Display omitted
•The effect of blocking of particles displacement in MAE was observed from ZFC-FC.•M-H loops change the shape at solidification temperature of MAE.
The magnetization of a ...magnetoactive elastomer (MAE) with microparticles of soft magnetic carbonyl iron embedded in a highly elastic matrix has been studied. It is shown that at high temperatures its magnetization curve has the form of a specific hysteresis loop. This hysteresis is attributed to the influence of displacement of magnetized particles in the elastically soft elastomer matrix under the effect of magnetic forces, leading to the change of magnetic interaction between the particles. In this case, there is a maximum in the field dependence of the magnetic susceptibility, the occurrence of which has been associated with the competition between re-arrangement of particles, when they are displaced in a magnetic field, and saturation of particles’ magnetization. When the MAE is cooled below approximately 225 K, both the magnetic hysteresis and the maximum in the field dependence of the magnetic susceptibility disappear. When the MAE material is cooled below the solidification temperature of the elastomer matrix, the displacements of the magnetic particles during magnetization are blocked by the rigid matrix. The magnetization reversal of the MAE is reversible. This means that the shape of subsequent magnetization loops remains constant and the sample returns into the initial non-magnetized state after the magnetic field is turned off.
Magnetic field and temperature dependencies of the critical current density, J/sub c/(H/spl par/c, T) were measured by SQUID-magnetometry, ac magnetic susceptibility, and dc transport current ...techniques in the single-crystalline epitaxially-grown by off-axis dc magnetron sputtering YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// (YBCO) films with J/sub c/(H/spl par/c, 77 K) /spl ges/ 2 /spl middot/ 10/sup 6/ A/cm/sup 2/. The mechanism of vortex depinning from growth-induced linear defects, i.e., out-of-plane edge dislocations in low-angle tilt domain boundaries, is shown to describe quantitatively measured J/sub c/(H/spl par/c, T). The developed model takes into account a statistical distribution of the dislocation domain boundaries ordered in a network as well as the interdislocation spacing within boundaries. Actual structural features of YBCO film known from HREM data turn out to be extracted from J/sub c/(H/spl par/c, T)-curves by a fitting procedure within the proposed model.
It is shown that in external magnetic fields, a uniaxial magnetic anisotropy comes into being in a magnetoactive elastomer (MAE). The magnitude of the induced uniaxial anisotropy grows with the ...increasing external magnetic field. The filler particles are immobilized in the matrix if the MAE sample is cooled below 220 K, where the anisotropy can be read out. The cooling of the sample is considered as an alternative methodological approach to the experimental investigation of the magnetized state of MAEs. The appearance of magnetic anisotropy in MAE is associated with restructuring of the filler during magnetization, which leads to an additional effective field felt by the magnetization. It is found that the magnitude of the effective magnetic anisotropy constant of the MAE is approximately two times larger than its effective shear modulus in the absence of magnetic field. It is proposed that the experimentally observed large (about 40) ratio of the magnetic anisotropy constant of the filler to the shear modulus of the matrix deserves attention for the explanation of magnetic and magnetoelastic properties of MAEs. It may lead to additional rigidity of the elastic subsystem increasing the shear modulus of the composite material through the magnetomechanical coupling.
Magnetic properties of a magnetoactive elastomer (MAE) filled with {\mu}m-sized soft-magnetic iron particles have been experimentally studied in the temperature range between 150 K and 310 K. By ...changing the temperature, the elastic modulus of the elastomer matrix was modified and it was possible to obtain magnetization curves for an invariable arrangement of particles in the sample as well as in the case when the particles were able to change their position within the MAE under the influence of magnetic forces. At low (less than 220 K) temperatures, when the matrix becomes rigid, the magnetization of the MAE does not show a hysteresis behavior and it is characterized by a negative value of the Rayleigh constant. At room temperature, when the polymer matrix is compliant, a magnetic hysteresis exists and exhibits local maxima of the field dependence of the differential magnetic susceptibility. The appearance of these maxima is explained by the elastic resistance of the matrix to the displacement of particles under the action of magnetic forces.