Graphitizing anthracene-based cokes and non-graphitizing saccharose-based chars were processed at temperatures from 450°C to 2900°C at ambient pressure. This offers a whole set of samples that ...greatly differ in structure. Here, their structural evolution was monitored by combining XRD and visible (green) Raman spectroscopy as well as, for the first time, near-infrared Raman and synchrotron-based C-XANES spectroscopies. These different techniques provide complementary information especially regarding the spatial resolution they achieved. However, despite its importance, the quantitative comparison between the structural parameters extracted from these techniques is difficult. Based on a new signal deconvolution procedure to extract quantitative structural information from C-XANES data and the achievement of a new dataset on a complete series of graphitization, the reliability and the precision of the information which can be retrieved from each technique are discussed. C-XANES spectroscopy appears to provide reliable proxies for the extent of aromatic layers of graphitic compounds and an empirical calibration is proposed.
In this paper we comprehensively characterized particles in drinking water originating from a lake water source. We focused on particles smaller than a few hundred nm. Several analytical techniques ...were applied to obtain information on number concentration, size distribution, morphology and chemical composition of the particles. Morphological information was obtained by atomic force microscopy (AFM) analysis. Two types of particles, spherical aggregates up to a few tens of nm and elongated fibers were identified. Similar structures were also observed in transmission electron microscope (TEM) images. A size distribution of the particles was obtained by applying image analysis (IA) tools on the TEM images. IA results showed an exponential increase of the particle number concentration down to 40nm, which is the lower detection limit of our setup. The total number of particles down to 10nm and the average particle diameter were determined with the laser-induced breakdown detection (LIBD) method. The results were in good agreement with the TEM-IA data and showed a total number concentration of roughly 108particles/mL in the purified water. The carbon of the particles was investigated with scanning transmission X-ray microscopy (STXM), which revealed that most particles were organic matter; the C-1s spectra were typical for dissolved organic matter.
The methods were applied to characterize the particles from two different drinking waters treated with different methods (conventional vs. ultrafiltration (cut-off 100kDa)). The results showed that the particle number density following ultrafiltration was lower by a factor of 5–10, compared to conventional treatment. However, the average particle diameter in the finished water of both treatment trains was roughly the same.
Para‐sexiphenyl is found to assemble into azimuthally oriented crystalline nanoneedles on a TiO2 substrate (see Figure). The needles grow after prolonged exposure until they completely tile the ...surface with a film of uniform thickness. This novel morphology combined with the unique orientation of the molecules (all parallel to each other and the substrate and all with their molecular planes tilted with respect to the substrate) appears useful for both light‐emitting diodes and field‐effect transistor applications.
The interaction between glycine (NH2CH2COOH) layers and an ultrathin Al2O3 film grown epitaxially onto NiAl(110) was studied by temperature-programmed desorption, X-ray photoelectron spectroscopy, ...ultraviolet photoelectron spectroscopy, work function measurements, and near-edge X-ray absorption fine structure (NEXAFS) spectroscopy. At monolayer coverages at 110 K, there are two coexisting molecular forms: the anionic (NH2CH2COO-) and the zwitterionic form (NH3+CH2COO-) of glycine. As deduced from the photoemission data, the buildup of multilayers at 110 K leads to a condensed phase predominantly in the zwitterionic state. In contrast to the monolayer at 110 K, the monolayer formed at 300 K consists primarily of glycine molecules in the anionic state. The latter species is adsorbed with the oxygen atoms of the carboxylic group pointing toward the substrate. The polarization-dependent C K- and O K-edge NEXAFS spectra indicate that the glycinate species in the monolayer at 300 K is oriented nearly perpendicular to the surface, with the amino group pointing away from the surface.
Diesel and wood combustion are major sources of carbonaceous particles in the atmosphere. It is very hard to distinguish between the two sources by looking at soot particle morphology, but clear ...differences in the chemical structure of single particles are revealed by C(1s) NEXAFS (near edge X-ray absorption fine structure) microspectroscopy. Soot from diesel combustion has a dominant spectral signature at approximately 285 eV from aromatic pi-bonds, whereas soot from wood combustion has the strongest signature at approximately 287 eV from phenolic carbon bonds. To investigate if it is possible to use these signatures for source apportionment purposes, we collected atmospheric samples with either diesel or wood combustion as a dominant particle source. No spectra obtained from the atmospheric particles completely matched the emission spectra. Especially particles from the wood dominated location underwent large modifications; the phenolic spectral signature at approximately 287 eV is greatly suppressed and surpassed by the peak attributed to the aromatic carbon groups at approximately 285 eV. Comparison with spectra from diesel soot samples experimentally aged with ozone show that very fast modification of the carbon structure of soot particles occurs as soon as they enter the atmosphere. Source attribution of single soot particles with microspectroscopy is thus hardly possible, but NEXAFS remains a powerful tool to study aging effects.
The adsorption of naphthalene, vacuum deposited on a Ag(1
0
0) surface, was comprehensively investigated by means of low-energy electron diffraction (LEED), temperature-programmed thermal desorption ...(TPD) spectroscopy, X-ray photoelectron spectroscopy (XPS), and polarization-dependent near-edge X-ray absorption fine structure (NEXAFS) spectroscopy in the mono- and multilayer regime. A growth of long-range ordered monolayer at 140
K is observed with LEED. The polarization-dependent C 1s NEXAFS shows that the naphthalene molecules in the monolayer lie almost parallel to the Ag(1
0
0) surface. With increasing film thickness, the molecular orientation turns to upright position. Furthermore, NEXAFS measurements show that in the multilayer regime the molecular orientation depends on the substrate temperature during deposition.
Ultrathin glycine-ice films (nanolayers) have been prepared in ultrahigh vacuum by condensation of H(2)O and glycine at 110 K and 150 K on single crystalline Al(2)O(3) surfaces and have been ...investigated by temperature programed thermal desorption, x-ray photoelectron spectroscopy, and work function measurements. Various layer architectures have been considered, including glycine-on-ice, ice-on-glycine, and mixed glycine-ice nanolayers. Low coverages of adsorbed glycine molecules on amorphous ice surfaces suppress the amorphous-to-crystalline phase transition in the temperature range 140-160 K in near-surface regions and consequently lead to a lower desorption temperature of H(2)O molecules than from pure ice layers. Thicker glycine overlayers on ice provide a kinetic restriction to H(2)O desorption from the underlying ice layers until the glycine molecules become mobile and develop pathways for water desorption at higher temperature (>170 K). Ice overlayers do not wet glycine film surfaces, but the glycine molecules on ice are sufficiently immobile at 110 K, so that continuous glycine overlayers form. In mixed glycine-ice nanolayers the glycine phase displays hydrophobic behavior and a phase separation takes place, with the accumulation of glycine near the surfaces of the films.
PDF
