As CMOS technology scales down, digital supply voltage and digital power consumption goes down. However, the supply voltage and power consumption of the RF front-end and analog sections do not scale in a similar fashion. In fact, in many state-of-the-art communication transceivers, RF and analog sections can consume more energy compared to the digital part. In this paper, first, a system level energy model for all the components in the RF and analog front-end is presented. Next, the RF and analog front-end energy consumption and communication quality of three representative systems are analyzed: a single user point-to-point wireless data communication system, a multi-user code division multiple access (CDMA)-based system and a receive-only video distribution system. For the single user system, the effect of occupied signal bandwidth, peak-to-average ratio (PAR), symbol rate, constellation size, and pulse-shaping filter roll-off factor is analyzed; for the CDMA-based multi-user system, the effect of the number of users in the cell and multiple access interference (MAI) along with the PAR and filter roll-off factor is studied; for the receive-only system, the effect of 1/f noise for direct-conversion receiver and the effect of IF frequency for low-IF architecture on the RF front-end power consumption is analyzed. For a given communication quality specification, it is shown that the energy consumption of a wireless communication front-end can be scaled down by adjusting parameters such as the pulse shaping filter roll-off factor, constellation size, symbol rate, number of users in the cell, and signal center frequency