Measurements of the Collins and Sivers asymmetries for charged pions and charged and neutral kaons produced in semi-inclusive deep-inelastic scattering of high energy muons off transversely polarised ...protons are presented. The results were obtained using all the available COMPASS proton data, which were taken in the years 2007 and 2010. The Collins asymmetries exhibit in the valence region a non-zero signal for pions and there are hints of non-zero signal also for kaons. The Sivers asymmetries are found to be positive for positive pions and kaons and compatible with zero otherwise.
A search for the exclusive production of the Zc±(3900) hadron by virtual photons has been performed in the channel Zc±(3900)→J/ψπ±. The data cover the range from 7 GeV to 19 GeV in the centre-of-mass ...energy of the photon–nucleon system. The full set of the COMPASS data set collected with a muon beam between 2002 and 2011 has been used. An upper limit for the ratio BR(Zc±(3900)→J/ψπ±)×σγN→Zc±(3900)N/σγN→J/ψN of 3.7×10−3 has been established at the confidence level of 90%.
In Fig. 5 on p. 311 of our Phys. Lett. B 740 (2015) 303 an adjustment by 180∘ is required for the phases with respect to the L=2,M=1 wave, of the following waves: L=1,3,5 with M=1, and L=2 with M=2. ...After this correction (Fig. 5 (corrected) below), the extracted partial waves describe the angular distribution of the η(′) in the Gottfried-Jackson (GJ) frame, using Eq. (4) with implicit Condon-Shortley phase convention. The other results of our paper are not affected. The right-handed GJ coordinate system was defined by the z-axis pointing in the direction of the beam in the η(′)π− center-of-mass system and the y-axis pointing in the direction of precoilGJ×pbeamGJ.
Micro Pattern Gas Detectors (MPGD) are the new frontier in gas trackers. Among this kind of devices, the Gas Electron Multiplier (GEM) chambers are widely used. The experimental signals acquired with ...the detector must obviously be reconstructed and analysed. In this contribution, a new offline software to perform reconstruction, alignment and analysis on the data collected with APV-25 and TIGER ASICs will be presented. GRAAL (Gem Reconstruction And Analysis Library) is able to measure the performance of a MPGD detector with a strip segmented anode (presently). The code is divided in three parts: reconstruction, where the hits are digitized and clusterized; tracking, where a procedure fits the points from the tracking system and uses that information to align the chamber with rotations and shifts; analysis, where the performance is evaluated (e.g. efficiency, spatial resolution,etc.). The user must set the geometry of the setup and then the program returns automatically the analysis results, taking care of different conditions of gas mixture, electric field, magnetic field, geometries, strip orientation, dead strip, misalignment and many others.
The experiment BESIII, running at the accelerator BEPCII in Beijing (P.R.C.), is going to be updated with the replacement of the Inner Drift Chamber with a Cylindrical triple-GEM Inner Tracker ...(CGEM-IT). In the R&D stage, two standalone C++ codes were implemented: GTS (Garfield-based Triple-GEM Simulator), for digitization and tuning of simulated data to the experimental ones, and GRAAL (GEM Reconstruction And Analysis Library), for the reconstruction and analysis of the experimental events collected in testbeams. GTS simulates the triple-GEM response to the particle passage, treating each stage separately: ionization, GEM properties, gas mixture, magnetic field and finally the induction of the signal on the anode. The necessary information was extracted by GARFIELD++ simulations, parametrized and used as input in GTS. This speeds up the simulation, since GTS performs only samplings instead of the full digitization chain. The simulated events were reconstructed with the same procedure used for experimental data and tuning factors were evaluated to obtain a satisfactory match. GRAAL is used in the analysis of the testbeam experimental data. It provides several levels of reconstruction: from the cluster formation, gathering contiguous firing strips, to the spatial position and the signal time reconstruciton. Two algorithms are used: the charge centroid and the micro-TPC, which exploit the charge deposition on the strips and the time information. Also a merging of the two algorithms is available to efficiently weight the two outcomes and obtain the best estimate of the spatial coordinate. Moreover, GRAAL performs tracking and alignment. Both codes are going to be made available also for other MPGDs simulation and reconstruction.
Triple-GEM detectors are a well known technology in high energy physics. In order to have a complete understanding of their behavior, in parallel with on beam testing, a Monte Carlo code has to be ...developed to simulate their response to the passage of particles. The software must take into account all the physical processes involved from the primary ionization up to the signal formation, e.g. the avalanche multiplication and the effect of the diffusion on the electrons. In the case of gas detectors, existing software such as Garfield already perform a very detailed simulation but are CPU time consuming. A description of a reliable but faster simulation is presented here: it uses a parametric description of the variables of interest obtained by suitable preliminary Garfield simulations and tuned to the test beam data. It can reproduce the real values of the charge measured by the strip, needed to reconstruct the position with the Charge Centroid method. In addition, particular attention was put to the simulation of the timing information, which permits to apply also the micro-Time Projection Chamber position reconstruction, for the first time on a triple-GEM. A comparison between simulation and experimental values of some sentinel variables in different conditions of magnetic field, high voltage settings and incident angle will be shown.
PDF
