert group reviewed all algorithms and solutions for critical calculus subsystems which are used within EARLINET with respect to their applicability for automated retrievals. Those methods have been implemented in ELDA. Since the software was designed in a modular way, it is possible to add new or alternative methods in future. Most of the implemented algorithms are well known and well documented, but some methods have especially been developed for ELDA, e.g., automated vertical smoothing and temporal averaging or the handling of effective vertical resolution in the case of lidar ratio retrievals, or the merging of near-range and far-range products. The accuracy of the retrieved profiles was tested following the procedure of the EARLINET-ASOS algorithm inter-comparison exercise which is based on the analysis of synthetic signals. Mean deviations, mean relative deviations, and normalized root-mean-square deviations were calculated for all possible products and three height layers. In all cases, the deviations were clearly below the maximum allowed values according to the EARLINET quality requirements.
The ARCADE (Atmospheric Research for Climate and Astroparticle DEtection) project is a 3 years project funded by MIUR, that aims to study the aerosol attenuation of UV light in atmosphere using ...multiple instruments and techniques, as those commonly used in the cosmic rays community: elastic Lidar, Raman Lidar, side-scattering measurements using a distant laser source. All measurements will be acquired on the same air mass at the same time, in a semi-desertic site near Lamar, Colorado (U.S.). For each instrument, multiple analysis techniques will be tested: the target is a better comprehension of the systematics and limits of applicability of each method. The system is composed by a Lidar (elastic+Raman), fully designed and built within this project, and by the Atmospheric Monitoring Telescope (AMT), a telescope for the detection of UV light owned by the Colorado School of Mines. The setup of the two instruments is described in detail here. The project is presently in its third year: the Lidar system has been tested at the University of L'Aquila in February 2014 before shipment to the U.S., and the AMT has been recently reinstalled and tested in Lamar (May 2014). In June/July 2014 the ARCADE group will work out the final setup of the Lidar+AMT system in Lamar and will begin data acquisition.
The AMY experiment aims to measure the Microwave Bremsstrahlung Radiation (MBR) Twitter by air-showers secondary electrons accelerating in collisions with neutral molecules of the atmosphere. The ...measurements are performed at the Beam Test Facility (BTF) of Frascati INFN National Laboratories and the final purpose is to characterize the process to be used in a next generation detectors of ultra-high energy cosmic rays (up to 10 super(20)eV). We describe the experimental set-up and the first test measurement performed in November 2011.
PDF
