E-viri
Recenzirano
-
Wu, Weitong; Li, Jianping; Chen, Chi; Yang, Bisheng; Zou, Xianghong; Yang, Yandi; Xu, Yuhang; Zhong, Ruofei; Chen, Ruibo
ISPRS journal of photogrammetry and remote sensing, 20/May , Letnik: 199Journal Article
As an effective complement to common laser scanning systems, the portable laser scanning system can acquire point clouds flexibly and quickly. Calibration between Light detection and ranging (LiDAR) sensors and inertial measurement units (IMU) is the prerequisite for laser scanning systems to obtain high-quality point clouds. Related methods have been proposed in the last two decades, where the global navigation satellite system (GNSS) or high-precision calibration fields are commonly used. However, the extrinsic self-calibration of LiDAR-IMU is challenging, due to the large distortion in single-frame point cloud caused by rapid motion and the position errors of IMU integration which drift quickly. At the same time, the highly dynamic motion patterns of portable devices and the changes in the scanned scene structure are not well considered in existing LiDAR odometry methods. To take better advantage of the characteristics of non-repetitive scanning LiDAR sensor, this paper proposes AFLI-Calib, which utilizes adaptive frame length LiDAR odometry to perform the extrinsic self-calibration of LiDAR-IMU. Unlike LiDAR odometry methods with a fixed frame length, the LiDAR frame length is dynamically adjusted according to the motion state of sensors and the matching stability of scenes. The single-frame point cloud is registered to the map through a linear-based continuous-time model, eliminating the motion distortion correction in advance. For further optimization of trajectory and extrinsic parameters, IMU raw measurements and LiDAR observations are involved in the multi-constraint optimization, through tightly-coupled IMU pre-integration constraints, LiDAR point-to-plane constraints, and prior constraints. The method is fully validated using self-collected calibration data of indoor and outdoor scenes and different motion modes. Experiments show that on the test data, the translation parameter accuracy of the method is 0.041 m, which is 56.3% higher than the state-of-the-art method. The standard deviation is significantly reduced, with translation deviation (0.017 m, 0.024 m, 0.022 m) and rotation deviation (0.17°, 0.25°, 0.15°), which verifies the robustness of our method. The average RMSE of distances to the reference point cloud acquired by the terrestrial laser scanning system (TLS) is 0.042 m, showing a high accuracy calibration result. Comparative experiments with the fixed frame length LiDAR odometry method and classical “correction-then-registration” motion distortion model further verify the superiority and effectiveness of the proposed adaptive frame length LiDAR odometry.
Avtor
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.