Synthetic textiles can shed numerous microfibers during conventional washing, but evaluating environmental consequences as well as source-control strategies requires understanding mass releases. ...Polyester apparel accounts for a large proportion of the polyester market, and synthetic jackets represent the broadest range in apparel construction, allowing for potential changes in manufacturing as a mitigation measure to reduce microfiber release during laundering. Here, detergent-free washing experiments were conducted and replicated in both front- and top-load conventional home machines for five new and mechanically aged jackets or sweaters: four from one name-brand clothing manufacturer (three majority polyester fleece, and one nylon shell with nonwoven polyester insulation) and one off-brand (100% polyester fleece). Wash water was filtered to recover two size fractions (>333 μm and between 20 and 333 μm); filters were then imaged, and microfiber masses were calculated. Across all treatments, the recovered microfiber mass per garment ranged from approximately 0 to 2 g, or exceeding 0.3% of the unwashed garment mass. Microfiber masses from top-load machines were approximately 7 times those from front-load machines; garments mechanically aged via a 24 h continuous wash had increased mass release under the same wash protocol as new garments. When published wastewater treatment plant influent characterization and microfiber removal studies are considered, washing synthetic jackets or sweaters as per this study would account for most microfibers entering the environment.
The global estimation of microplastic afloat in the ocean is only approximately 1% of annual global plastic inputs. This reflects fundamental knowledge gaps in the transformation, fragmentation, and ...fates of microplastics in the ocean. In order to better understand microplastic fragmentation we proceeded to a thorough physicochemical characterization of samples collected from the North Artlantic subtropical gyre during the sea campaign Expedition seventh Continent in May 2014. The results were confronted with a mathematical approach. The introduction of mass distribution in opposition to the size distribution commonly proposed in this area clarify the fragmentation pattern. The mathematical analysis of the mass distribution points out a lack of debris with mass lighter than 1 mg. Characterization by means of microscopy, microtomography, and infrared microscopy gives a better understanding of the behavior of microplastic at sea. Flat pieces of debris (2 to 5 mm in length) typically have one face that is more photodegraded (due to exposure to the sun) and the other with more biofilm, suggesting that they float in a preferred orientation. Smaller debris, with a cubic shape (below 2 mm), seems to roll at sea. All faces are evenly photodegraded and they are less colonized. The breakpoint in the mathematical model and the experimental observation around 2 mm leads to the conclusion that there is a discontinuity in the rate of fragmentation: we hypothesized that the smaller microplastics, the cubic ones mostly, are fragmented much faster than the parallelepipeds.
Remanufactured products that can substitute for new products are generally claimed to save energy. These claims are made from studies that look mainly at the differences in materials production and ...manufacturing. However, when the use phase is included, the situation can change radically. In this Article, 25 case studies for eight different product categories were studied, including: (1) furniture, (2) clothing, (3) computers, (4) electric motors, (5) tires, (6) appliances, (7) engines, and (8) toner cartridges. For most of these products, the use phase energy dominates that for materials production and manufacturing combined. As a result, small changes in use phase efficiency can overwhelm the claimed savings from materials production and manufacturing. These use phase energy changes are primarily due to efficiency improvements in new products, and efficiency degradation in remanufactured products. For those products with no, or an unchanging, use phase energy requirement, remanufacturing can save energy. For the 25 cases, we found that 8 cases clearly saved energy, 6 did not, and 11 were too close to call. In some cases, we could examine how the energy savings potential of remanufacturing has changed over time. Specifically, during times of significant improvements in energy efficiency, remanufacturing would often not save energy. A general design trend seems to be to add power to a previously unpowered product, and then to improve on the energy efficiency of the product over time. These trends tend to undermine the energy savings potential of remanufacturing.
Unsafe drinking water and household air pollution (HAP) are major causes of morbidity and mortality among children under 5 in low and middle-income countries. Household water filters and ...higher-efficiency biomass-burning cookstoves have been widely promoted to improve water quality and reduce fuel use, but there is limited evidence of their health effects when delivered programmatically at scale.
In a large-scale program in Western Province, Rwanda, water filters and portable biomass-burning natural draft rocket-style cookstoves were distributed between September and December 2014 and promoted to over 101,000 households in the poorest economic quartile in 72 (of 96) randomly selected sectors in Western Province. To assess the effects of the intervention, between August and December, 2014, we enrolled 1,582 households that included a child under 4 years from 174 randomly selected village-sized clusters, half from intervention sectors and half from nonintervention sectors. At baseline, 76% of households relied primarily on an improved source for drinking water (piped, borehole, protected spring/well, or rainwater) and over 99% cooked primarily on traditional biomass-burning stoves. We conducted follow-up at 3 time-points between February 2015 and March 2016 to assess reported diarrhea and acute respiratory infections (ARIs) among children <5 years in the preceding 7 days (primary outcomes) and patterns of intervention use, drinking water quality, and air quality. The intervention reduced the prevalence of reported child diarrhea by 29% (prevalence ratio PR 0.71, 95% confidence interval CI 0.59-0.87, p = 0.001) and reported child ARI by 25% (PR 0.75, 95% CI 0.60-0.93, p = 0.009). Overall, more than 62% of households were observed to have water in their filters at follow-up, while 65% reported using the intervention stove every day, and 55% reported using it primarily outdoors. Use of both the intervention filter and intervention stove decreased throughout follow-up, while reported traditional stove use increased. The intervention reduced the prevalence of households with detectable fecal contamination in drinking water samples by 38% (PR 0.62, 95% CI 0.57-0.68, p < 0.0001) but had no significant impact on 48-hour personal exposure to log-transformed fine particulate matter (PM2.5) concentrations among cooks (β = -0.089, p = 0.486) or children (β = -0.228, p = 0.127). The main limitations of this trial include the unblinded nature of the intervention, limited PM2.5 exposure measurement, and a reliance on reported intervention use and reported health outcomes.
Our findings indicate that the intervention improved household drinking water quality and reduced caregiver-reported diarrhea among children <5 years. It also reduced caregiver-reported ARI despite no evidence of improved air quality. Further research is necessary to ascertain longer-term intervention use and benefits and to explore the potential synergistic effects between diarrhea and ARI.
Clinical Trials.gov NCT02239250.
The bacteria that colonize humans and our built environments have the potential to influence our health. Microbial communities associated with seven families and their homes over 6 weeks were ...assessed, including three families that moved their home. Microbial communities differed substantially among homes, and the home microbiome was largely sourced from humans. The microbiota in each home were identifiable by family. Network analysis identified humans as the primary bacterial vector, and a Bayesian method significantly matched individuals to their dwellings. Draft genomes of potential human pathogens observed on a kitchen counter could be matched to the hands of occupants. After a house move, the microbial community in the new house rapidly converged on the microbial community of the occupants’ former house, suggesting rapid colonization by the family’s microbiota.
Newly defined categories of WEEE have increased the types of China's regulated WEEE from 5 to 14. Identification of the amounts and valuable-resource components of the "new" WEEE generated is ...critical to solving the e-waste problem, for both governmental policy decisions and recycling enterprise expansions. This study first estimates and predicts China's new WEEE generation for the period of 2010-2030 using material flow analysis and the lifespan model of the Weibull distribution, then determines the amounts of valuable resources (e.g., base materials, precious metals, and rare-earth minerals) encased annually in WEEE, and their dynamic transfer from in-use stock to waste. Main findings include the following: (i) China will generate 15.5 and 28.4 million tons WEEE in 2020 and 2030, respectively, and has already overtaken the U.S. to become the world's leading producer of e-waste; (ii) among all the types of WEEE, air conditioners, desktop personal computers, refrigerators, and washing machines contribute over 70% of total WEEE by weight. The two categories of EEE-electronic devices and electrical appliances-each contribute about half of total WEEE by weight; (iii) more and more valuable resources have been transferred from in-use products to WEEE, significantly enhancing the recycling potential of WEEE from an economic perspective; and (iv) WEEE recycling potential has been evolving from ∼16 (10-22) billion US$ in 2010, to an anticipated ∼42 (26-58) billion US$ in 2020 and ∼73.4 (44.5-103.4) billion US$ by 2030. All the obtained results can improve the knowledge base for closing the loop of WEEE recycling, and contribute to governmental policy making and the recycling industry's business development.
Indoor biomass burning is a major contributor to the emission of PAHs (polycyclic aromatic hydrocarbons) in China. To date, estimates of PAH emissions from the burning of biomass have involved ...considerable uncertainty, mostly from the lack of real-world measurements of emission factors. In this study, we conducted a comprehensive evaluation on PAH emissions from biomass burning in real-world cooking stoves in three Chinese provinces. PAH emission factors, in both particle- and gas-phase, from 11 fuel-stove combinations were measured and the provincial emissions were estimated based on the measured emission factors and fuel consumption. The measured PAH28 emission factors (including 16 US EPA priority PAHs and 12 non-priority PAHs) ranged from 42 mg/kg to 370 mg/kg, with an order of magnitude difference, which was mostly affected by fuel type. The emission factors measured in this study were generally higher than those reported in laboratory studies and were comparable with field studies. The gas-particle distribution indicated that the absorption of PAHs by organic carbon in particulate matter (PM) was the dominant sorption mechanism in gas-particle distribution. The composition profile was different from previous studies, especially for non-priority PAHs, which are highly toxic and should be given more attention. Following the disparities in composition profiles, our study suggests that source apportionment based on single- or multi-diagnostic ratios may lead to large bias and uncertainties. It appears that the toxicity potential of PAHs in northern China emitted from combustion of crop residues is greater than that in southern China where PAHs are mainly emitted from wood combustion.
Display omitted
•The real-world measurements of EFs of PAHs from biomass burning in real-world cooking stoves were conducted in rural China.•The EFs in this study showed larger contributions from non-priority PAHs, suggesting greater potential toxicity.•The per-capita emissions were estimated based on the real-world EFs, and greater toxicity was found in northern China.
Summary: The real-world measurements of PAH emission factors were found to be larger than those reported by laboratory studies. Based on the EFs, the newly estimated PAH emissions in northern China revealed greater toxicity.
Natural gas stoves in >40 million U.S. residences release methane (CH
)─a potent greenhouse gas─through post-meter leaks and incomplete combustion. We quantified methane released in 53 homes during ...all phases of stove use: steady-state-off (appliance not in use), steady-state-on (during combustion), and transitory periods of ignition and extinguishment. We estimated that natural gas stoves emit 0.8-1.3% of the gas they use as unburned methane and that total U.S. stove emissions are 28.1 95% confidence interval: 18.5, 41.2 Gg CH
year
. More than three-quarters of methane emissions we measured originated during steady-state-off. Using a 20-year timeframe for methane, annual methane emissions from all gas stoves in U.S. homes have a climate impact comparable to the annual carbon dioxide emissions of 500 000 cars. In addition to methane emissions, co-emitted health-damaging air pollutants such as nitrogen oxides (NO
) are released into home air and can trigger respiratory diseases. In 32 homes, we measured NO
(NO and NO
) emissions and found them to be linearly related to the amount of natural gas burned (
= 0.76;
≪ 0.01). Emissions averaged 21.7 20.5, 22.9 ng NO
J
, comprised of 7.8 7.1, 8.4 ng NO
J
and 14.0 12.8, 15.1 ng NO J
. Our data suggest that families who don't use their range hoods or who have poor ventilation can surpass the 1-h national standard of NO
(100 ppb) within a few minutes of stove usage, particularly in smaller kitchens.
In the absence of particulate matter (PM) control devices, residential coal combustion contributes significantly to ambient PM pollution. Characterizing PM emissions from residential coal combustion ...with high time resolution is beneficial for developing control policies and evaluating the environmental impact of PM. This study reports the evolution of submicrometer organic aerosols (OA) during a complete residential coal combustion process, that is, from fire start to fire extinction. Three commonly used coal types (bituminous, anthracite, and semicoke coals) were evaluated in a typical residential stove in China. For all three types of coal, the OA emission exhibited distinct characteristics in the four stages, that is, ignition, fierce combustion, relatively stable combustion, and ember combustion. OA emissions during the ignition stage accounted for 58.2-85.4% of the total OA emission of a complete combustion process. The OA concentration decreased rapidly during the fierce combustion stage and remained low during the relatively stable combustion stage. During these two stages, a significant ion peak of m/z 73 from organic acids were observed. The degree of oxidation of the OA increased from the first stage to the last stage. Implications for ambient OA source-apportionment and residential PM emission characterization and control are discussed.