T2K is a long-baseline neutrino experiment that aims to investigate the CP violation in the neutrino sector. An upgrade of the ND280, which is one of the T2K near detectors, is in progress. The ...active target detector of the upgraded ND280 is a segmented highly granular plastic scintillation detector (SuperFGD) consisting of about two million scintillator cubes. About sixty thousand silicon photo-multipliers (SiPMs) coupled with wavelength shifting fibers are used for light readout. The fibers go through the scintillator cubes along the orthogonal three directions. We developed a novel system based on LEDs and notched light guide plates for in-situ calibration of the SuperFGD. The developed system can distribute LED light to SiPMs simultaneously with high uniformity and can be used for gain calibration and stability monitor of the signal readout. In addition, it can fit in the confined space of the SuperFGD due to its thin structure. In this paper, we report the design and the performance of the calibration system.
Test of the HAPD light sensor for the Belle II Aerogel RICH Yusa, Y.; Adachi, I.; Dolenec, R. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2017, Letnik:
876
Journal Article
Recenzirano
The Aerogel Ring-Imaging Cherenkov detector (ARICH) is being installed in the endcap region of Belle II spectrometer to identify particles from B meson decays by detecting the Cherenkov ring image ...from aerogel radiators. To detect single photons, high-sensitive photon detector which has wide effective area (∼70mm × 70mm), a Hybrid Avalanche Photo Detector (HAPD), has been developed in a collaboration with Hamamatsu K.K. The HAPD consists of hybrid structure of a vacuum tube and an avalanche photodiode (APD). It can be operated in 1.5T magnetic field of the spectrometer and withstands the radiation levels expected in the Belle II experiment. There are two steps of electric pulse amplification: acceleration of photo-electron in electric field in the vacuum tube part and electron avalanche in the APD part resulting in total gain of order 105. For the ARICH, we use 420 HAPDs in total. Before installing them, we performed quality assessment studies such as measurements of dark current, noise level, signal-to-noise ratio and two-dimensional scan with laser illumination. We also measured quantum efficiency of the photocathode. During the HAPD performance tests in the magnetic field, we observed very large signal pulses which cause long dead time of the readout electronics in some of the HAPDs. We have carried out a number of studies to understand this phenomenon, and have found a way to mitigate it and suppress the degradation of the ARICH performance. In this report, we will show a summary of the HAPD performance and quality assessment measurements including validation in the magnetic field for all of the HAPDs manufactured for the ARICH in the Belle II.
In the forward end-cap of the Belle II spectrometer, particle identification is provided by a proximity focusing RICH detector with an aerogel radiator (ARICH). The ARICH’s primary function is to ...effectively distinguish between pions and kaons in the momentum range of 0.5GeV/c to about 4GeV/c, as well as to contribute to identification of low-momentum leptons. Since its operation began, Belle II has collected over 420fb−1 of data. Based on this large data sample, studies of several effects that impact the performance of the ARICH detector were carried out. In this paper, we present a comparison of the observed Cherenkov ring image and detector particle identification performance in the measured data and detector simulation. Furthermore, we highlight recent efforts aimed at enhancing the ARICH’s performance by taking into account the effects of particle decay in flight and scattering in materials before the detector, as well as by refining the probability density function used for particle identification likelihood evaluation.
The Belle II experiment is a new generation B factory experiment at the SuperKEKB electron–positron collider. The main purpose of the experiment is to search for new physics with a large sample of B ...meson decays. The proximity-focusing Aerogel Ring-Imaging Cherenkov detector (ARICH) has been designed to identify kaons and pions in the forward end-cap of the Belle II spectrometer. Using aerogel as radiator with specialized photon sensors called HAPD, the K/π separation is expected to reach more than 4 σ in the momentum range from 0.5 GeV/c to 4.0 GeV/c. ARICH detector was constructed in summer 2017 and was installed in the Belle II spectrometer in the beam line of the SuperKEKB collider. The test of the ARICH detector is performed using both cosmic rays and the beam collisions during the accelerator commissioning. We observe Cherenkov rings in the ARICH detector associated with charged tracks detected by the tracking system. The reconstructed Cherenkov angle distribution has a clear and reasonable peak. The ARICH K∕π separation performance is evaluated using Bhabha events in beam runs; the separation power achieve the design value.
Aerogel RICH for the Belle II forward PID Nishida, S.; Adachi, I.; Hamada, N. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2014, Letnik:
766
Journal Article
Recenzirano
The Belle II spectrometer, a follow up of the very successful Belle experiment, is under construction at the SuperKEKB electron-positron collider at KEK in Japan. For the PID system in the forward ...region of the spectrometer, a proximity focusing ring-imaging Cherenkov (RICH) counter with an aerogel radiator is being developed. The counter will provide a 4 sigma separation of pions and kaons up to momenta of 4 GeV/c. For the position sensitive photon sensor, a 144-channel Hybrid Avalanche Photo-Detector (HAPD) has been developed with Hamamatsu Photonics K.K. The readout electronics is based on the custom developed ASIC. The design of the components is currently being finalized and part of their mass production have already started. Herein, we report the final design of the counter and a prototype test conducted with test beams at DESY.
Front-end electronics of the Belle II aerogel ring imaging detector Pestotnik, R.; Adachi, I.; Burmistrov, L. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
A proximity focusing RICH detector with an aerogel radiator is used for charged particle identification in the forward end-cap of the Belle II spectrometer. The detector, consisting of a 4 cm aerogel ...radiator, a 16 cm expansion volume and a photon detector with 420 Hybrid Avalanche Photo Detectors, is mounted in a very confined space between Central Drift Chamber and Electromagnetic Calorimeter, allowing only 5 cm of space for the readout electronics. In our solution, low power front-end read-out boards are mounted at the back side of each of the HAPD photosensors. These boards have each been tested individually before their installation onto the photosensors and into the spectrometer. Most important design issues and first experiences with the aforementioned front-end read-out boards are presented in this contribution.
We have developed a RICH counter as a new forward particle identification device for the Belle II experiment. As a Cherenkov radiator in this counter, a dual aerogel layer combination consisting of ...two refractive indicies, n=1.045 and 1.055, is employed. Mass production of these aerogel tiles has been done during 2013–2014 with new method improved by Chiba group. Optical qualities for them have been examined. The refractive indices of the obtained tiles were found to be in good agreement with our expectations, and the transparencies were high enough to be used for the RICH radiator.
At the Belle II experiment, Aerogel RICH is used as the particle identification device that covers the forward end-cap part of the Belle II detector. We develop the readout system of Hybrid Avalanche ...Photo Detectors that are used as the photon sensors of the Aerogel RICH. We present overview of the readout system, and report the status of the mass production toward the Belle II experiment.
Electron identification in Belle Hanagaki, K; Kakuno, H; Ikeda, H ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
06/2002, Letnik:
485, Številka:
3
Journal Article
Recenzirano
Odprti dostop
We report on electron identification methods and their performance in the Belle experiment at the KEK-B asymmetric B-Factory e
+e
− storage ring. Electrons are selected using a likelihood approach ...that takes information from the electromagnetic calorimeter, the central drift chamber, and the silica aerogel Cherenkov counters as input. We achieve an electron identification efficiency of (92.4±0.4)% with a π
± fake rate of (0.25±0.02)% for the momentum range between 1.0 and
3.0
GeV/c
in laboratory frame.
PDF